N2O微推力器性能及喷管热结构分析

针对采用氧化亚氮推进剂的单组元微推力器开展了比冲性能影响因素的分析,分析结果显示微推力器比冲与氧化亚氮分解效率及喷管扩张比有着密切关系。利用有限元分析法对高空及地面试验两种工况下氧化亚氮单组元微推力器喷管的结构温度场开展了数值仿真计算,并在结构温度场仿真计算的基础上进一步对地面试验用喷管的结构应力场进行了分析。初步试验表明,所设计的微喷管在地面工况下工作良好。     

月球探测器着陆过程羽流热效应数值模拟研究

考虑到月球探测器着陆过程变推力发动机工作可能引发羽流热效应,通过差分求解N S方程与直接模拟蒙特卡洛(DSMC)耦合的方法,针对探测器变推力发动机羽流的连续流区与稀薄流区进行了数值模拟,获得了着陆过程不同状态探测器表面的羽流气动热流密度分布,分析了探测器在不同高度及坡度受到的羽流热效应,研究了探测器因落月惯性与发动机延时拖尾等特殊工况羽流气动热的影响程度。数值模拟结果表明,探测器受到的羽流气动热影响总体随着发动机出口与月面间距离减小而急剧增强,随着距离减小至0.434 m,热流密度最大值为429 kW/m 2 ,而且月面坡度对羽流热效应有减弱作用。研究结果可为探测器关机策略的制定提供支撑,为探测器关键部位的热防护提供输入,为探测器整体的设计优化提供服务。     

喷管流场和羽流场的N－S数值模拟

利用时间推进的方法，通过求解可压缩的、雷诺平均的Ｎ－Ｓ方程，并利用Ｂａｌｄｗｉｎ－Ｌｏｍａｘ两层代数湍流模型和Ｐｒａｎｄｔｌ混合长度模型，数值模拟了飞机和火箭发动机喷管的内流和羽流，获得了喷管内流场和羽流场的参数分布，计算结果与试验结果及国外研究成果一致。网格划分采用了自适应网格技术。     

单喷嘴气-气喷注器推力室燃烧流场相似性

 设计了单喷嘴容热式气-气喷注器推力室,喷注器采用同轴剪切式,氢气/氧气作为推进剂。在同一燃烧室采用了0.92~6.10 MPa范围内7个室压工况,并在同一室压下采用不同燃烧室尺寸工况进行了试验研究,在变化室压和推力室尺寸时,推进剂种类、温度、混合比和喷注速度保持不变,燃烧室尺寸变化时保持几何相似,采用燃烧室壁面测温方法对比了不同工况下内流场的相似性。研究结果表明：不同室压和不同推力室尺寸工况下的推力室内流场具有相似性。     

应用于DSMC方法的二维Voronoi网格技术

研究了Voronoi网格技术并将其应用于直接模拟蒙特卡洛DSMC(Direct Simulation Monte Carlo)计算.基于Dirichlet镶嵌与Voronoi图理论,Voronoi网格利用特征点表征网格单元,具有建立粒子与网格单元之间映射关系的独特算法,适合于DSMC方法的统计特点.在剔除过于靠近边界的特征点以及必要情况下边界细化的基础上,通过区分由边界节点表征的非完整Voronoi网格单元以及由计算区域内镶嵌点表征的完整Voronoi网格单元,解决了Voronoi网格的二维边界匹配问题.Voronoi网格技术支持自适应DSMC计算.映射效率对比表明,Voronoi网格的DSMC计算效率高于三角形网格,低于多级直角网格.通过MEMS微喷管流动数值模拟,验证了Voronoi网格技术在DSMC方法中的有效性.      

关于螺旋桨桨叶有利迎角的探讨

通过桨叶的性质角与迎角关系的数学模型,对桨叶有利迎角进行了分析研究。当桨叶迎角和桨叶性质角变化时,桨叶极线图和桨叶总空气动力向拉力轴靠近或离开,由此找出桨叶的最有利状态。通过分析得出,桨叶迎角接近桨叶临界迎角时最有利。最后通过桨叶极线图和桨叶总空气动力方向变化的模型实验验证了此结论的正确性。     

压力波对垂直管低温气液掺混冷凝的影响

为了分析高压补燃液氧煤油发动机氧泵间管内气液两相掺混冷凝及其压力波传播过程,建立了可产生压力扰动的垂直管低温气液两相掺混实验系统,以氧气/液氧为实验工质,开展压力波对垂直管内低温气液两相掺混冷凝的影响研究,获得了不同压力波频率和氧气流量工况下的掺混图像,分析结果表明:压力波会使发散流型由微弱振荡冷凝向间歇振荡冷凝转变,使椭圆流型由稳定冷凝向振荡冷凝转变;在0~52 Hz不同频率压力波作用下,发散流型最大轴向冷凝长度与掺混孔径之比在10~30之间,椭圆流型的比值在8~15之间变化;压力波对气相摆动频率起主导性和正相关性的影响。     

Numerical Simulation of 2D Supersonic Magnetohydrodynamic Channel and Study on Hall Effect

In this research effort,numerical simulation of two-dimensional magnetohydrodynamic(MHD) channel is performed and Hall effect is studied.The computational model consists of the Navier-Stokes(N-S) equations coupled with electrical-magnetic source terms,Maxwell equations and the generalized Ohm’s law.Boundary conditions for the electrical potential equation considering Hall effect are derived.To start with,the MHD channel with single-pair electrodes is studied and flow of the electric current is in accordance with physical principle.Then the MHD channel with five-pair electrodes is numerically simulated.The results show that the electrical current concentrates on the downstream of the anode and the upstream of the cathode due to Hall effect,and the flow field becomes asymmetrical.At the current value of the magnetic interaction parameter,the electrical-magnetic force affects the flow remarkably,decreasing the outlet Mach number and increasing the outlet pressure;what’s more,the flow structure in the channel becomes extremely complex.Performances of MHD channels with continual electrodes and segmented electrodes are compared.The results show that performance of the MHD channel with segmented electrodes is better than that with continual electrodes with the increase of Hall parameter.     

飞行中飞机加油门后的动态特点分析

主要对飞机单纯加油门后的运动规律做了定量的理论计算，对定长周期运动进行了一定物分析，得出了飞机在小速度时加油后有三种可能的状态，即收敛、发散和中立稳定。并指出飞机加油门后的增速状态是暂时的，一般民政部下增速之后，是一个高度与速度相互转化的振荡过程。同时还指出低空小速度时，在加油门后暂时的增速过程中靠拉杆争取高度是不安全的。     

Achievable debris orbit prediction accuracy using laser ranging data from a single station

Earlier studies have shown that an orbit prediction accuracy of 20 arc sec ground station pointing error for 1–2 day predictions was achievable for low Earth orbit (LEO) debris using two passes of debris laser ranging (DLR) data from a single station, separated by about 24 h. The accuracy was determined by comparing the predicted orbits with subsequent tracking data from the same station. This accuracy statement might be over-optimistic for other parts of orbit far away from the station. This paper presents the achievable orbit prediction accuracy using satellite laser ranging (SLR) data of Starlette and Larets under a similar data scenario as that of DLR. The SLR data is corrupted with random errors of 1 m standard deviation so that its accuracy is similar to that of DLR data. The accurate ILRS Consolidated Prediction Format orbits are used as reference to compute the orbit prediction errors. The study demonstrates that accuracy of 20 arc sec for 1–2 day predictions is achievable.