Determination of station positions and velocities from laser ranging observations to Ajisai,Starlette and Stella satellites

The positions and velocities of the four Satellite Laser Ranging (SLR) stations: Yarragadee (7090), Greenbelt (7105), Graz (7839) and Herstmonceux (7840) from 5-year (2001–2005) SLR data of low orbiting satellites (LEO): Ajisai, Starlette and Stella were determined. The orbits of these satellites were computed from the data provided by 20 SLR stations. All orbital computations were performed by means of NASA Goddard’s GEODYN-II program. The geocentric coordinates were transformed to the topocentric North–South, East–West and Vertical components in reference to ITRF2005. The influence of the number of normal points per orbital arc and the empirical acceleration coefficients on the quality of station coordinates was studied. To get standard deviation of the coordinates determination lower than 1 cm, the number of the normal points per site had to be greater than 50. The computed positions and velocities were compared to those derived from LAGEOS-1/LAGEOS-2 data. Three parameters were used for this comparison: station coordinates stability, differences from ITRF2005 positions and velocities. The stability of coordinates of LEO satellites is significantly worse (17.8 mm) than those of LAGEOS (7.6 mm), the better results are for Ajisai (15.4 mm) than for Starlette/Stella (20.4 mm). The difference in positions between the computed values and ITRF2005 were little bit worse for Starlette/Stella (6.6 mm) than for LAGEOS (4.6 mm), the results for Ajisai were five times worse (29.7 mm) probably due to center of mass correction of this satellite. The station velocities with some exceptions were on the same level (≈1 mm/year) for all satellites. The results presented in this work show that results from Starlette/Stella are better than those from Ajisai for station coordinates determination. We can applied the data from LEO satellites, especially Starlette and Stella for determination of the SLR station coordinates but with two times lower accuracy than when using LAGEOS data.     

A technique for presentation and application of the propeller fan multidimensional characteristics in semi-full-scale simulation of a gas turbine engine and its automatic control system

A technique for linear interpolation of the multidimensional characteristics of a coaxial propeller fan with opposite rotation propellers is proposed; the technique makes it possible to simulate the turbofan engine operation in the entire range of flight conditions and reduce expenses for fullscale tests. The mathematical models obtained meet the requirements imposed in the semi-full-scale simulation.     

Variation in the ionospheric propagating factor M(3000)F2 at Ouagadougou,Burkina Faso

We use hourly monthly median values of propagation factor M(3000)F2 data observed at Ouagadougou Ionospheric Observatory (geographic12.4°N, 1.5°W; 5.9^o dip), Burkina Faso (West Africa) during the years Januar1987–December1988 (average F10.7 < 130 × 10⁻²² W/m²/Hz, representative of low solar flux conditions) and for January 1989–December1990 (average F10.7 ? 130 × 10⁻²² W/m²/Hz, representative of high solar epoch) for magnetically quiet conditions to describe local time, seasonal and solar cycle variations of equatorial ionospheric propagation factor M(3000)F2 in the African region. We show that that seasonal trend between solar maximum and solar minimum curves display simple patterns for all seasons and exhibits reasonable disparity with root mean square error (RMSE) of about 0.31, 0.29 and 0.26 for December solstice, June solstice and equinox, respectively. Variability Σ defined by the percentage ratio of the absolute standard deviation to the mean indicates significant dissimilarity for the two solar flux levels. Solar maximum day (10–14 LT) and night (22–02 LT) values show considerable variations than the solar minimum day and night values. We compare our observations with those of the IRI 2007 to validate the prediction capacity of the empirical model. We find that the IRI model tends to underestimate and overestimate the observed values of M(3000)F2, in particular, during June solstice season. There are large discrepancies, mainly during high solar flux equinox and December solstice between dawn and local midnight. On the other hand, IRI provides a slightly better predictions for M(3000)F2 between 0900 and 1500 LT during equinox low and high solar activity and equinox high sunspot number. Our data are of great importance in the area of short-wave telecommunication and ionospheric modeling.     

