Nature's efficient energy production, storage, and data processing

Converting the solar energy received on the surface of the Earth has not been practical with heat engines because of the low density of this energy. On a clear bright day in the summer, the sun generally delivers less than 80 W per square foot. Also, heat engines are prohibited from exceeding the Carnot-cycle efficiency limit. On the other hand, plants perform their energy conversion electrochemically, and, hence, are not limited by the Carnot-cycle. They use solar energy to produce useful fuels that range from corn-cobs and maple syrup to pitch and firewood. However, they have an extremely complicated process control that uses blue and red parts of the visible solar spectrum to extract hydrogen from water and carbon from carbon dioxide to make hydrocarbons. They do not need precious-metal catalysts; however they run complex data processing programs in which stored instructions control electrochemical reactions and also cause growth and production of needed products to occur when needed.     

PWM full-bridge converter with natural input power factor correction

A pulsewidth modulated (PWM) full-bridge converter that simultaneously performs input power factor correction (PFC) and DC-DC conversion is proposed. The converter is the same as the standard voltage-fed PWM full-bridge converter with a diode-bridge low-pass filter front end, but with a slight modification that results in an improvement in power factor that is sufficient to satisfy the EN61000-3-2 requirements for electrical equipment. The operation of the converter is explained and analyzed, and the results of the analysis are used to determine the converter's steady-state characteristics, which are discussed in detail. A design procedure for the selection of components is then derived and demonstrated with an example. The feasibility of the converter and its ability to satisfy EN61000-3-2 requirements on electrical equipment is shown with results obtained from an experimental prototype.     

Dynamic optimization of CELSS crop photosynthetic rate by computer-assisted feedback control.

A procedure for dynamic optimization of net photosynthetic rate (Pn) for crop production in Controlled Ecological Life-Support Systems (CELSS) was developed using leaf lettuce as a model crop. Canopy Pn was measured in real time and fed back for environmental control. Setpoints of photosynthetic photon flux (PPF) and CO2 concentration for each hour of the crop-growth cycle were decided by computer to reach a targeted Pn each day. Decision making was based on empirical mathematical models combined with rule sets developed from recent experimental data. Comparisons showed that dynamic control resulted in better yield per unit energy input to the growth system than did static control. With comparable productivity parameters and potential for significant energy savings, dynamic control strategies will contribute greatly to the sustainability of space-deployed CELSS.     

Novel sensor technology for monitoring and control of critical plant nutrient parameters.

A novel dielectric sensor technology has been developed for monitoring and control of plant nutrient delivery systems as part of NASA's Controlled Ecological Life Support System (CELSS) program. A unique measurement phenomenon was discovered in which the electrostatic field is shunted to a third terminal of the sensor, resulting in a much greater sensitivity to changes in the complex dielectric properties of the nutrient solution. Based on this phenomenon, a small, flexible, thin-film shunting dielectric sensor (SDS) was designed to provide low-frequency, non-invasive measurement of both the thickness and nutrient concentration of the layer of solution on a plant growth surface. Test results indicate a sensitivity of +/- 0.05mm in layer thickness while characterization of the ability to measure nutrient concentration continues. The development plan for this sensor is presented and other applications are discussed.     

Effects of RF absorbers on measurements of small antennas in smallanechoic chambers

In this work, the influence of resistive absorbers in the vicinity of small antennas was investigated, in order to define a lower limit for the size of a small anechoic chamber for antenna calibration and radiation pattern measurements, with respect to the distance between the antenna under test (AUT) and the RF absorbers lining the walls. Furthermore, the influence of a relatively narrow transmission channel, formed by the absorbers on the side walls between the measurement antenna and the AUT was investigated. It was found by measurements that absorbers with the length of 610 mm do not have a measurable effect on the radiation characteristics of a small antenna at around 1.8 GHz, as long as they are kept more than 100 mm from the AUT, and the transmission channel formed by the absorbers between the antennas is wider than 100 mm     

Observations of Magnetospheric Waves and their Relation to Precipitation

Magnetospheric wave observations are discussed from the viewpoint of their potential importance for precipitation of charged particles into the auroral zones. While wave processes are a fundamental part of magnetospheric plasma physics, occurring most of the time in most of the magnetospheric regions, their direct role in and relative importance for auroral precipitation are not easy to assess. The role of the waves varies from one spatial region to another and is very different for electrons and ions. Furthermore, the distinction between wave processes and other precipitation mechanisms is not at all straightforward. This review focuses on four main topics: The problem of diffuse electron precipitation, the recent surprise on the detailed structure of broad-banded electrostatic noise in the plasma sheet boundary layer, ion precipitation through electromagnetic ion cyclotron waves, and the role of low-altitude waves in precipitation. It is concluded that, while the observational status of high-altitude ion cyclotron waves is reasonably good, in most areas more thorough studies of existing data as well as refined observations are very much needed. Successful observational studies are to be carried out jointly with theoretical work as well as with studies on the large-scale context of the often localized wave processes. This is especially important when interests are moving toward more nonlinear phenomena, such as shocks, double layers, or strong quasi-static gradients, where a strict adherence to classical wave concepts is becoming more and more diffuse and less motivated.     

Radiation biodosimetry: applications for spaceflight.

The multiparametric dosimetry system that we are developing for medical radiological defense applications could be adapted for spaceflight environments. The system complements the internationally accepted personnel dosimeters and cytogenetic analysis of chromosome aberrations, considered the best means of documenting radiation doses for health records. Our system consists of a portable hematology analyzer, molecular biodosimetry using nucleic acid and antigen-based diagnostic equipment, and a dose assessment management software application. A dry-capillary tube reagent-based centrifuge blood cell counter (QBC Autoread Plus, Becton [correction of Beckon] Dickinson Bioscience) measures peripheral blood lymphocytes and monocytes, which could determine radiation dose based on the kinetics of blood cell depletion. Molecular biomarkers for ionizing radiation exposure (gene expression changes, blood proteins) can be measured in real time using such diagnostic detection technologies as miniaturized nucleic acid sequences and antigen-based biosensors, but they require validation of dose-dependent targets and development of optimized protocols and analysis systems. The Biodosimetry Assessment Tool, a software application, calculates radiation dose based on a patient's physical signs and symptoms and blood cell count analysis. It also annotates location of personnel dosimeters, displays a summary of a patient's dosimetric information to healthcare professionals, and archives the data for further use. These radiation assessment diagnostic technologies can have dual-use applications supporting general medical-related care.     

Development of a Digital Array Radar (DAR)

Twenty-first century littoral and open-sea missions present US Navy (USN) shipboard-radar systems with the challenge of detecting small targets in severe clutter and against multiple sources of interference. In Fiscal Year 2000 (FY00), the Office of Naval Research (ONR) sponsored a program to develop an active array radar that includes a digital beamforming (DBF) architecture. The DBF radar system has the potential for improved time-energy management, improved signal-to-clutter (S/C) ratios, improved reliability and reduced life-cycle costs. This paper summarizes the latest developments of the program during FY00