Diurnal and seasonal variations in long-term changes in the E-layer critical frequency

Long-term changes in the E-layer critical frequency, foE, at three stations of the European region (Juliusruh, Slough and Rome) and also at Moscow and Wakkanai stations are analyzed by the method developed by the authors and described in detail in the previous papers. It is found that Juliusruh and Slough stations demonstrate a well-pronounced change in foE (a trend) during two previous decades. At the same time, the same features of the behavior of the aforementioned trend k(foE) are obtained. The trend is positive and negative in the morning and evening hours, respectively. Similar diurnal behavior of k(foE) is found also for Moscow station but with lower absolute values of the trends. A well-pronounced seasonal behavior of k(foE) is detected at Juliusruh and Slough: the trend is minimal and maximal in the summer period and at the end of fall—beginning of winter, respectively. The maximal amplitude in the morning hours reaches +0.04?MHz per year, whereas the minimal amplitude in evening hours is ?0.06?MHz per year. No systematic changes exceeding by the magnitude 0.01?MHz per year are found for Rome and Wakkanai stations. It is assumed that the observed trends are related to changes (trends) in the meridional wind bringing NO molecules from the auroral oval to lower latitudes.     

Evaluation and improvement of coastal GNSS reflectometry sea level variations from existing GNSS stations in Taiwan

Global sea level rise due to an increasingly warmer climate has begun to induce hazards, adversely affecting the lives and properties of people residing in low-lying coastal regions and islands. Therefore, it is important to monitor and understand variations in coastal sea level covering offshore regions. Signal-to-noise ratio (SNR) data of Global Navigation Satellite System (GNSS) have been successfully used to robustly derive sea level heights (SLHs). In Taiwan, there are a number of continuously operating GNSS stations, not originally installed for sea level monitoring. They were established in harbors or near coastal regions for monitoring land motion. This study utilizes existing SNR data from three GNSS stations (Kaohsiung, Suao, and TaiCOAST) in Taiwan to compute SLHs with two methods, namely, Lomb–Scargle Periodogram (LSP)-only, and LSP aided with tidal harmonic analysis developed in this study. The results of both methods are compared with co-located or nearby tide gauge records. Due to the poor quality of SNR data, the worst accuracy of SLHs derived from traditional LSP-only method exceeds 1?m at the TaiCOAST station. With our procedure, the standard deviations (STDs) of difference between GNSS-derived SLHs and tide gauge records in Kaohsiung and Suao stations decreased to 10?cm and the results show excellent agreement with tide gauge derived relative sea level records, with STD of differences of 7?cm and correlation coefficient of 0.96. In addition, the absolute GNSS-R sea level trend in Kaohsiung during 2006–2011 agrees well with that derived from satellite altimetry. We conclude that the coastal GNSS stations in Taiwan have the potential of monitoring absolute coastal sea level change accurately when our proposed methodology is used.     

Experimental drop tube of the metallurgy department of Grenoble

The drop tube which will be available in the “Centre d'Etudes Nucléaires de Grenoble” is described. Its main features are the following: - Dimensions : Drop height : 47.1 m Drop time : 3.1 s Tube inside diameter : 0.2 m - Experimental atmosphere : 1 Ultra-vacuum : 10⁻⁶ to 10⁻⁷ Pa - Residual gravity level : 10⁻⁸ to 10⁻⁹ g according to the vacuum level and drop diameter.

This facility is unique insofar as it enables experiments to be performed under ultra-vacuum conditions which, by delaying the formation of surface oxides, should contribute to improving maximum undercooling values.

The techniques used for obtaining small metallic drops (0.5 to 3 mm) are described. The availability of this instrument for the scientific community is also foreseen by the french sponsoring organizations (CEA, CNES, CNRS) ; some practicle informations will be given to potential experimenters.     

Computational fluid dynamics and material processing (buoyancy and thermocapillary convections in melts during directional crystallization)

Modelisation and solution of heat and mass transfer problems relevant for material processing are generally hard to be handled, as they often involve 3D unsteady flows, viscous mixtures, phase changes, moving liquid-solid fronts, deforming liquid-gas interfaces, etc.… For space applications, material processing benefits of reduced buoyancy convection but can be faced to a strongly increased complexity due to variable g, mainly in manned flight.

Computational techniques used to analyse fluid motions in material processing, accounting for free surface, crystallization front and bulk convection in melt, are reviewed with emphasis to directional crystallization. Hydrodynamics stability and bifurcation analysis are shown to be useful complementary tools for correlating data, and for a better understanding of the physical laws. This last point will be illustrated in the case of the onset of oscillations in metallic melts.     

