Ray Based Diffraction Tomography of the Ionosphere and Laboratory Inhomogeneous Plasma

A new procedure for restoration of the plasma inhomogeneities with improved resolution is suggested. The procedure deals with the double weighted Fourier transform (DWFT) of the observed wavefield in coordinates of both receivers = (x, y) and sources ₀ = (x ₀, y ₀) [1]. Phase increments between the sources and receivers, being found from DWFT representation, can be used for extracting information on small perturbations of the dielectric constant ~(, z) in a way similar to traditional radio tomography. The resulting resolution of the method is close to the diffraction limit = h/D in the horizontal direction and z = (h/D)² in the vertical direction, where h is the height of inhomogeneities and D is the length of the ground-based receiving system.     

固体发动机喷管延伸锥展开前级间分离的热环境分析

通过FLUENT流场计算软件,采用RNGK k-ε湍流模型,针对带有延伸喷管的多级固体发动机级间热分离的热环境进行了数值分析。研究表明,延伸喷管尾流受到连接筒、前封头、延伸段的阻碍后,其流动特征变化显著,尤其在一级前封头的影响下形成回流,并在喷管内形成激波。计算得到的热环境参数,对发动机的热防护设计具有一定的参考价值。     

化学气相反应法在C/C复合材料抗氧化处理中的应用

通过把硅蒸气渗入预制体孔隙与碳直接反应生成SiC的化学气相反应(CVR)方法,提高初始密度和预制体结构均不同的C／C复合材料的抗氧化能力,研究了C／C复合材料的密度变化与微观结构,并对其进行了氧化试验。结果表明,因CVR温度、C／C复合材料初始密度不同,抗氧化处理后的密度增加量有显著不同。针刺炭布C／C／SiC复合材料在马福炉中于1160℃经65min氧化后,其失重率仅2．6％,而密度为1．95g／cm^3的同结构C／C复合材料相在同条件下失重率高达32％。     

Odyssey: Principles for enduring space exploration

As the USA, Europe and other nations embark on a new voyage of exploration to the Moon, Mars and beyond, they should lay the foundations and establish precedents that invite a host of participants and followers. We argue that international cooperation, driven by foreign-policy and cost-sharing considerations, has taken a prominent role but must be pragmatically and flexibly balanced with economic and strategic self-interest. Since exploration visions are likely to differ, the steps each country will pursue, the funding provided, and schedules followed will also differ. To support an enduring exploration vision, it will be important to remain flexible to changing priorities and amenable to the inclusion of new, non-traditional participants. Open-systems principles and metaprinciples should be employed at all levels—hardware, software, programmatic, political and cultural. Equally important, national leadership and decision makers should be mindful of the potential pitfalls that might undermine the venture. While the new vision inspires us all, it will take creativity, resourcefulness, hard work and cooperation to succeed.     

Three dimensional temperature field in a conducting sphere due to an arbitrarily located split ring heating source

Thermal control of spacecrafts plays an important role in space missions. In the design stage the preliminary thermal analysis of the spacecraft requires an estimate of the conductive thermal resistance between the various spacecraft components. With this in mind, the fully three dimensional problem of determining the thermal field in a conducting sphere with an asymmetric split ring current carrying heating source is resolved in an analytical or almost analytical form, implying either a closed form solution or utmost expressions involving a simple numerical integration. This has immediate application for evaluation of thermal resistance in spacecrafts. Green's function integral techniques are used. Comparisons are made with series solutions and also with purely numerical solutions to contrast the simplicity and highlight the elegance of the present method. Parametric studies reveal expected behavior.     