Testing baseline stability of some neutron monitors in Europe,Africa, and Asia

For six decades, the global network of neutron monitors (NMs) has provided a continuous stream of very valuable data to the heliophysics community, leading to many insights into the myriad modes of charged particle transport in the tangled magnetic fields that permeate the 3D heliosphere. Earlier, Ahluwalia and Ygbuhay (2012) reported on the drifts in some high latitude NM counting rates in the American zone. We continue our enquiry by testing the stability of the counting rate baselines of some NMs operating in Europe, Africa, and Asia. The data from these detectors have been extremely valuable for the short-term time variation studies, but caution is advised in using the data for long-term studies from NMs with baselines that are drifting for cause(s) unknown.     

An ion analyzer for the lunar surface with E-parallel–B

We present a novel instrument concept to measure the energy and mass spectra of ions incident on the lunar surface, based on the E-parallel–B or Thomson-parabola device used extensively as a diagnostic in the plasma fusion community. The Apollo-era Suprathermal Ion Detector Experiment (SIDE) was the first instrument package to perform in-situ measurements of ions incident on the lunar surface. The ions can originate from a variety of sources, including the solar wind, the Earth’s magnetotail, and photoionization of the thin lunar atmosphere. The species and energy distribution of ions arriving at the lunar surface depend in a complicated and poorly-understood fashion on the phase of the lunar day, the position of the Moon with respect to the Earth, and on the local plasma environment.     

Analysis of nonstationary heating and cooling of a thermomagnetic engine gadolinium working element

The paper presents the results of calculating nonstatitionary heat exchange between a heattransfer agent (water) and a gadolinium working element of the thermomagnetic engine with the use of ANSYS 13.0 certified software. Recommendations for designing the thermomagnetic engine working elements are given based on the analysis of calculation results.     

Aircraft engine health management via stochastic modelling of flight data interrelations

A novel engine health management (EHM) scheme is introduced. It uses flight-level, instead of thermodynamic, data to cost-effectively augment the onboard EHM redundancy. For a nominal healthy aircraft, fault-sensitive interrelations among flight data are globally modelled inside a flight regime via Constant-Coefficient Pooled Nonlinear AutoRegressive with eXogenous (CCP-NARX) excitation representations. Single or sequential engine faults perturb these interrelations. Statistically evaluating the perturbation-induced effects draws reliable conclusions on the engine?s health. Validation and comparisons with Kalman filter-based alternatives are made throughout the regime under various operational conditions.     

Computational approach for investigation of thrust and acoustic performances of present-day nozzles

A computational viewpoint on the problems of design and numerical simulation for the nozzles of modern aircraft turbofan engines is presented. Modern concepts of noise-suppressing nozzles for civil aircraft are reviewed. Examples of application of CFD (computational fluid dynamics) methods to the analysis of nozzle flow structure and assessment of nozzle thrust characteristics are given. Errors of turbulence models in simulation of jets are analyzed. The authors’ experience in simulation of noise-suppressing nozzles for supersonic civil aircrafts is demonstrated. Insufficient accuracy of acoustic analogies for this class of tasks is shown, but a possible area of acoustic analogies application is noted. The essential elements of computational aeroacoustics (CAA) approach and numerical methods characteristic of CAA are reviewed. Numerical methodology for the simulation of nozzle acoustic performance is described in detail, including methods for simulation of near and far field of a nozzle, for generation of input perturbations and for the processing the far-field noise. Results of verification and methodical analysis of this acoustic methodology are presented.     

Solid nanomembrane manufacture using ion-plasma action

A process of manufacture of porous membranes made of aluminum foil (Al 99.99%) by the method of electrochemical anodic oxidation followed by a continuous barrier layer removal with ion-plasma irradiation is described. The membranes having a 8 mm diameter made from AL2O3 with a thickness from 2 to 5 microns thick with a regular channel arrangement are obtained. A possibility to change the channel diameter in the range of 20?C100 nm by adjusting voltage and temperature during the oxidation is shown. We present the experimental dependencies of aluminum and aluminum oxide sputtering coefficients on the energy and incidence angle of xenon ions within the energy range of 100??400 eV.