Convective motions in liquid metals for material processings. Numerical simulation of oscillation regimes and effect of rotation

The paper is concerned with the numerical simulation and the analysis of some kinds of flow regimes which can develop in Bridgman and Czochralski systems for material processings. The flows in the liquid phase are investigated considering two-dimensional and axisymmetric models. The time-dependent regimes were studied for a zero-Prandtl-number fluid layer confined inside a two-dimensional cavity of aspect ratio (length-to-height) A=4, involving a stress-free upper surface and submitted to a horizontal temperature gradient. The range of Grashof number was varied up to the conditions at which the flow goes from oscillatory to chaotic type behaviours. The combined influence of the temperature gradients and of the rotations of the crucible and of the seed/crystal was investigated for a Czochralski model. The axisymmetric regimes were studied for a Pr_m=0.015 liquid melt confined inside a cylindrical crucible of aspect ratio (height-to-radius) A_m=2, and coupled to a viscous encapsulant liquid layer (10<Pr_e<1200) of aspect ratio A_e=0.5. A number of steady and (transient) time-dependent flow patterns are identified.     

Earth and Mars observation using periodic orbits

This paper reports the results of a general study carried out on the Periodic Multi-SunSynchronous Orbits (PMSSOs), which the classical Periodic SunSynchronous Orbits (PSSOs) represent a specific solution of. Such orbits allow to obtain cycles of observation of the same region in which the solar illumination regularly varies according to the value of the orbit elements and comes back to the initial condition after a time interval which is multiple of the revisit time. Therefore this kind of orbits meets all the remote sensing applications that need observations of the same area at different local times (for example the reconstruction of the day-nighttime trend of the surface temperature of the planet) and it is particularly suitable to the study of several terrestrial and martian phenomena (diurnal cycle of the hazes and clouds, dynamics of the thermal tides, density variations, meteorology phenomena, etc.). The design of PMSSO is based on the variation of the Right Ascension of the Ascending Node due to the Earth oblateness (referred as basic solution). However, with respect to the basic solution, the analysis of the perturbative effects has demonstrated the need, especially in the case of Mars, to take into account all the superior harmonics of the gravitational field. To this end a corrective factor, to add to the basic equations, has been proposed, allowing a significant saving of propellant (of the order of 2 km/s per year). Besides, single and multi-plane satellite constellations have been taken into account in order to improve the repetition of observation and the ground spatial resolution.     

Alfvn Waves in the Solar Wind

Alfvn waves are found to be ubiquitous in the solar wind.Recent progress in observational studies of the waves is reviewed to formulate a microscopic picture for the Alfvenic fluctuations. The main aspects of the observational properties of these waves,including the wave intervals, propagation,evolution,origin and generation,are presented.Then Alfven wave heating and acceleration of the solar wind plasma are briefly introduced.The relation of the waves to rotational and tangential discontinuities,magnetic decreases,and other relatively large-scale structures such as flux tubes/ropes,magnetic clouds and interplanetary coronal mass ejections in the solar wind is particularly investigated.Finally,some remaining open questions are also indicated due to their fundamental importance of understanding of the physical nature of Alfven waves and the role of the waves in heating and accelerating the solar wind.     

Al-Li合金搅拌摩擦焊搭接接头的疲劳性能

通过疲劳寿命试验、疲劳断口和金相组织分析,研究了Al-Li合金搅拌摩擦焊搭接接头的疲劳性能,分析了接头前进侧热机影响区(TMAZ, Thermal-Mechanically Affected Zone)出现的"钩状缺陷"对其疲劳性能的影响.结果表明,钩状缺陷容易引起裂纹萌生及扩展,减小接头的有效承载板厚,适当缩短搅拌针长度可以改善钩状缺陷,提高接头力学性能.母材与搭接接头的疲劳S-N曲线研究表明:在高疲劳应力下,接头的疲劳寿命接近母材,但随着疲劳应力水平降低,接头的疲劳寿命急剧下降,200万循环周次下的疲劳强度仅达到80 MPa,为母材的35%.     

Antideuteron based dark matter search with GAPS: Current progress and future prospects

The General Antiparticle Spectrometer (GAPS) is a new approach to the indirect detection of dark matter. It relies on searching for primary antideuterons produced in the annihilation of dark matter in the galactic halo. Low energy antideuterons produced through Standard Model processes, such as collisions of cosmic-rays with interstellar baryons, are greatly suppressed compared to primary antideuterons. Thus a low energy antideuteron search provides a clean signature of dark matter. In GAPS antiparticles are slowed down and captured in target atoms. The resultant exotic atom deexcites with the emission of X-rays and annihilation pions, protons and other particles. A tracking geometry allows for the detection of the X-rays and particles, providing a unique signature to identify the mass of the antiparticle. A prototype detector was successfully tested at the KEK accelerator in 2005, and a prototype GAPS balloon flight is scheduled for 2011. This will be followed by a full scale experiment on a long duration balloon from Antarctica in 2014. We discuss the status and future plans for GAPS.