Extensions of the Discrete-Average Models for Converter Power Stages

An improved power converter model is developed by combining the average and discrete modeling techniques. The parameter determination of the proposed discrete-average model is shown to be dependent on the type of duty cycle control law and the nature of the error processor used in the feedback loop. Furthermore, the paper pinpoints deficiencies of the conventional loop gain measurement technique which is widely used in industries.     

An Upper Bound on Detection Probability for Fluctuating Signals

In the theory of signal detectability, the signal-to-noise ratio (SNR), defined as the quotient of the average received signal energy and the spectral density of the white Gaussian noise, is a fundamental parameter. For a signal which is exactly known, or known except for a random phase, this ratio uniquely defines the detection performance which can be achieved with a matched filter receiver. However, when the signal amplitude is a random parameter, the detection performance is changed and must be determined from the probability density function (pdf) of the amplitude. Relative to the case of a constant signal amplitude, such signal amplitude fluctuation usually degrades performance when a high probability of detection (Pd) is required, but improves performance at low values of Pd; the corresponding change in the required SNR is the so-called signal fluctuation loss Lf. Thus, since Lf in some cases represents an improvement in performance for low values of Pd, a question of at least theoretical interest is: how large might this improvement be, when the class of all signal amplitude pdf's is considered. The solution, presented here, results in a lower bound on the signal fluctuation loss Lf as a function of Pd, or equivalently an upper bound on Pd as a function of SNR. The corresponding most favorable pdf was determined using the Lagrange multiplier technique and results of a numerical maximization are included to provide insight into the general properties of the solution.     

Position and Velocity Estimation Via Bearing Observations

The problem of performing target motion analysis using noisy bearing measurements derived from multiple observation platforms or from a single moving observer is addressed. For the latter case, the properties of an estimator based on a Cartesian model of the process are detailed. Methods of providing estimates both before an observer maneuver, when the process is unobservable, and following an observer maneuver are developed. The results of an experimental study are presented.     

Ultraviolet spectrometer experiment for the Voyager mission

The Voyager Ultraviolet Spectrometer (UVS) is an objective grating spectrometer covering the wavelength range of 500–1700 Å with 10 Å resolution. Its primary goal is the determination of the composition and structure of the atmospheres of Jupiter, Saturn, Uranus and several of their satellites. The capability for two very different observational modes have been combined in a single instrument. Observations in the airglow mode measure radiation from the atmosphere due to resonant scattering of the solar flux or energetic particle bombardment, and the occultation mode provides measurements of the atmospheric extinction of solar or stellar radiation as the spacecraft enters the shadow zone behind the target. In addition to the primary goal of the solar system atmospheric measurements, the UVS is expected to make valuable contributions to stellar astronomy at wavelengths below 1000 Å.     

Design of the HEAO Main Bus Shunt Regulator

The High Energy Astronomy Observatory (HEAO) main bus regulator contains a redundant error amplifier (REA) and a 12-section sequenced shunt transconductance amplifier (STA) in which not more than three and not less than one shunt section are in an active control mode regardless of a failure in any one of the twelve sections. The part of the work concerned with the shaping of the frequency response of the REA and STA minor feedback loops and of the teolator major feedback loop is described. Emphasis is on the application of a general design technique embodying a "design-analyze-measure iteration loop," in which a first-cut design and analysis is corrected ard improved after experimental observation of discrepancies and deficiencies. In particular, an incipient high-frequency oscillation was thereby reliably eliminated. It is demonstrated that analysis techniques involving a minimum of algebra can provide full quantitative information on an efficient and reliable system design.     

Properties of Staggered PRF Radar Spectral Components

Expressions for moving target indicator (MTI) improvement factor limitation due to pulse repetition frequency (PRF) staggering and loss of target detectability for various values of Doppler frequency in the passband are presented. It is also shown that the product of variance of stagger periods and clutter variance is an important parameter determining the performance of a staggered PRF MTI radar.     

ATS-6 Energetic Particle Radiation Measurement at Synchronous Altitude

The Aerospace Corporation energetic electron-proton spectrometer operating on Applications Technology Satellite-6 (ATS-6) detects energetic electrons in four channels between 140 keV and greater than 32 MeV, and measures energetic protons in five energy channels between 2.3 and 80 MeV and energetic alpha particles in three channels between 9.4 and 94 MeV. After more than a year of operation in orbit, the experiment continues to return excellent data on the behavior of energetic magnetospheric electrons as well as information regarding the fluxes of solar protons and alpha particles.     

Identifications of some highly-ionized iron and nickel lines in the 200–400 Å region of the solar spectrum

A number of previously unclassified multiplets of Fexiv, xiii, xii, and xi produced by transitions of the type 3s ²3p ⁿ -3s3p ⁿ⁺¹ are identified in the XUV spectrum of the Sun. The iron lines account for most of the previously unidentified strong lines between 330 and 370 Å. Solar observations of especial value for the investigation of the 300–400 Å region were the slitless spectroheliograms of September 22, 1968 (Purcell and Tousey, 1969) and November 4, 1969 (Tousey, 1971) — on which the image of a flare was recorded. Other solar identifications in the same spectral region include the resonance lines of Nixvii and Nixviii, and one 3p-3d multiplet of Fexiii. The solar blend at 417 Å involving the Fexv inter-combination line and Sxiv is resolved.     

An Aspect of Determining the Range of Radar Detection

The determination of the range of radar is carried out according to statistical methods which are not always immediate. For this reason, a parametrical method is proposed which condenses the elements necessary for this calculation in the form of three abaci. Furthermore, a general formula condenses this result, and the formula is extended to the other transmission systems.