复合固体推进剂燃气烟雾对激光透射的影响

建立了一套测定固体推进剂燃气烟雾对激光衰减的装置,研究了固体推进剂燃气对激光衰减的规律,由实验结果和理论分析得出,燃气烟雾对激光和可见光的透射率较好;能量较高的丁羟推进剂无烟化的最佳配方是Al粉含量应小于8%,硝胺(HR)的含量应大于30%。     

GPS／惯性组合导航系统导航性能的仿真与分析

本文从卡尔曼滤波的基本原理和几何精度因子GDOP的物理意义出发,并结合实例的仿真计算结果,讨论GPS/惯性组合导航系统的定位和测速精度。结果表明:由于位置和速度的双重组合,且由于卡尔曼滤波具有利用以前所有测量值的能力,以及综合利用GPS和惯导信息的能力,所以组合系统的精度虽仍与GDOP有关,但却高于单独利用GPS接收机点解法得到的定位和测速精度,其中定位精度的提高更为显著。     

Experimental investigation of the modes of operation of uncontrolled attitude motion of the Progress spacecraft

Results of in-flight tests of three modes of uncontrolled attitude motion of the Progress spacecraft are described. These proposed modes of experiments related to microgravity are as follows: (1) triaxial gravitational orientation, (2) gravitational orientation of the rotating satellite, and (3) spin-up in the plane of the orbit around the axis of the maximum moment of inertia. The tests were carried out from May 24 to June 1, 2004 onboard the spacecraft Progress M1-11. The actual motion of this spacecraft with respect to its center of mass, in the above-mentioned modes, was determined by telemetric information about an electric current tapped off from solar batteries. The values of the current obtained during a time interval of several hours were processed jointly using the least squares method by integration of the equations of the spacecraft’s attitude motion. The processing resulted in estimation of the initial conditions of motion and of the parameters of mathematical models used. For the obtained motions the quasi-static component of microaccelerations was computed at a point onboard, where installation of experimental equipment is possible.     

铝合金真空钎焊用低温铝基钎料的研究

为了避免在铝合金焊接中产生晶粒长大、溶蚀等缺陷,提高铝合金的钎焊质量,本文在Al-Si共晶钎料的基础上加入合金元素Cu和其它微量元素,研制新的低熔点钎料,最后确定新钎料为Al19Cu9Si。该钎料的熔点为543℃,比BAl86.5SiMg钎料的熔点降低了40℃,试验结果表明新钎料具有良好的润湿性、流动性,接头的剪切强度、抗腐蚀性能均满足铝合金钎焊要求。     

Some technical aspects of gaseous detonation

This paper briefly describes two attempts to utilize detonative combustion processes to MHD conversion of thermal energy of fuel to electrical energy and bonding of atmospheric nitrogen. For this purpose a continuous impulse detonation chamber with a frequency up to 200 cps was constructed. Using methane-oxygen-nitrogen mixtures the chamber was maintained in stable operation for several hundred hours. Oil was also employed as fuel.Estimates based on experimental data showed that up to 2% of chemical energy of the fuel may be converted into electrical energy. The use of an accelerating nozzle may improve this result.The concentration of nitrogen oxide in combustion products of the detonation wave was higher by 14% than that expected under usual combustion conditions.The advantages of this type of apparatus are: absence of compressors for fuel and oxidant, impulse current generation, low temperatures of chamber walls, and operation over a large range of operating conditions.Problems associated with the effect of the magnetic field on the propagation of the detonation wave are discussed and the possibility of applying the Zeldovich theory to the case of MHD interaction is described. It is shown that the detonation velocity may either increase or decrease depending on the relative orientation of the direction of magnetic field with respect to the detonation wave.     

A New Population of the Cusp Suprathermal Protons Formed at Mid-Altitudes: INTERBALL-2 Measurements

A new population of dispersed suprathermal ions descending into the ionosphere is discovered in the cusp region from theINTERBALL-2 measurements at altitudes of 2–3R _E. The proton energies of the population are below the low energy cut-off of the main dispersed proton population of the magnetosheath origin, and its intensity and density are also much lower. For IMF B _z 2 nT the region of the population observations is located partly coincident with (or sometimes poleward from) the main proton population of the cusp proper. The pitch-angle velocity dispersion in the population during a 2-min satellite rotation manifests itself as a typical pitch-angle V together with a velocity dispersion due to poleward convection. The satellite passes chosen for the detailed analysis and modeling lay approximately along the cusp/cleft band from afternoon till prenoon MLT sectors, thus emphasizing the pitch-angle dispersion role with respect to the dispersion due to convection. This allows one to observe the suprathermal proton population during several tens of minutes over the MLT range of 3 h around noon, i.e., similarly to the MLT extension of the cusp proper. A remarkable space/time stability of this new population is due to its low velocity (tens of km/s) and/or velocity diffusion in the flux tubes of the cusp proper. We have performed both backward tracing of proton trajectories in the Tsyganenko-96 model, and kinetic modeling of the kinematic variations of the distribution function for protons along their way from the bi-Maxwellian source in the form of a heating wall till the satellite. The parameters of the model were adjusted to the observed energy–time spectrograms. They consistently indicate the origin of the descending suprathermal proton population at intermediate altitudes of 5R _E, i.e., within cusp flux tubes but well below the magnetopause. Some published measurements from the POLAR satellite in the cusp region at altitudes of 4–5R _E seem to be consistent with the supposition of crossing the source region of this population, variable in space and time (though these measurements were interpreted in a different manner).     

带弹性附件的卫星的姿态动力学方程

本文采用虚功形式的d’A1embert原理建立了带弹性附件的卫星的姿态动力学方程。方程便于与有限元程序结合。对于非自旋卫星,可以给出线性化的方程。文中建议以各阶约束模态的角动量系数对弹性附件的惯矩的贡献作为降价的参考较为方便。文章给出了一个数字例。     

基于分数傅立叶变换的SAR成像算法研究

当距离徙动较小时,合成孔径雷达(SAR)回波信号在方位向和距离向都可以转化为调频信号,据此提出一种基于分数傅立叶变换(FRFT)的SAR成像算法,通过距离向和方位向的特定阶次的FRFT,在两个方向上把回波信号同时近似地压缩为脉冲函数。理论分析和仿真数据结果表明,该算法计算简单快速,只需两次FRFT即在分数傅立叶域可以有效成像,并且成像精度优于传统的Chirp Scaling算法。     

星载SAR对抗方法研究

论述了星载SAR的特点及固有缺陷,从有源和无源两个方面提出了几种不同的星载SAR对抗方法,最后给出了结论。     

DATH在CMDB推进剂中应用研究

对ＤＡＴＨ在复合改性双基推进剂中应用及配装浇 出工艺制ＤＡＴＨ－ＣＭＤＢ推进剂药柱过程中出现的较强固化放气问题做了探讨，得出了若干结论。