STSS红外传感器探测性能分析

随着导弹防御系统的发展,弹道导弹突防将受到更大的威胁,而弹道导弹中段是攻防对抗集中体现的区域。本文针对空间跟踪与监视系统(STSS),通过预估其红外传感器的关键性能参数,对其中段目标探测能力进行了分析,结果表明STSS将对弹道导弹突防构成严重威胁。     

硝酸羟胺水溶液的制备及其含量分析

以复分解法制备硝酸羟胺(HAN)水溶液，用正交实验分析了反应温度、反应时间和减压蒸馏温度对反应产率的影响。确定的实验室最佳制备条件为：反应时间25min，反应温度60℃，减压蒸馏温度50℃。并比较了氧化还原滴定法与酸碱滴定法测定硝酸羟胺水溶液中硝酸羟胺含量的精度。     

基于气动辅助变轨的变气动外形飞行器概念研究--最优控制律问题

从一个天地往返飞行器的上升轨道和再入返回轨道的优化，以及适用不同飞行任务的变轨要求的气动外形问题，提出一项基于气动力辅助变轨的变气动外形飞行器的新概念研究。对于一个固定气动外形飞行器要同时满足上升轨道有效载荷最大和再入轨道热流峰值、过载峰值及机动性能约束下的成本最低往往是困难的。若同时满足不同飞行任务：飞往太空站的运输任务，空间拦截和交会机动巡航任务及星际探测任务，则更为困难，实际上是不可能的。文章研究基于气动力辅助变轨，在热流约束下，气动外形参数变化对最优控制的影响。其结论为：热流约束下的最优控制解，包括考虑推力协同变轨，除了在非约束弧的滚转角不直接受气动外形影响外，其余的控制律，升力系数和滚转角都是气动外形参数和攻角的函数。因而变气动外形可作为一项新技术，即通过气动外形参数变化和相应的变轨策略而获得性能和成本都最佳的用途很广的一种新型飞行器。     

Measurement of mass diffusion coefficients of O_2 in aviation fuel through digital holographic interferometry

The experimental apparatus to measure the mass diffusion coefficients of O2 in aviation fuel was constructed based on the digital holographic interferometry method. The theory of mass diffusion coefficient and interference image processing were introduced in detail. The accuracy of the experiment was verified by measuring the mass diffusion coefficient of 0.33 mol/L KCl in aqueous solution at 298.15 K. The mass diffusion coefficients of O_2 in RP3 and RP5 aviation fuels were measured at temperature from 278.15 K to 333.15 K, and the Arrhenius equation was employed to fit the experimental data. In terms of the Stokes-Einstein equation, the viscosities of these two aviation fuels were tested to estimate the correlation among mass diffusion coefficient, viscosity and temperature. A uniform polynomial calculation correlation was proposed to predict the mass diffusion coefficients of O_2 in both RP3 and RP5 aviation fuels, and its accuracy is considerably higher than that of the Stokes-Einstein equation.     

水陆两栖飞机方向舵附面层控制研究

水陆两栖飞机采用增升手段降低起降速度后,需要提高方向舵的操纵能力。将吹气式附面层控制方法应用到水陆两栖飞机的垂尾上,建立其二维模型并进行数值模拟,设计垂尾安定面与方向舵之间的缝道挡板,防止迎风一侧的高压气流冲击背风面、阻碍吹气气流附着;研究垂尾安定面后缘和前缘吹气共同作用的组合吹气方案,防止方向舵较早失速。结果表明:垂尾采用吹气式附面层控制之后,结合缝道挡板和组合吹气,方向舵操纵能力可提高1倍左右。     

一类隔离驱动电路的“剩余驱动”问题

讨论直流变换器中将脉宽调制器（PWM）输出与受控MOS管栅极连接的一类开关驱动电路.专注于分析它在PWM电路关闭后对栅极产生的驱动信号,被命名为＂剩余驱动＂.描述这类剩余驱动的电气特性,说明它对变换器造成的危险,提出改进这类驱动电路以消除这些危险的4种方法.     

Eliminating negative VTEC in global ionosphere maps using inequality-constrained least squares

Currently, ground-based Global Navigation Satellite System (GNSS) stations of the International GNSS Service (IGS) are distributed unevenly around the world. Most of them are located on the mainland, while only a small part of them are scattered on some islands in the oceans. As a consequence, many unreasonable zero values (in fact negative values) appear in Vertical Total Electron Content (VTEC) of European Space Agency (ESA) and Center for Orbit Determination in Europe (CODE) IONEX products, especially in 2008 and 2009 when the solar activities were rather quiet. To improve this situation, we directly implement non-negative physical constraints of ionosphere for global ionosphere maps (GIM) with spherical harmonic functions. Mathematically, we propose an inequality-constrained least squares method by imposing non-negative inequality constraints in the areas where negative VTEC values may occur to reconstruct GIM models. We then apply the new method to process the IGS data in 2008. The results have shown that the new algorithm efficiently eliminates the unwanted behavior of negative VTEC values, which could otherwise often be seen in the current CODE and ESA GIM products in both middle and high latitude areas of the Southern Hemisphere (45°S∼90°S) and the Northern Hemisphere (50°N∼90°N). About 64% of GPS receivers’ DCBs have been significantly improved. Finally, we compare the GIM results between with and without the inequality constraints, which has clearly shown that the GIM result with inequality constraints is significantly better than that without the inequality constraints. The inequality-constrained GIM result is also highly consistent with the final IGS products in terms of root mean squared (RMS) and mean VTEC.     

RNSS/INS深耦合高动态导航接收机测试方法研究CSCD

卫星导航和惯性导航采用深耦合方式实现导航作为世界上最先进的导航形式,在国防中的应用越来越广泛,但其在高动态下的性能需要验证。当前针对深耦合高动态下导航接收机的测试研究较少,本文介绍了基于卫星信号模拟器的测试系统组成及测试用高动态场景,运用模拟测试原理,通过对导航接收机在高动态下定位速度和跟踪灵敏度的测试及其结果分析,验证了导航接收机的深耦合功能,对此类接收机的测试方法进行了初步探究。     

抗振晶体振荡器的仿真设计CSCD

本文介绍了利用仿真软件进行抗振晶体振荡器设计的方法,通过建立晶体振荡器结构仿真模型,对其力学特性进行深入细致的分析,并在此基础上对比分析减振材料的剪切模量和被减振物质量对晶体振荡器抗振性能的影响,优化晶体振荡器减振结构。然后,根据仿真设计制做了抗振晶体振荡器,并进行了随机振动试验。结果表明,试验现象与仿真结果基本一致,验证了仿真分析的有效性,且振动下晶体振荡器相位噪声达到-145d Bc/Hz@1k Hz,极大地提高了晶体振荡器的抗振性能。     

一种新的最速下降算法在自适应噪声对消中的应用

自适应噪声对消在很多领域有着重要应用。为了进行自适应噪声对消,提出了一种新的最速下降算法。该算法主要原理是对多元二次函数进行降维处理,使其变成一元二次函数,再应用抛物线的性质分别循环迭代地求解每一个维度上的极值。在自适应噪声对消应用中,所提算法与传统的自适应算法进行对比,具有收敛速度快,滤波效果好,滤波效果可调节,抗恶劣信噪比以及急剧变化信噪比,不需选择迭代步长,适合计算机和可编程硬件实现等优点。