Neutron stars: Classification and evolution

The general aproach is considered which describs the evolution of neutron stars in terms of their interaction with surrounding matter. All possible states of neutron stars are classified from this point of view. Classification and evolution of binaries contaning neutron stars are also considered.     

Studies of the geocenter motion using 16-years DORIS data

An accuracy of geocenter motion estimation is strongly dependent on the geodetic network size and stations distribution over the Earth’s surface. From this point of view DORIS system has an advantage, as its ground network of beacons consists of more than 50 sites, equally distributed over the Earth’s surface. Aiming to study variations of the geocenter movements, the results of DORIS data analysis for the time span 1993.0–2009.0 (inawd06.snx series), performed at the Analysis Centre of the Institute of astronomy of the Russian Academy of Sciences, have been used. DORIS data processing was made with GIPSY/OASIS II software, developed by Jet Propulsion Laboratory and modified for DORIS data processing by Institute Géographique National. Standard deviations of stations coordinates are estimated at the level 0.5–4.0 cm (internal consistency), depending on the number of satellites used in the solution. RMS of estimated components of the DORIS satellites orbits, compared with the solutions of other IDS analysis centres, do not exceed 1–2 cm. Weekly solutions for coordinates have been transformed from free network solutions (inawd06.snx series) to a well defined terrestrial reference frame ITRF2005 with the use of seven parameters of Helmert transformation, which were examined with a view to study variations of the geocenter movements (ina05wd01.geoc time series). In order to estimate linear trend, amplitudes, periods and phases of geocenter variation a method of linear regression was applied. The evaluated amplitudes of annual variations are of the order of 5–7 mm for X and Y components and 27–29 mm for Z component. Semi-annual amplitudes are also noticeable in all components (1–34 mm for X, Y and Z components). Secular trends in the DORIS geocenter coordinates are: −1.2, −0.1 and −0.3 mm/year for X, Y and Z directions respectively.     

SIGMA observations of two new hard X-ray and soft gamma-ray transients: GX 354-0 and Nova Persei

We report the first detection of two soft gamma ray transients GX 354-0 and Nova Persei (GRO J0422+32) by the coded-mask telescope SIGMA. Only preliminary results are presented with regard to Nova Persei while special emphasis is given to the data on GX 354-0 which has been monitored during the 1992 February–April survey of the Galactic Center. GX 354-0 underwent two flares of about two week duration and its average spectrum is well described by a thermal Bremsstrahlung model or a broken power law whereas the Nova Persei spectrum seems to be similar to the one observed for GRS 1124-684 in Musca.     

Formation and evolution of low-mass Algols

We discuss the origin, evolution and fate of low-mass Algols (LMA) that have components with initial masses less than 2.5 M₀. The semi-major axes of orbits of pre-LMA do not exceed 20–25 R₀. The rate of formation of Algol-type stars is 0.01/year. Magnetic stellar winds may be the factor that determines the evolution of LMA. Most LMA end their lives as double helium degenerate dwarfs with M₁/M₂ 0.88 (like L870-2). Some of them even merge through angular momentum loss caused by gravitational waves.     

Frequency estimation techniques for high dynamic trajectories

A comparison is presented of four different estimation techniques applied to the problem of continuously estimating the rapidly varying parameters of a sinusoidal signal, observed in the presence of additive noise. Frequency estimates are emphasized, although phase and/or frequency rate are also estimated by some of the algorithms. These parameters are related to the velocity, position, and acceleration of the maneuvering receiver or transmitter. Estimated performance at low carrier-to-noise ratios and high dynamics is investigated for the purpose of determining the useful operating range of an approximate maximum likelihood estimator, an extended Kalman filter, a cross-product automatic frequency loop and a phase-locked loop. Numerical simulations are used to evaluate performance while tracking a common trajectory exhibiting high dynamics     

A noise insensitive solution to an ambiguity problem in spectralestimation

The instantaneous frequency measurement (IFM) receiver is capable of measuring the center frequency of single frequency pulses over a wide range (bandwidth) of center frequencies. Because of various constraints, the frequency resolution requirement results in long correlator delay times that reduce the single correlator bandwidth. A large bandwidth can be achieved only if two or more correlators are used. The problem of estimating frequency is then reduced to the simultaneous congruence problem of number theory. A design procedure is presented for solving the congruence problem for a given amount of noise protection, a stated frequency resolution, a minimum bandwidth, and a fixed level of precision (bits) in the IFM receiver     

Simulation of Permanent Magnet Generator/Rectifier Combination

Permanent magnet generators are often used as the pilot exciters of three-stage generating units to provide an efficient and reliable source of electrical power. No external power supply is then necessary, and the problems associated with brushwear and with arcing at the rubbing contacts are eliminated. A technique is presented here by which the performance of a permanent magnet generator, when combined with a rectifier-fed d.c. load at its output terminals, may be accurately and efficiently computed. The machine model takes into account the magnetization characteristic of the permanent magnet rotor and involves only parameters which can be determined from terminal measurements on the machine at standstill. Both computed and measured characteristics for an experimental machine are presented, and a comparison of these characteristics shows that the model can predict accurately all the major characteristics of the machine, as well as its detailed internal performance, when supplying a typical resistiveinductive load.     

UVCS Observations and Modeling of Streamers

We present results derived from the analysis of an equatorial streamer structure as observed by the UVCS instrument aboard SOHO. From observations of the H I Lyα and Lyβ lines we infer the density and temperature of the plasma. We develop a preliminary axisymmetric, magnetostatic model of the corona which includes the effects of gas pressure gradients on the magnetic structure. We infer a coronal plasma β > 1 in the closed field regions and near the cusp of the streamer. We add to the model a parallel velocity field assuming mass flux conservation along magnetic flux tubes. We then compute the Lyα emissivity and the line-of-sight integrals to obtain images of Lyα intensity, taking into account projection effects and Doppler dimming. The images we obtain from this preliminary model are in good general agreement with the UVCS observations, both qualitatively and quantitatively. This revised version was published online in June 2006 with corrections to the Cover Date.     

The conundrum of software estimation models

There are many sophisticated models and methods for estimating the size, cost, and schedule of software projects. However, the ability to accurately estimate software cost, size, or schedule is still dubious. In general, the predictive accuracy of models for estimating software development cost and schedule has not been shown to be better than “within 25 percent of actual cost or schedule, about one half of the time”, especially for Department of Defense software efforts. The same is true for software size estimating models and methods, although there are some studies that have shown superior results. For software support (or maintenance) cost estimation, no model has been demonstrated to be accurate. This paper presents a summary of efforts performed to date which demonstrate the accuracy (or lack thereof) of software models. The results of several studies in the areas of software development cost and schedule estimation, size estimation, and support cost estimation are presented to show what these models can and cannot do. Some ideas for improvement are also presented, including the results of some studies which may lead to a resolution of the accuracy conundrum which currently exists