Behavior of tethered debris with flexible appendages

Active exploration of the space leads to growth of a near-Earth space pollution. The frequency of the registered collisions of space debris with functional satellites highly increased during last 10 years. As a rule a large space debris can be observed from the Earth and catalogued, then it is possible to avoid collision with the active spacecraft. However every large debris is a potential source of a numerous small debris particles. To reduce debris population in the near Earth space the large debris should be removed from working orbits. The active debris removal technique is considered that intend to use a tethered orbital transfer vehicle, or a space tug attached by a tether to the space debris. This paper focuses on the dynamics of the space debris with flexible appendages. Mathematical model of the system is derived using the Lagrange formalism. Several numerical examples are presented to illustrate the mutual influence of the oscillations of flexible appendages and the oscillations of a tether. It is shown that flexible appendages can have a significant influence on the attitude motion of the space debris and the safety of the transportation process.     

Neutral surfaces of coronal magnetic field and solar filaments

The shape of solar filaments is compared with the projection of parts of the neutral surface of the coronal magnetic field within a certain range of heights at different aspects of observation due to the rotation of the Sun. Neutral surfaces are calculated in the potential approximation from the photospheric data. The comparison shows that the material of filaments is concentrated mainly near the neutral surface of the potential field. The traces of the neutral surface section by the horizontal plane serve as polarity inversion lines (PILs) of the vertical field at the given height. In projection onto the disk, a lower edge of the filament with the intermediate barbs protruding on each side is delineated by the PIL at the low height, while an upper edge touches the high-height PIL. All material of the filament is enclosed in the space between these two lines. Although in reality the magnetic field structure near filaments differs very strongly from the potential field structure, their neutral surfaces can be similar and close, especially at low heights. This fact is probably the cause of the observed correlation. It can be used to determine the height of the upper edge of filaments above the photosphere in the case of observations only on the disk.     

Technology readiness assessments: A retrospective

The development of new system capabilities typically depends upon the prior success of advanced technology research and development efforts. These systems developments inevitably face the three major challenges of any project: performance, schedule and budget. Done well, advanced technology programs can substantially reduce the uncertainty in all three of these dimensions of project management. Done poorly, or not at all, and new system developments suffer from cost overruns, schedule delays and the steady erosion of initial performance objectives. It is often critical for senior management to be able to determine which of these two paths is more likely—and to respond accordingly. The challenge for system and technology managers is to be able to make clear, well-documented assessments of technology readiness and risks, and to do so at key points in the life cycle of the program.In the mid 1970s, the National Aeronautics and Space Administration (NASA) introduced the concept of “technology readiness levels” (TRLs) as a discipline-independent, programmatic figure of merit (FOM) to allow more effective assessment of, and communication regarding the maturity of new technologies. In 1995, the TRL scale was further strengthened by the articulation of the first definitions of each level, along with examples (J. Mankins, Technology readiness levels, A White Paper, NASA, Washington, DC, 1995. [1]). Since then, TRLs have been embraced by the U.S. Congress’ General Accountability Office (GAO), adopted by the U.S. Department of Defense (DOD), and are being considered for use by numerous other organizations. Overall, the TRLs have proved to be highly effective in communicating the status of new technologies among sometimes diverse organizations.This paper will review the concept of “technology readiness assessments”, and provide a retrospective on the history of “TRLs” during the past 30 years. The paper will conclude with observations concerning prospective future directions for the important discipline of technology readiness assessments.     

Long-term variations of fluxes of solar protons and helium isotopes

The fluxes of hydrogen and helium isotopes in the solar wind are reconstructed over a long time scale since the present time up to 600 million years back. Abundances of helium isotopes, obtained in the helium isotopic analysis made for 8 lunar soil samples, were used as initial data in the reconstruction procedure. Samples were taken off from various levels of the 1.6-m core of lunar soil delivered by the automatic Luna-24 station in 1976. The data on modern hydrogen and helium fluxes were used as well. The developed reconstruction procedure allowed one to select various solar wind components in a ??gross?? composition. Proton flux variations over the interval of 600 million years do not exceed a value of 40 %. Helium flux variations reach a value of 1.5?C2 relative to the average value. Most likely, this circumstance is caused by considerable variations of a number of coronal mass ejections (CME) enriched by helium. The arguments in favor of solar activity polycyclicity on a long time scale are discussed.