High Dynamic GPS Receiver Using Maximum Likelihood Estimationand Frequency Tracking

A new high dynamic global positioning system (GPS) receiver ispresented and its performance characterized by analysis,simulation, and demonstration. The demonstration receiver is abreadboard model capable of tracking a single simulated satellitesignal in pseudorange and range rate. Pseudorange and range rateestimates are made once every 20 ms, using a maximum likelihoodestimator, and are tracked by means of a third-order fadingmemory filter in a feedback configuration. The receiver trackspseudorange with rms errors of under 1 m when subjected tosimulated 50 g, 40 g/s circular trajectories. The tracking thresholdis approximately 28 dB·Hz, which provides 12 dB margin relativethe the minimum specified signal strength, assuming 3.5 dB systemnoise figure and 0 dB antenna gain.     

Century scale solar variability imprinted in the 44Ti activity in meteorites.

The measurements of gamma-activity of the 44Ti (T1/2 = 66.6 years) produced by spallation reaction of galactic cosmic rays (GCR) in Alfianello, Olivenza, Rio Negro, Dhajala and Torino meteorites, which fell in the time interval 1883 AD (Alfianello)-1988 AD (Torino), show a century scale modulation, connected to long-term solar-wind flux variations in the interplanetary space. The variation of the 44Ti activity with the time of fall of meteorites is qualitatively consistent with the Gleissberg solar cycle, but the amplitude is three-four times higher than expected (about 5%) for GCR flux modulated by solar activity, as determined solely by the sunspot number. The cosmogenic 44Ti is a suitable radioisotope for this investigation, but its activity in meteorites is very low. We performed these measurements in the underground low level counting station of Monte dei Cappuccini in Torino, by means of a big hyperpure Ge crystal (approximately 2 kg) in selective coincidence with a heavy NaI (T1) scintillation detector (approximately 28 kg). This system allows a reliable and non destructive measurement of 44Ti (44Sc) in meteorites of 200-1200 g in weight. The background is about 1 count per day in the gamma-peak at 1157 keV of 44Sc in equilibrium with its parent 44Ti. The high stability of the performance allows long-lasting runs (approximately 10(7) s) in order to attain results with a standard deviation up to about 10%.     

New instrumentation for optical measuring of oxygen in gas or dissolved in liquids.

The optical oxygen sensor is a novel device for the determination of oxygen in gases or dissolved in liquids. It is based on the measurement principle of fluorescence quenching, which is completely different from that of polarographic oxygen sensors (today the most widespread devices of oxygen detection). The new instrument offers features and advantages, which render it not only a realistic alternative, but, for specific applications, make it superior to existing electrochemical methods. The system is based on low-cost semiconductor devices (light-emitting diodes, photodiodes, low-cost analogue and digital components) and new LED-compatible oxygen-sensitive membranes. The flow cell of the instrument may be thermostatted and the sensor can be calibrated by a simple two-point calibration procedure. The optical oxygen sensor is particularly suitable for measuring dissolved oxygen in respirometry, since no oxygen is consumed by the device and the signal is independent of sample flowrate or stirring speed. Typical fields of application are monitoring of oxygen in ground and drinking water, in process control in bioreactors and in breath gas and blood gas analysis.     

Aiming at a 1-cm Orbit for Low Earth Orbiters: Reduced-Dynamic and Kinematic Precise Orbit Determination

The computation of high-accuracy orbits is a prerequisite for the success of Low Earth Orbiter (LEO) missions such as CHAMP, GRACE and GOCE. The mission objectives of these satellites cannot be reached without computing orbits with an accuracy at the few cm level. Such a level of accuracy might be achieved with the techniques of reduced-dynamic and kinematic precise orbit determination (POD) assuming continuous Satellite-to-Satellite Tracking (SST) by the Global Positioning System (GPS). Both techniques have reached a high level of maturity and have been successfully applied to missions in the past, for example to TOPEX/POSEIDON (T/P), leading to (sub-)decimeter orbit accuracy. New LEO gravity missions are (to be) equipped with advanced GPS receivers promising to provide very high quality SST observations thereby opening the possibility for computing cm-level accuracy orbits. The computation of orbits at this accuracy level does not only require high-quality GPS receivers, but also advanced and demanding observation preprocessing and correction algorithms. Moreover, sophisticated parameter estimation schemes need to be adapted and extended to allow the computation of such orbits. Finally, reliable methods need to be employed for assessing the orbit quality and providing feedback to the different processing steps in the orbit computation process. This revised version was published online in August 2006 with corrections to the Cover Date.     

