Flight Flutter Modal Parameters Identification with Atmospheric Turbulence Excitation Based on Wavelet Transformation

针对基于大气紊流激励的飞机颤振试验数据具有信噪比低以及测量数据以加速度响应形式给出等特点,将小波变换与随机减量法相结合对飞机颤振模态参数进行识别,首先利用随机减量法获得结构在非零初始加速度条件下的自由衰减响应,然后对该自由衰减响应进行Morlet连续小波变换,为使变换简单,本文采用了Parseval定理和留数定理,利用Morlet的带通滤波特性,通过搜索小波变换系数在不同的尺度区域内的极大值,再根据小波变换系数的极大值、相角与固有振动频率及阻尼系数间的关系,即可识别出各模态参数。并对利用小波变换识别颤振模态参数时,实现模态解耦应满足的条件进行了分析研究。通过仿真和飞机颤振试验数据分析,验证了该识别方法不仅简单、有效和可行,而且具有较强的抗噪性。     

蛇形进气道的电磁散射特性

 对一种进口与机身保形设计的蛇形进气道在Ku波段选择入射频率15 GHz情况下进行了电磁散射特性的实验和仿真研究,取得了蛇形进气道雷达散射截面(RCS)随方位角、迎角和终端的变化规律。研究结果表明: (1)该蛇形进气道在水平极化终端为风扇时±60° RCS均值为-24.33 dB·m²,垂直极化为-19.15 dB·m²,是一种低RCS进气道;(2)运用时域有限差分法计算所得的RCS随方位角变化曲线与实验曲线趋势基本一致,±60°均值误差在4 dB以内;(3)从进气道对称面电场(Ex)分布图可以看出入射波射入进气道并在内壁面产生多次反射,从而验证了蛇形进气道的设计思想并为在内通道关键反射点涂敷吸波材料实现蛇形进气道的高隐身提供了一个可行的研究平台。     

电大目标等离子体隐身的矩量法优化设计

根据高频散射特征,提出典型几何散射中心替代法,用于解决矩量法（MOM）用于电大目标等离子体隐身时的优化设计问题。以某典型电大目标为例,通过仿真分析了该方法的可行性。结果显示,电大目标覆盖利用该方法得到最优参数的等离子体后,不仅目标整体的单站RCS平均缩减与典型几何散射体的单站RCS缩减相当,且任意方向上RCS基本都有10dB左右的缩减,表明用该方法得到用于电大目标隐身的等离子体参数是可行的。     

分布式航天器相对位置测量平台设计

分布式航天器间相对位置的实时高精度测量是分布式航天器实现空间队形保持的关键技术之一。为了对相对位置测量方法进行研究、分析和论证,建立了分布式航天器相对位置测量地面实验平台。介绍了分布式航天器相对位置测量和解算的基本原理;论述了仿真平台的组成和功能;基于仿真平台对相对位置测量精度进行了仿真试验,试验结果显示该平台具有良好的性能指标;最后介绍了相对位置解算仿真评估软件的设计方法。     

高超声速滑翔再入定向定速打击末制导算法

以具有终端落角和落速约束的小升阻比短距滑翔高超声速再入打击飞行器为研究对象,通过引入弹道调整段来实现对飞行器的初步大幅度减速,并使其满足中末制导交班条件,以解决飞行器捕获目标后难以直接对其进行定向定速打击的问题。首先设计了一种变角偏差反馈系数的偏置比例制导律,解决了末端攻击段弹道下压困难以及导引头视场稳定跟踪等问题。在此基础上,建立了一种基于攻角和弹道倾角估计的末端减速指令生成方法,有效解决了基于理想速度曲线减速控制方法精度不足的问题。因此,数值仿真结果表明该制导方案能够有效控制飞行器终端落角和落速,并具有较高的制导精度。     

航天器表面电荷激发空间静电场规律研究

从带电表面微元出发,通过求解泊松方程,得到带电介质平板表面邻近空间静电势的解析表达式,建立介质表面电位-介电常数模型,求得了带电介质平板表面电位、表面带电量和介质介电常数三者之间的关系式。结合典型的航天器表面介质材料带电案例,对此类圆盘结构介质平板带电问题进行了仿真分析,结果表明,在介质材料表面电位一定的情况下,表面电荷激发的空间静电势值随距离的增大而减小,并且距离介质表面越近,电势的空间变化率越大;在介质材料带电量相等的情况下,介质表面电位随着介质介电常数的增大而减小,并逐渐趋于一个稳定值,所以在一定范围内选择介电常数较大的介质材料可以降低介质的表面电位,减小介质间发生静电放电的几率。     

