基于STFRFT的LFM引信抗欺骗干扰方法

针对线性调频脉冲压缩引信易受转发式假目标欺骗干扰问题,提出了基于短时分数阶傅立叶变换(STFRFT)的抗欺骗干扰方法。首先,通过分数阶傅立叶变换将回波信号与欺骗干扰各分量信号进行分离;再利用相同调频率的LFM信号经短时分数阶傅立叶变换后最大幅值与窗函数宽度成线性关系,而不同调频率的最大幅值不随窗函数宽度变化的特点,有效分辨假目标欺骗干扰,正确检测目标回波信号;最后,通过仿真证明了方法的正确性,并验证所提方法具有良好的抗欺骗干扰效果。     

高压质子交换膜水电解技术研究

介绍了国内外质子交换膜水电解技术的研究进展,讨论了阳极催化剂材料、膜厚度、电流密度对膜电极电化学性能的影响,利用高压水电解制氧测试平台分析了高压大功率质子交换膜水电解器的工作性能和长期运行稳定性的影响。结果表明,以Ir O2复合金属氧化物催化剂的膜电极,在80℃和1.0 A/cm2的条件下,电解单槽电压不大于1.75 V,水电解器氧气输出压力达到5 MPa,最大产氧量为3.6 Nm3/h,氧气纯度不小于99.5%,研制的水电解器具备在高压、大电流密度下稳定工作的能力。     

氦气驱动预压涡轮泵启动初期反流问题分析

用于某液体火箭发动启动动系统的气驱预压涡轮泵在起动初期出现了气体反流,导致预压泵呈夹气状态,对发动启动动过程控制不利。根据驱动试验系统原理,在MWorks平台中对驱动过程进行了仿真。对预压泵采用了Suter全特性表达式,对涡轮管路及排放路分别建立了描述排空与两相流动过程的简化数学模型。结果 表明,导致反流的原因为涡轮入...     

一种弱场区无线传输系统

在铁路无线列调通信中存在弱场区和盲区,通信质量难以控制。设计了完整的方案,提高了原无线列调中存在的弱场区的场强,并增大场强覆盖率,使通话距离得到扩展,改善了话音质量。     

捷联式制导系统中四元数的保范递推计算

推导了捷联式制导系统中四元数的保持范数不变的递推计算公式,并对公式的误差传递进行分析,证明其计算误差随迭代次数线性增长.     

洗出滤波算法在飞行模拟器中的应用

介绍了六自由度运动平台的洗出滤波算法及其在飞行器地面滑跑阶段的实现。根据飞行仿真模块的输出,通过坐标变换、比例限制、信号洗出和滤波等,形成运动平台的驱动信号。该算法在不增加系统硬件的前提下,充分利用液压缸现有行程,逼真地模拟飞机俯仰、滚转、偏航、升降、纵向和侧向平移运动。     

预处理实时数字仿真方法

本文对半实物数字仿真的数学模型提出了一种预处理实时数字仿真方法。在保持原模型精度的基础上,该方法将在每帧内的数字仿真时间由作四次右函数计算的时间减少到作一次计算的时间。本文阐明了推导这种方法的思路、步骤,给出了误差估计并指出了这种方法计算的复杂性。     

外差式侦察接收机对频率捷变信号进行侦察的可行性

根据频率捷变信号的特点,分析了几种侦察体制下接收频率捷变信号需要的中频带宽、扫描步进频宽和截获时间,给出了对频率捷变信号侦察的可行性方案。     

机床主轴加工工艺教学案例分析——以CA6140车床主轴机械加工为例

针对<机械制造工艺基础>课程中实验内容较少的实际情况,在教学过程中,应该提倡增加实践教学环节,提高学生的实际动手能力,本文以CA6140机床主轴加工工艺为例,详细说明加工路线的制定、定位基准的选择及CA6140机床主轴的加工工艺过程的制定,使学生熟悉制订工艺过程的原则,步骤和方法,培养合理确定工艺过程的技能.     

Recurrent isolation of hydrogen peroxide-resistant spores of Bacillus pumilus from a spacecraft assembly facility

While the microbial diversity of a spacecraft assembly facility at the Jet Propulsion Laboratory (Pasadena, CA) was being monitored, H2O2-resistant bacterial strains were repeatedly isolated from various surface locations. H2O2 is a possible sterilant for spacecraft hardware because it is a low-temperature process and compatible with various modern-day spacecraft materials, electronics, and components. Both conventional biochemical testing and molecular analyses identified these strains as Bacillus pumilus. This Bacillus species was found in both unclassified (entrance floors, anteroom, and air-lock) and classified (floors, cabinet tops, and air) locations. Both vegetative cells and spores of several B. pumilus isolates were exposed to 5% liquid H2O2 for 60 min. Spores of each strain exhibited higher resistance than their respective vegetative cells to liquid H2O2. Results indicate that the H2O2 resistance observed in both vegetative cells and spores is strain-specific, as certain B. pumilus strains were two to three times more resistant than a standard Bacillus subtilis dosimetry strain. An example of this trend was observed when the type strain of B. pumilus, ATCC 7061, proved sensitive, whereas several environmental strains exhibited varying degrees of resistance, to H2O2. Repeated isolation of H2O2-resistant strains of B. pumilus in a clean-room is a concern because their persistence might potentially compromise life-detection missions, which have very strict cleanliness and sterility requirements for spacecraft hardware.