Aerodynamic Design Method of Integrated Aircraft with Submerged Intake Devices and Power Plant Included into Airframe Carrying System

This paper presents a theoretically and practically grounded architecture of design methods combination. A possibility and completeness of developing integral design solutions and intensifying the design process are provided by redistribution of emphases of numerical and natural experiments.     

The Electric Antennas for the STEREO/WAVES Experiment

The STEREO/WAVES experiment is designed to measure the electric component of radio emission from interplanetary radio bursts and in situ plasma waves and fluctuations in the solar wind. Interplanetary radio bursts are generated from electron beams at interplanetary shocks and solar flares and are observed from near the Sun to 1 AU, corresponding to frequencies of approximately 16 MHz to 10 kHz. In situ plasma waves occur in a range of wavelengths larger than the Debye length in the solar wind plasma λ _D ≈10 m and appear Doppler-shifted into the frequency regime down to a fraction of a Hertz. These phenomena are measured by STEREO/WAVES with a set of three orthogonal electric monopole antennas. This paper describes the electrical and mechanical design of the antenna system and discusses efforts to model the antenna pattern and response and methods for in-flight calibration.     

Notes on SCPC-FM System Design and Performance

In many domestic satellite communication systems single-channel per-carrier FM (SCPC-FM) has become the accepted transmission method for thin route communication. The SCPC-FM modem operates over a wide range of carrier frequencies and is designed to use satellite power and bandwidth efficiently. It incorporates elements which make the signal transfer complex, so the system behavior is not immediately obvious. This article investigates the signal processes and analyzes the performance of a companded and preemphasized SCPC-FM system and it furnishes insight into the choice of crucial system parameters.     

Automated air defense system using knowledge-based system

The proposed KAAD (knowledge-based automated air defense) system demonstrates a man-machine environment for airspace defense systems. When the unknown aircraft is hostile, a threat rating and response methods are generated by the system. It serves as a double-check decision-making system for a war control center. In addition to this application, the KAAD system can also be a useful tool as a training program for the war controller. The capabilities of the system are limited due to the shortage of knowledge resources. It requires communications among war controllers and air fighter pilots to organize a practical knowledge base. It is shown that the KAAD system can be combined with an automated ATC (air traffic control) system to become a practical system for air defense applications     

Optimum gain control for A/D conversion using digitized I/Q data inquadrature sampling

Calculation of optimum gain for minimum distortion due to A/D (analog-to-digital) conversion requires the estimation of the input signal strength. To use a common AGC (automatic gain control) for both the I/Q (in-phase and quadrature) signals, it is efficient to estimate the input signal strength using the quantized A/D output from both channels. Assuming a Gaussian input, the relationship between σ of the input of the A/D converter and E(|x|+|y|) and E(max(|x|,|y|)+1/2 min (|x|,|y|)) for t quantized I/Q output x and y is derived. Numerical results obtained using the derived expression and the statistical data obtained through simulation show excellent agreement. It is concluded that, because of its simplicity, the cubic equation obtained by fitting the numerical results should be useful     

Identifications of some highly-ionized iron and nickel lines in the 200–400 Å region of the solar spectrum

A number of previously unclassified multiplets of Fexiv, xiii, xii, and xi produced by transitions of the type 3s ²3p ⁿ -3s3p ⁿ⁺¹ are identified in the XUV spectrum of the Sun. The iron lines account for most of the previously unidentified strong lines between 330 and 370 Å. Solar observations of especial value for the investigation of the 300–400 Å region were the slitless spectroheliograms of September 22, 1968 (Purcell and Tousey, 1969) and November 4, 1969 (Tousey, 1971) — on which the image of a flare was recorded. Other solar identifications in the same spectral region include the resonance lines of Nixvii and Nixviii, and one 3p-3d multiplet of Fexiii. The solar blend at 417 Å involving the Fexv inter-combination line and Sxiv is resolved.     

The astrophysical interest of EUV observations of extra-solar objects

The feasibility of observation of EUV sources is assessed. Many stars have been detected in the EUV range ( 100–1000); line fluxes from others can be predicted. Selected astrophysical problems are reviewed that can benefit from EUV spectroscopy. Included among them are the physics and dynamics of stellar coronae, confirmation of nuclear surface burning on cataclysmic variables, evolutionary properties of white dwarfs, the helium abundance in the interstellar medium, and spectroscopic signatures of neutrino oscillations.Proceedings of the Conference Solar Physics from Space, held at the Swiss Federal Institute of Technology Zurich (ETHZ), 11–14 November 1980.     

Optical observations of the X-ray source 2S0921-630

We report photometric observations of the optical counterpart of the X-ray source 2S0921-630. The data, obtained at the South African Astronomical Observatory during 3 weeks in 1980 and 1981, are consistent with a 17.9 day periodic modulation of the flux in the B band. Correlated variability of the (B-V) and (U-B) colour indices with the B mag. is demonstrated and quantified. The observed B mag. and colours at maximum and minimum light are used to compute some of the system parameters. A model of 2S0921-630 is proposed in terms of a binary system in which the variable inclination of a luminous accretion disc produces the long-term modulation of the optical flux.     

Orbital and Attitude Prediction Accuracy Requirements for Satellites

This paper examines the criteria for selecting the orbital and attitude prediction accuracy requirements for communications satellites. The accuracy requirements have been analyzed in terms of the various space operations involved, e.g., satellite acquisition, guidance and control, communications, telemetry, and command. It is hoped that the findings of this investigation will prove useful in satellite mission planning and design, thereby facilitating a judicious choice of the various satellite and ground components of the related subsystems.     

Current Injected Equivalent Circuit Approach to Modeling Switching DC-DC Converters

A new current injected equivalent circuit approach (CIECA) to modeling switching dc-dc converter power stages is developed, which starts with the current injected approach and results in either a set of equations which completely describe input and out-put properties or an equivalent linear circuit model valid at small signal, low frequency levels. This approach to modeling switching dc-dc converter power stages has the merits but not the demerits of both the electronic equivalent circuit state space average approach and the current injected control type approach, namely, 1) the modeling is very clear and is simple whether the converter operates in continuous or discontinuous inductor conduction modes, 2) the modeling results in an equivalent circuit which is very close to the actual converter, and 3) the equivalent circuit can be used directly in the computer for theoretical predictions like SPICE, etc.