Eliminating negative VTEC in global ionosphere maps using inequality-constrained least squares

Currently, ground-based Global Navigation Satellite System (GNSS) stations of the International GNSS Service (IGS) are distributed unevenly around the world. Most of them are located on the mainland, while only a small part of them are scattered on some islands in the oceans. As a consequence, many unreasonable zero values (in fact negative values) appear in Vertical Total Electron Content (VTEC) of European Space Agency (ESA) and Center for Orbit Determination in Europe (CODE) IONEX products, especially in 2008 and 2009 when the solar activities were rather quiet. To improve this situation, we directly implement non-negative physical constraints of ionosphere for global ionosphere maps (GIM) with spherical harmonic functions. Mathematically, we propose an inequality-constrained least squares method by imposing non-negative inequality constraints in the areas where negative VTEC values may occur to reconstruct GIM models. We then apply the new method to process the IGS data in 2008. The results have shown that the new algorithm efficiently eliminates the unwanted behavior of negative VTEC values, which could otherwise often be seen in the current CODE and ESA GIM products in both middle and high latitude areas of the Southern Hemisphere (45°S∼90°S) and the Northern Hemisphere (50°N∼90°N). About 64% of GPS receivers’ DCBs have been significantly improved. Finally, we compare the GIM results between with and without the inequality constraints, which has clearly shown that the GIM result with inequality constraints is significantly better than that without the inequality constraints. The inequality-constrained GIM result is also highly consistent with the final IGS products in terms of root mean squared (RMS) and mean VTEC.     

GRACE gravity field modeling with an investigation on correlation between nuisance parameters and gravity field coefficients

The GRACE (Gravity Recovery And Climate Experiment) monthly gravity models have been independently produced and published by several research institutions, such as Center for Space Research (CSR), GeoForschungsZentrum (GFZ), Jet Propulsion Laboratory (JPL), Centre National d’Etudes Spatiales (CNES) and Delft Institute of Earth Observation and Space Systems (DEOS). According to their processing standards, above institutions use the traditional variational approach except that the DEOS exploits the acceleration approach. The background force models employed are rather similar. The produced gravity field models generally agree with one another in the spatial pattern. However, there are some discrepancies in the gravity signal amplitude between solutions produced by different institutions. In particular, 10%–30% signal amplitude differences in some river basins can be observed. In this paper, we implemented a variant of the traditional variational approach and computed two sets of monthly gravity field solutions using the data from January 2005 to December 2006. The input data are K-band range-rates (KBRR) and kinematic orbits of GRACE satellites. The main difference in the production of our two types of models is how to deal with nuisance parameters. This type of parameters is necessary to absorb low-frequency errors in the data, which are mainly the aliasing and instrument errors. One way is to remove the nuisance parameters before estimating the geopotential coefficients, called NPARB approach in the paper. The other way is to estimate the nuisance parameters and geopotential coefficients simultaneously, called NPESS approach. These two types of solutions mainly differ in geopotential coefficients from degree 2 to 5. This can be explained by the fact that the nuisance parameters and the gravity field coefficients are highly correlated, particularly at low degrees. We compare these solutions with the official and published ones by means of spectral analysis. It is found that our solutions are, in general, consistent with others in the spatial pattern. The water storage variations of the Amazon, Chari and Ganges river basins have also been computed. The variations computed with the NPARB approach are closer to those produced by JPL and DEOS solutions, while the variations produced with the NPESS approach are in good agreement with those produced by the CSR and GFZ solutions. A simulation study is implemented with considering realistic noise and low-frequency error. The two approaches are used to recover the true model. The NPESS solution appears closer to the true one. Therefore we are inclined to estimate the nuisance parameters simultaneously with the geopential coefficients.     

干涉配合构件的应力腐蚀开裂特性

采用恒载荷拉伸实验技术,研究了镀锌３０ＧｒＭｎＳｉＡ锡螺栓干涉配合连接ＬＹ１２－ＣＺ铝合金构件在３．５％ＮａＣａｌ＋０．５％Ｈ２Ｏ２溶液中的应力腐蚀开裂特性。结果表明,随干涉量的增加,应力腐蚀敏感性有所下降,基材与紧固件的电偶效应对应力腐蚀繁感性有重大影响。