A review of long drop tubes as a supplement/alternative to space experiments

The 100 meter high drop tube at the Marshall Space Flight Center has proven to be a viable facility for studies of containerless solidification. Advantages are that experiments are inexpensive and large numbers of specimens can be processed rapidly. It would not be unusual to run ten specimens in a day. Another significant advantage is that the undercooling behavior can be followed with sufficient sensitivity to easily detect the onset of recalescence and subsequent events.Disadvantages are the restrictions on specimen sizes and types of alloys that can be run in a microgravity environment. Practical specimen sizes range between 50 mg and 500 mg depending on the type of furnace being used. Refractory alloys can be processed in a vacuum (about 10^?5 torr) and therefore at microgravity. Non-refractory alloys demand an atmosphere (about 200 torr) to obtain appreciable undercooling before impact at the bottom of the tube. Under these conditions significant g forces result.Because of the present limitations of the 100 meter drop tube, the most definitive work has been done on niobium based alloys. Large amounts of undercooling have been observed routinely and the effects of undercooling on microstructure have been characterized in detail. X-ray diffraction, scanning electron microscopy, and transmission electron microscopy have been used to determine types of phases, amounts of phases, and compositions of phases. It is clear, as would be expected, that the results bear some resemblance to rapid solidification processing by quenching. However, there are dissimilarities due to the uniqueness of solidification by deep undercooling without quenching in long drop tubes and accompanying recalescence effects.     

Vertical profiles of halocarbons in the stratosphere

Stratospheric air samples collected between 10 and 35 km altitude my means of a cryogenic sampler were analyzed by gaschromatography. Thus vertical profiles of source gases for halogen radicals were derived, such as CCl₄, CCl₃F, CCl₂F₂, CClF₃, CF₄, C₂F₃Cl₃, C₂F₄Cl₂, C₂F₅Cl, C₂F₆, CH₃Cl, CH₃CCl₃, CHF₂Cl, CH₃Br, CBrF₃, and CBrCl₂F. Systematic discrepancies between measured and modelled halocarbon profiles point to deficiencies of present one- and two-dimensional models. Measurements of fully halogenated hydrocarbons provide a tool for systematically studying these deficiencies and thus improving the models.     

Application of remote sensing techniques in mineral resources survey — a case study pertaining to Singhbhum Shear Zone,Bihar, India

Geological analysis and evaluation of digitally processed and enhanced LANDSAT MSS data products for three test areas of Singhbhum Shear Zone, India has led to certain significant results regarding optimisation and utility of such techniques for geological studies and obtaining additional/new information regarding lithology and structure. Three band-to-band ratio images are found to give best results. Lithologic formations could be subdivided into a number of units. The Westward and southeastward extension of the shear zone could be delineated thereby indicating scope of mineralisation in these parts.     

A new calibration of the semi-empirical photometric theory for Halley and other comets

A massive new body of data, comprised of spectrophotometry of 17 comets by Newburn and Spinrad, has now become available for calibration of the basic theory, the Semi-Empirical Photometric Theory, used for modelling of Comet Halley. A redetermination of the constant $\text{R}$ and the function δ has been made, and no change is needed. Improved mixing ratios given as a function of heliocentric distance also permit an improvement in the constants of the visual photometric model presented at COSPAR XXIV. A new light curve for Halley and a lower dust to gas ratio prove to make roughly compensating changes in dust densities.     

Mass spectrometric measurements of stratospheric ions

Recent in situ measurements with balloon borne quadrupole mass spectrometers, between 20 and 45 km altitude, are reviewed and discussed.The major stratospheric positive ions observed are proton hydrates [H⁺(H₂O)_n] and non proton hydrates of the form H⁺X_m(H₂O)₂. The data analysis allows a derivation of the vertical mixing ratio profile of X (most probably CH₃CN), which is compared with recent model calculations. From negative ion composition data, showing the presence of NO₃^? and HSO₄^? cluster ions, the density of sulfuric acid in the stratosphere is deduced. The implications of these findings on our understanding of the sulfur chemistry is briefly treated.Finally some other aspects such as contamination, cluster break up and the use of stratospheric ion mass spectra for determination of thermochemical data and other minor constituents are discussed.     