Role of BIT in support system maintenance and availability

The role of built in test (BIT) in electronic systems has grown in prominence with the advances in system complexity and concern over maintenance lifecycle costs of large systems. In an environment where standards drive system designs (and provide an avenue for focused advancement in technology), standards for BIT are very much in an evolutionary state. The reasons for advancing the effectiveness of BIT include reduced support overhead, greater, confidence in operation, and increased system availability. The cost of supporting military electronic systems (avionics, communications, and weapons systems) has driven much of the development in BIT technology. But what about the systems that support these end items that contain test and measurement instrumentation - such as automatic test equipment (ATE), simulators and avionics development suites? There has also been a beneficial effect on the maintenance and availability of these systems due to the infusion of BIT into their component assemblies. But the effect has been much more sporadic and fragmented. This paper looks at the state of BIT in test and measurement instruments, explain its affect on system readiness, and present ideas on how to improve BIT technologies and standards. This will not provide definitive answers to BIT development questions, since the factors that affect it are specific to the instrument itself. The topics covered in this paper are: definitions of built-in test, instrument BIT history, importance of BIT fault coverage and isolation in support systems, overview of BIT development process issues that limit the effectiveness of BIT Standards related to instrument BIT, making BIT more effective in support system maintenance and availability and conclusions.     

Chromosome instability of HPRT-mutant subclones induced by ionising radiation of various LET.

The induction of HPRT-mutations and survival of Chinese hamster cells (line B11ii-FAF28, clone 431) were studied after irradiation by 4He and 12C-ions of various LET (20-360 keV/micrometers), produced by the U-200 heavy ion accelerator. The RBE increases with LET up to the maximum at 100-200 keV/micrometers and then decreases. Cytogenetic analysis was performed on the HPRT-mutant subclones selected from unirradiated Chinese hamster V-79 cells and from HPRT-mutant subclones that arose after exposure to gamma-rays, 1 GeV protons and 14N-ions (LET-77 keV/micrometers), produced by the synchrophasotron and the U-400M heavy ion accelerator. Slow growing mutant subclones were observed. The cytogenetic properties of individual clones were highly heterogeneous and chromosome instability was observed in both spontaneous and radiation-induced mutants. Chromosome instability was highest among spontaneous mutants and decreased with increasing LET.     

Design of the TRIO system-on-chip for aerospace

Several design and testing aspects of the TRIO smart sensor data acquisition chip, developed by JHU/APL for NASA spacecraft applications are presented. TRIO includes a 10 bit self-corrected analog-to-digital converter (ADC), 16/32 analog inputs, a front end multiplexer with selectable aquisition time, a current source, memory, serial and parallel bus, and control logic. So far TRIO is used in many missions including Contour, Messenger, Stereo, Pluto, and the generic JPL X2000 spacecraft bus.     

Optimal multiple level decision fusion with distributed sensors

A data fusion model consisting of several levels of parallel decision fusions is considered. Global optimization of such a model is discussed to obtain the fusion rules for overall optimal performance. The reliability analysis of the proposed model is carried out to establish its superiority over the existing parallel and serial fusion models     

Distributed flight control system using fiber distributed datainterface (FDDI)

The design of fault-tolerant distributed control systems is discussed. The application described is a generic flight control system (FCS) for a fighter aircraft. The system is designed for high redundancy and expandability to meet various requirements. The communication network is based on the fiber distributed data interface (FDDI), which provides a high level of electromagnetic interference resistance and reliability. The choice of fiber optic media also provides an extremely high bandwidth and tremendous growth capability for future communications needs. This study is not specific to FDDI or flight control systems. The methods and configurations presented should be applicable to many real-time control implementations