Comments on "Optimum Bandwidth of a Low-Pass Filter for Detection of a Pulse in Nonstationary Noise"

In a recent correspondence1 a calculation of the optimum bandwidth of a low-pass RC filter for the detection of a pulse signal in nonstationary noise was presented. The purpose of this correspondence is: 1) to point out additional references to the work which has been conducted in the stationary noise case, and 2) to present an interesting alternate derivation of the expected output noise power for the nonstationary noise case.     

Dissipation of temperature perturbations in the middle atmosphere

It is often observed that the stratospheric and mesospheric temperature structure undergoes transient disturbances from its averaged steady-state behavior. The causes may be traceable to gravity waves, planetary waves, solar proton and relativistic electron precipitation, etc. We examine the theoretical time behavior of the atmospheric temperature following the cessation of such heating phenomena as it relaxes toward its quiescent steady-state value. We also study the time-dependent response during a model stratospheric-warming/mesospheric-cooling event. In particular, we investigate the roles of eddy heat conduction, non-LTE cooling in the 15μm CO₂ band, and an ambient vertical wind, and their relative importance as they depend upon altitude and time, in modifying temperature changes in this region.     

Causes of aircraft electrical failures

The results of a survey of data on failures of aircraft electronic and electrical components that was conducted to identify problematic components are reported. The motivation for the work was to determine priorities for future work on the development of accident investigation techniques for aircraft electrical components. The primary source of data was the Airforce Mishap Database, which is maintained by the Directorate of Aerospace Safety at Norton Air Force Base. Published data from the Air Force Avionics Integrity Program (AVIP) and Hughes Aircraft were also reviewed. Statistical data from these three sources are presented. Two major conclusions are that problems with interconnections are major contributors to aircraft electrical equipment failures, and that environmental factors, especially corrosion, are significant contributors to connector problems     

Acousto-optic spectrum analyzer techniques for monitoring CW

The issues associated with processing the outputs of an integrating acoustooptical spectrum analyzer (AOSA) to detect and identify the frequency and power of continuous wave (CW) signals are considered. The performance of the optimum detection strategy is presented, along with the Cramer-Rao bound on the performance of estimators of the frequency, and the performance of a simple peak-based frequency estimator. The performance of the maximum likelihood (ML) estimator of the power level is also presented. The results provide the behavior of the system as a function of the product of the aperture time and photodetector spacing amongst other parameters     

Isotopic analysis of cometary organic matter

Carbon isotope ratios have been measured for CN in the coma of comet Halley and for several CHON particles emitted by Halley. Of these, only the CHON-particle data may be reasonably related to organic matter in the cometary nucleus, but the true range of ¹³C/¹²C values in those particles is quite uncertain. The D/H ratio in H₂O in the Halley coma resembles that in Titan/Uranus. The next decade should substantially improve our understanding of the distribution of C, H, N, and O isotopes in cometary organics. The isotopic composition of meteoritic organic matter is better understood and can serve as a useful analog for the cometary case.     

Advanced concepts for launch vehicle control

The objective of the advanced launch system (ALS) program is to develop a family of launch vehicles which provides a substantial improvement in reliability, operability, and economy over existing systems. This requires that autopilot design and verification procedures be of minimum sensitivity to recurring costs while providing adequate, but not necessarily optimal, vehicle performance. One approach to accomplishing this task, namely, the utilization of advanced control design and analysis techniques, is considered. It is shown that the techniques, which represent a cross-section of developments in control theory, attempt to solve the ALS control problem in one of two ways: given increased knowledge of the launch vehicle and its environment, through greater model fidelity and additional sensor data; and autopilot design in the presence of quantified model/disturbance uncertainties and less stringent sensing requirements. It is concluded that the methods are promising and cost effective     

An alternate algorithm for discrete-time filtering

The discrete-time Kalman filter is an optimal estimator for the states of a linear, stochastic system. It assumes that measurements are linear combinations of the states, and all disturbances are Gaussian. The influence diagram, a decision analysis tool that provides an algorithm for discrete-time filtering equivalent to the Kalman filter when the influence diagram represents Gaussian random variables, is discussed. The influence diagram algorithm is a factored form of the Kalman filter, similar to other factored forms such as the U-D filter. Compared with the Kalman filter, it offers improved numerical properties. Compared with other factored forms, it offers a reduced computational load     

Direct integration methods in dynamic problems of structural mechanics

A method of direct integration with respect to time is proposed to solve dynamic problems of structural mechanics and comparison with the well-known methods is presented.     

Residual stresses and endurance strength under tension-compression in the conditions of stress concentration

Residual stresses and endurance strength of specimens with stress concentrators are considered. The results obtained make it possible to predict the fatigue limit of strengthened parts with concentrators in the case of tension-compression.     

Statistical analysis of experimental study results on low-cycle fatigue resistance for the EI698-VD high-temperature alloy

The results of low-cycle fatigue tests of smooth cylindrical specimens made of the EI698-VD nickel-base high-temperature alloy widely used in aircraft engine industry are considered statistically. The influence of such factors as an initial level of mechanical properties, operating time and temperature of tests is evaluated. The experimental data on low-cycle fatigue (LCF) are used when determining the cyclic life for disks.