Thermal and thermosolutal convective effects in bridgman solidification: Effect of orientation relative to gravity

A concentrated binary system (Ge-Si) and a dilute one (Ge-Ga) have been solidified at 1 g, in a new vertical Bridgman furnace where radial thermal gradients have been minimized. Very different solutal boundary layer extents (δ_Ge-Si = 3 cm, δ_Ge-Ga = 2.5 mm) obtained for both systems solidified in the same thermal conditions are explained by simple analytical hydrodynamic models. It is demonstrated that :1. The convective transport of Ga in the Ge-Ga system is due to the unavoidable residual horizontal thermal gradients associated with discontinuity of thermal properties at the solid-liquid interface.2. The larger boundary layer extent observed for Ge-Si and the corresponding pure diffusive transport is the result of the stabilizing effect of the longitudinal solutal gradient in this system.Thus, in the case of dilute systems, convective effects can only be cancelled through a reduction of the gravity level. On the opposite, pure diffusive solute transport can be achieved in the vertical configuration a 1 g in the case of concentrated systems where a stabilizing solutal effect is operating.     

Humane Intelligence: A Human Factors Perspective for Developing Intelligent Cockpits

A human factors perspective for creating intelligent cockpits is described and explained. A conceptualized interface among the pilots, mental models, and human information technologies is proposed wherein knowledge concerning human cognition is meshed with the capabilities and limitations of artificial intelligence (AI). Necessarily, a different way of looking at the pilot's role in the intelligent cockpit is developed.     

Radio aurora magnetic and streaming aspect sensitivities on 6 simultaneous links at 50 MHz

During August 1981, a 50 MHz c.w. radar system was operated in central Canada to measure auroral scatter amplitudes and Doppler spectra from a scattering region centered near 66° magnetic invariant latitude (L ≈ 6.0). Narrow beams from 3 transmitters, differing in frequency by 1 KHz, were directed to cover a common volume of the ionosphere over a ground location at 56.3°N, 103.5°W. The scattered signals were received on narrow beam antennas at two receiving sites, and recorded in analog form on magnetic tape under the control of an AIM65 microcomputer. The analog tapes were digitized later and FFT-processed to obtain Doppler spectra and amplitudes.The 6 transmission paths were designed to provide several magnetic aspect angles varying by 1.5°-7° from perpendicularity with the earth's field B and two streaming aspect angles differing by ～38°. The objective was to employ controlled geometric factors to study the functional dependency of signal amplitudes and Doppler shifts on magnetic and streaming aspect angles. Several hundred hours of excellent data were obtained in continuous operation during the month of August 1981. Preliminary results will be reported.     

Analysis of gravity-wave induced instabilities and turbulence viscosity parameters from optical emissions

The effects of gravity waves on OH and 5577 0I emissions have been used to investigate (1) the possible production of “secondary” waves or “ripples” by a “primary” wave; (2) the possible application of such observed optical emissions for computing atmospheric parameters such as turbulence viscosity in the mesospheric regions.     

Empirical models of the thermosphere and requirements for improvements

The different types of variation in the thermosphere are briefly examined and the solar-activity effect is singled out for special attention. To this day, empirical models have made use of the decimetric solar flux F_10.7 as an index of the variable XUV radiation from the sun. To account for the change in the relative intensity of the different types of emissions in the course of the solar cycle, F_10.7 is made to perform double duty: The daily values are used to represent the day-to-day and “27-day” variations, while its averages over several solar rotations are used to represent the variations with the 11-year cycle. The availability of direct solar XUV data should eventually eliminate the need for such a make-shift procedure. Accuracy and continuity requirements of XUV intensity measurements are discussed and a strategy is outlined for sorting out the relevant features from the observational material and putting them to practical use in thermospheric modeling. It is suggested that future models of the diurnal and the geomagnetic variation use as a guide theoretical models which have achieved considerable success in qualitatively representing the observed phenomena.