全文获取类型
收费全文 | 1138篇 |
免费 | 367篇 |
国内免费 | 176篇 |
专业分类
航空 | 1021篇 |
航天技术 | 267篇 |
综合类 | 76篇 |
航天 | 317篇 |
出版年
2024年 | 18篇 |
2023年 | 36篇 |
2022年 | 109篇 |
2021年 | 113篇 |
2020年 | 74篇 |
2019年 | 69篇 |
2018年 | 80篇 |
2017年 | 93篇 |
2016年 | 57篇 |
2015年 | 71篇 |
2014年 | 72篇 |
2013年 | 79篇 |
2012年 | 80篇 |
2011年 | 94篇 |
2010年 | 76篇 |
2009年 | 75篇 |
2008年 | 77篇 |
2007年 | 93篇 |
2006年 | 87篇 |
2005年 | 59篇 |
2004年 | 53篇 |
2003年 | 46篇 |
2002年 | 30篇 |
2001年 | 22篇 |
2000年 | 8篇 |
1999年 | 9篇 |
1997年 | 1篇 |
排序方式: 共有1681条查询结果,搜索用时 281 毫秒
731.
Baopeng LIAO Bo SUN Yu LI Meichen YAN Yi REN Qiang FENG Dezhen YANG Kun ZHOU 《中国航空学报》2019,32(9):2188-2198
Many variables affect the sealing performance, and their distribution characteristics are difficult to obtain with probabilistic methods owing to the high cost involved. Numerous problems in engineering are similar due to the appearance of small-sample parameters. In this study, the sealing reliability of an aviation seal was defined as the research object, and an interval uncertainty method and multidimensional response surface were proposed to calculate the sealing reliability.Based on this, we first analyzed the failure mechanism of the aviation seal and established a leakage rate model. Then, based on the non-probabilistic interval model, an interval uncertainty method was proposed to construct the analytical model. With reference to the limit state equation from the structural reliability theory, the multidimensional response surface was used for fast calculation.Then, we chose the single-cylinder gas steering gear used in aircraft as the case study, its sealing reliability in working and non-working statuses were calculated, and the results were verified with the actual maintenance records. By analyzing the sensitivity of some variables, we can improve the sealing reliability of the aviation seal by improving the surface roughness only if the cost allows.Finally, we consider that the method proposed in this study realizes the application of smallsample uncertainty analysis in reliability analysis, and could provide a feasible way to solve the similar problems in engineering with multidimensional and small-sample parameters. 相似文献
732.
及时准确地发现并处理卫星出现的异常,对卫星运控管理非常重要,关系到卫星在轨使用寿命。设计卫星状态智能诊断知识库,基于该知识库构建的卫星在轨状态自动化报警诊断系统,能够辅助卫星管理人员进行运控管理,这对提高工作效率、降低管理成本、提高卫星安全性具有重要意义。 相似文献
733.
734.
基于退化失效数据的环境因子问题研究 总被引:3,自引:0,他引:3
针对具有退化失效特性的高可靠性长寿命产品,在有限试验时间内难以获得大量失效数据进行环境因子研究的问题,通过对产品性能退化特性的监测和分析,研究退化失效环境因子的建模和估计方法.给出了退化失效环境因子的一般定义和数学描述;提出了复合Poisson过程退化轨道模型的退化失效环境因子模型,并给出了环境因子点估计的矩方法和区间估计的二项分布法;通过仿真实例,对方法在工程应用上的有效性进行了说明. 相似文献
735.
736.
带盖板的预旋系统温降和压力损失数值研究 总被引:13,自引:5,他引:8
为了更大限度地挖掘预旋系统的温降潜力,对有盖板的预旋进气转-静盘腔内的气动热力问题进行了数值模拟,研究了旋转雷诺数、无量纲流量和旋转比对系统温降和压力损失特性的影响,结合盘腔内的流动特征分析了预旋温降和压力损失机理.计算表明绝热条件下的预旋温降主要受动静坐标系转换引起的动降温、离心升温,以及摩阻做功与黏性耗散等不可逆因素三方面影响,其中动降温取决于气流速度和相对速度,这些因素综合决定了系统温降随旋转雷诺数、无量纲流量和旋转比的变化规律.系统压降主要受气动损失、离心升压和坐标系转换引起的动压变化三方面影响.数据显示旋转比是无量纲温降和压力损失系数的主要影响因素.还讨论了预旋孔和接受孔流量系数随流量、转速和旋转比的变化规律. 相似文献
737.
738.
739.
研究了中继卫星跟踪用户航天器的轨迹分段优化计算方法。首先根据位置矢量计算出理论跟踪轨迹,其次根据指向角连续变化的要求确定了单变量最小二乘拟合方法。在此基础上提出了基于动态拟合误差阈值的中继卫星跟踪轨迹分段优化方法。该方法首先确定在初始拟合误差阈值下跟踪轨迹的最优分段数目,然后将拟合误差阈值减小一个修正量,在新的误差阈值约束下重新计算各段的分段时长和分段数目,通过不断减小误差阈值进行循环计算,直到新的分段数目大于最优分段数目时完成计算。由于采用了逐步减小拟合误差阈值的动态阈值计算方法,使得各段的最大拟合误差得到了减小,并且达到了各段拟合误差的一致。该算法有效地提高了中继卫星程序跟踪中全程轨迹的计算精度,获得了良好的应用效果。 相似文献
740.
高转速袋型阻尼密封泄漏的特性 总被引:2,自引:2,他引:0
采用有限元分析和计算流体动力学耦合数值分析方法(FEA/CFD),研究了考虑转子系统由于高速旋转造成转子径向伸长效应时袋型阻尼密封的泄漏特性和流场形态.计算了密封间隙为0.13mm时,袋型阻尼密封试验件在3种压比、3种转速下的泄漏量,并与试验值和不考虑转子伸长效应的CFD数值模拟结果进行了比较,验证了所采用的FEA/CFD数值方法的可靠性(误差小于1.3%)和高转速下考虑转子伸长的必要性.研究了6种压比、6种转速下密封间隙为0.25mm的袋型阻尼密封的流场和泄漏量,分析了压比和转速对袋型阻尼密封泄漏特性的影响规律.结果表明:当压比大于0.26时,随压比的减小,袋型阻尼密封泄漏量逐渐增大;当压比减小到一定值时(π<0.26),泄漏流体的马赫数在最后一个密封齿间隙处达到1.0,即发生了堵塞,此时泄漏量达到与密封进口总压相对应的最大值;在高转速下,考虑和不考虑转子半径的伸长,密封泄漏量均随转速的增大而减小;在转子面周向马赫数大于0.35时,需要考虑转子半径伸长对泄漏量的影响. 相似文献