EUV emission from normal galaxies

Using data from the Wide Field Camera EUV all-sky survey, we have established upper limits to the EUV flux from a sample of 30 bright, nearby, non-active spiral galaxies. These galaxies were chosen to be those most likely to be detected in the EUV on the basis of (i) low interstellar absorption within our own galaxy, (ii) brightness in other wavebands, (iii) high star formation activity, and (iv) proximity. The derived EUV upper limits are restrictive, and establish for the first time that the EUV flux escaping from galaxies does not constitute a major component of their bolometric luminosity, and in particular that it cannot be the sink for the energy injected into the interstellar medium by supernova explosions, as had been suggested following the failure to detect this power in the X-ray band.     

Reconfigurable NDI controller using inertial sensor failuredetection & isolation

A modified derivation of nonlinear dynamic inversion provides the theoretical underpinnings for a reconfigurable control law for aircraft that have suffered combinations of actuator failures, missing effector surfaces, and aerodynamic changes. The approach makes use of acceleration feedback to extract information pertaining to any aerodynamic change and thus does not require a complete aerodynamic model of the aircraft. The control law does require feedback of effector positions to accommodate actuator dynamics. Both accelerometer and rate gyro failure detection and isolation (FDI) systems are implemented, allowing up to three independent failures for each FDI system as long as they are in different axes. Nonlinear simulation results show that the FDI systems improve the robustness to accelerometer/rate gyro uncertainties. An advanced tailless aircraft model is used to demonstrate the concepts. The simulation includes accelerometer and rate gyro noise and bias, failures due to accelerometers, rate gyros, and actuators, and modeled missing surfaces that cause airplane aerodynamic changes     

Observer-type Kalman innovation filter for uncertain linear systems

An observer-type of Kalman innovation filtering algorithm to find a practically implementable "best" Kalman filter, and such an algorithm based on the evolutionary programming (EP) optima-search technique, are proposed, for linear discrete-time systems with time-invariant unknown-but-hounded plant and noise uncertainties. The worst-case parameter set from the stochastic uncertain system represented by the interval form with respect to the implemented "best" filter is also found in this work for demonstrating the effectiveness of the proposed filtering scheme. The new EP-based algorithm utilizes the global optima-searching capability of EP to find the optimal Kalman filter and state estimates at every iteration, which include both the best possible worst case Interval and the optimal nominal trajectory of the Kalman filtering estimates of the system state vectors. Simulation results are included to show that the new algorithm yields more accurate estimates and is less conservative as compared with other related robust filtering schemes     

The Freja ultraviolet imager

Auroral images acquired by satellite instrumentation have proven to be a crucial component of the scientific equiry into the physical processes of the Earth's magnetosphere. TheFreja mission provided an opportunity to extend these measurements into the temporal and spatial regime commonly associated with ground-based optical imagers. Employing the basic procedure used successfully in theViking program allowed image repetition rates of 6 s to be achieved with simultaneous exposure of all pixels within the field-of-view. Typical exposure times of 0.3 s required development of an improved image intensifier system and operational requirements resulted in image formats covering approximately one-third of a spin. Simultaneously exposing two broad-band UV cameras, the instrument generates in its normal operational mode 264.6 kbytes per image pair. Results from initial operations confirm the design approach and suggest such imagers can be routinely included on challenging low cost missions such asFreja.     

High Dynamic GPS Receiver Using Maximum Likelihood Estimationand Frequency Tracking

A new high dynamic global positioning system (GPS) receiver ispresented and its performance characterized by analysis,simulation, and demonstration. The demonstration receiver is abreadboard model capable of tracking a single simulated satellitesignal in pseudorange and range rate. Pseudorange and range rateestimates are made once every 20 ms, using a maximum likelihoodestimator, and are tracked by means of a third-order fadingmemory filter in a feedback configuration. The receiver trackspseudorange with rms errors of under 1 m when subjected tosimulated 50 g, 40 g/s circular trajectories. The tracking thresholdis approximately 28 dB·Hz, which provides 12 dB margin relativethe the minimum specified signal strength, assuming 3.5 dB systemnoise figure and 0 dB antenna gain.     

New instrumentation for optical measuring of oxygen in gas or dissolved in liquids.

The optical oxygen sensor is a novel device for the determination of oxygen in gases or dissolved in liquids. It is based on the measurement principle of fluorescence quenching, which is completely different from that of polarographic oxygen sensors (today the most widespread devices of oxygen detection). The new instrument offers features and advantages, which render it not only a realistic alternative, but, for specific applications, make it superior to existing electrochemical methods. The system is based on low-cost semiconductor devices (light-emitting diodes, photodiodes, low-cost analogue and digital components) and new LED-compatible oxygen-sensitive membranes. The flow cell of the instrument may be thermostatted and the sensor can be calibrated by a simple two-point calibration procedure. The optical oxygen sensor is particularly suitable for measuring dissolved oxygen in respirometry, since no oxygen is consumed by the device and the signal is independent of sample flowrate or stirring speed. Typical fields of application are monitoring of oxygen in ground and drinking water, in process control in bioreactors and in breath gas and blood gas analysis.     

Large-size space laboratory for biological orbit experiments.

The study of space factors on living systems has great interest and long-term experiments during orbital flight will be important tool for increasing our knowledge. Realization of such experiments is limited by constraints of modern space stations. A new technology of large-size space laboratory for biological experiments has been developed on the basis of polymerization techniques. Using this technique there are no limits of form and size of laboratory for a space station that will permit long term experiments on Earth orbit with plants and animals in sufficient volume for creation of closed self-regulating ecological systems. The technology is based on experiments of the behavior of polymer materials in simulated free space conditions during the reaction of polymerization. The influences of space vacuum, sharp temperature changes and space plasma generated by galactic rays and Sun irradiation on chemical reaction were evaluated in their impact on liquid organic materials in laboratory conditions. The results of our study shows, that the chemical reaction is sensitive to such space factors. But we believe that the technology of polymerization could be used for the creation of space biological laboratories in Earth orbit in the near future.     

Use of combined light flash and plasma measurements to study hypervelocity impact processes

We present new measurements concerning generation of light flash during hypervelocity impacts. We use iron particles (10⁻¹³ to 10⁻¹⁷ kg) with velocities over the range 1 to 42 km/s impacting semi-infinite targets (aluminium and molybdenum). The main results of previous work in the field are found to be reproduced with some slight deviations. For iron projectiles with given mass and velocity the energy of the flash (normalized to mass) is proportional to velocity to the power of 3.5 for aluminium targets and 3.9 for molybdenum targets. The duration of the flash is of order 1 microsecond. Simultaneous measurements of the generation of impact plasma do not change this. The onset of plasma generation of the bulk target material does not affect the total light flash energy. We discuss the duration of the flash compared to a simple calculation of temperature in the target and plasma vs time.