Analysis of Performance Degradation in CdS Solar Cells

The effect of changes in five physically meaningful parameters on the I-V (current-voltage) curve of a CdS solar cell is calculated. Comparisons between the calculated data and performance data obtained from degraded solar cells are made. The parameter that changed to cause the degradation in each cell becomes apparent.     

弯曲网格上的间断有限元湍流数值解法研究

采用间断有限元方法对雷诺平均Navier-Stokes(RANS)方程进行了数值求解,对Spalart-Allmaras单方程湍流模型进行了部分修正,使得求解器更加鲁棒。构造了分段高次多项式来逼近真实物面,同时物面附近采用多层弯曲网格来避免网格交叉,此外提出了一种快速计算积分点的曲面物面距的方法。采用混合网格对NACA0012翼型以及RAE翼型进行了数值计算,并与实验数据以及前人数据进行了对比。计算结果表明,采用物面弯曲网格结合修正的湍流模型方法在相对稀疏的网格上就能得到比较好的数值解。     

低雷诺数下50°后掠三角翼的旋涡流动

采用数值模拟和流动显示的方法研究了50°后掠角三角翼在低雷诺数下的旋涡流动,结果表明:低雷诺数下,非细长三角翼在5°攻角时就形成了稳定的前缘涡,较小攻角时前缘主涡就开始破裂,并观察到泡型和螺旋型两种旋涡破裂方式。另外,在一定的攻角范围内,前缘主涡的外侧又生成一对新的集中涡,构成双涡结构;随着攻角的增大,前缘涡涡核不断升高,主再附线向中心移动,二次分离区扩大。     

The Freja wave and plasma density experiment

The Wave Experiment, F4, on the Swedish/German satelliteFreja, is designed to measure the electric wave fields up to 4 MHz, the magnetic wave fields up to 16 kHz and the plasma density and its relative variations up to 2 kHz. Six wave signals and four density probe signals can be measured simultaneously. The wave forms of all signals are transmitted to ground without any analysis onboard. The limited TM allocation does not allow continuous sampling of the wave signals, so normally the measurements are made in snapshots of various lengths dependent on sampling frequency, etc. Continuous sampling can be made for shorter time periods by using a 6 Mbyte memory as a buffer.     

Ulysses observations of a coronal origin particle event at 32° south heliographic latitutde

A remarkable streaming beam-like particle event of 60 keV-5 MeV ions and of 38–315 keV electrons has been reported previously. This event has been associated with the passage of a Coronal Mass Ejection (CME) over the Ulysses spacecraft on June 9–13, 1993. At this time, the spacecraft was located at 4.6 AU from the sun and at an heliolatitude of 32° south. It was proposed (Armstrong et al., 1994) that the particle injection source could have been of coronal origin. In this study, we analyse the solar activity during this period. We identify a region of solar radio noise storms in the corona and in particular, a flare on June 7 that presents all the required characteristics to produce the hot plasma beam observed in the interplanetary medium.     

Reconnection on open field lines ahead of coronal mass ejections

Plasma and magnetic field signatures from 29 November 1990 indicate that the Ulysses spacecraft passed through a series of interplanetary structures that were most likely formed by magnetic reconnection on open field lines ahead of a coronal mass ejection (CME). This reconnection changed the magnetic topology of the upstream region by converting normal open interplanetary magnetic field into a pair of regions: one magnetically disconnected from the Sun and the other, a tongue, connected back to the Sun at both ends. This process provides a new method for producing both heat flux dropouts and counterstreaming suprathermal electron signatures in interplanetary space. In this paper we expand upon the 29 November case study and argue that reconnection ahead of CMEs should be less common at high heliolatitudes.     

Isotopic Signatures of Presolar Materials in Interplanetary Dust

Interplanetary dust particles collected in the stratosphere frequently exhibit enrichments in deuterium (D) and ¹⁵N relative to terrestrial materials. These effects are most likely due to the preservation of presolar interstellar materials. While the elevated D/H ratios probably resulted from mass fractionation during chemical reactions at very low < 100 K temperatures, the origin of the N isotopic anomalies remains unresolved. The bulk of the N-bearing material may have obtained its isotopic signatures from low temperature chemistry, but a nucleosynthetic origin is also possible. This revised version was published online in August 2006 with corrections to the Cover Date.     

Genesis on-board determination of the solar wind flow regime

Some of the objectives of the Genesis mission require the separate collection of solar wind originating in different types of solar sources. Measurements of the solar wind protons, alpha particles, and electrons are used on-board the spacecraft to determine whether the solar-wind source is most likely a coronal hole, interstream flow, or a coronal mass ejection. A simple fuzzy logic scheme operating on measurements of the proton temperature, the alpha-particle abundance, and the presence of bidirectional streaming of suprathermal electrons was developed for this purpose. Additional requirements on the algorithm include the ability to identify the passage of forward shocks, reasonable levels of hysteresis and persistence, and the ability to modify the algorithm by changes in stored constants rather than changes in the software. After a few minor adjustments, the algorithm performed well during the initial portion of the mission. This revised version was published online in August 2006 with corrections to the Cover Date.     

微型扑翼飞行器的气动建模分析与试验

用计算流体力学的数值模拟方法研究了微扑翼飞行器的扑翼飞行的非定常空气动力学问题。在对昆虫扑翼飞行运动的仿生模拟基础上 ,对实际可飞的微扑翼飞行器的扑翼运动建立了三维翼型的运动学与空气动力学模型。利用任意拉格朗日欧拉 ( ALE)有限元方法求解出 N-S方程的数值解 ,证明简单扑翼布局所提供的升力足以克服微扑翼飞行器本身的重力使其飞行。在此基础上 ,分别计算并分析了拍动幅值、俯仰幅度以及扑翼频率等各种扑翼参数对升力的影响。最后 ,探索性的扑翼风洞试验与飞行试验结果在一定程度上验证了文中计算方法的可行性      

用偏微分方程构造车身外形曲面

阐述了在给定边界条件及其他曲面限制因素的情况下,用偏微分方程构造曲面的基本理论;研究了引入曲面形状控制系数来控制生成曲面的形状以及应用于车身外形曲面设计的实现方法,并分析了该方法的特点,最后给出了在车身设计中应用的实例。