A Closely Regulated TWT Converter

The design concept for the traveling wave tube amplifier converter for possible use in the Thermoelectric Outer Planet Spacecraft (TOPS) is presented. An unusual combination of semiconductors and magnetics were utilized to achieve very stable voltage regulation on a number of separate outputs to satisfy the requirements of a high-power traveling wave tube (TWT), and at the same time operate at an efficiency of better than 90 percent from a 30-volt source. The circuitry consists of an output filter, an auxiliary Jensen oscillator driving a high-reactance transformer to provide current limiting to the heater, a variable time delay, a main Jensen oscillator driving the power transformer with a maximum step-up ratio of 120 to 1, and series transistorized post regulators to provide precise voltage adjustment and low output impedance. This paper discusses the design of the high-reactance transformer and the high step-up ratio transformer, as well as the high-voltage series regulators that are limited in range and operate at the top of the unregulated output voltage. Test data is presented, and details of current transients caused by charging the filter circuits, input current ripple, and output voltage ripples are considered. The circuit provides better than 0.5 percent regulation against load change, input voltage change, and over-operating temperature range of from -20 to + 80°C, with output ripple voltage of less than 2 volts peak-to-peak on top of the 3600-Vdc output. The measured efficiency was typically 87 percent. and recommendations are included to improve this to in excess of 90 percent.     

Target Identification by Natural Resonance Estimation

This paper presents a target identification method based on an estimation of the natural frequencies of oscillation in transient radar signatures. The emphasis is placed upon signal modeling and estimation ation strategy rather than relating resonance locations to physical structures. Salient features of this identification method are: 1) target aspect angle is not needed, 2) multiple targets of the same type can be illuminated simultaneously, and 3) bandpass interrogation ion pulses can be used. The latter feature is compatible with existing radar facilities. The method is applied to some simulated transfer functions, and factors affecting estimate accuracy are discussed.     

高压不稳定环境中的燃料液滴蒸发

对燃料液滴在高压不稳定环境中的蒸发进行了研究，着重讨论了气相介质压力振荡对液滴蒸发特性的影响，计算了Ｃ１２Ｈ２６液滴在Ｎ２介质中蒸发时的蒸发速率、滴温和无因次滴径随时间的变化。结果表明：（１）蒸发速率、滴温发生相同频率的振荡，相位滞后分别为π和π／２；（２）压力振荡使蒸发速率平均值增大，液滴生存时间减少；（３）在不定常加热阶段压力振荡影响很小。     

TC4钛合金紧固件孔E-I强化研究

 介绍TC4(Ti-6Al-4V)钛合金螺栓孔无衬套冷胀孔干涉配合综合强化的研究结果。实验证明,在给定的条件下,冷胀孔强化的TC4板状空孔试件的疲劳寿命增益系数(LIF)为13,干涉配合螺栓连接的LIF=3,而E-l强化件的疲劳寿命比单纯干涉配合又有成倍提高。电镜断口分析表明TC4合金强化件的疲劳裂纹的形成和扩展与LY12CZ及30CrMnSiA相似,它们不表现为典型的角裂纹,即沿板平面和厚向扩展速率有明显差异。对于TC4合金,在改善疲劳品质上,带衬套冷胀孔强化比无衬套冷胀孔强化好得多。     

An exact expression for resolution cell area in special case ofbistatic radar systems

An exact expression for the bistatic resolution-cell area (A _B) is developed for the special case in which either the transmit or receive antenna has a broad azimuth beamwidth or is omnidirectional. Quantitative examples are presented to illustrate the variation of A_B with location. A comparison is made with the performance of a commonly used approximation formula     

超音速燃烧室燃烧效率数学模型及气流状态参数的计算

本文分析及提出了超音速燃烧冲压发动机燃烧室燃烧效率的数学模型.该模型综合了氢气喷射方式、燃烧室进口气流参数以及燃烧室结构的影响因素.用这一数学模型求解一组一元流方程.计算出通过燃烧室的气流状态参数,计算结果与试验数据对比,证明这个模型是适用的.     

一种分析稳态压力畸变对多级轴流压缩系统稳定性影响的新方法

发展了一种分析进口稳态压力畸变对多级轴流压缩系统稳定性影响的逐级平行压缩系统模型；建立了一种稳态压力畸变进气条件下，多级轴流压缩系统对燃烧室燃油瞬时脉冲的气动响应及气动稳定性分析的新方法；导出了基于ＭａｃＣｏｒｍａｃｋ隐式格式的新的数值计算方法。应用新的模型方法对一个三级实验压气机进行了数值分析，给出了稳态压力畸变与压缩系统稳定裕度损失及不稳定发生时间之间的定量关系，定量给出了压气机失稳首发级的识别方法。     

超声速主流中横向喷流干扰流场数值模拟

本文用二阶迎风 TVD格式求解层流 N- S方程 ,数值模拟了超声速主流与横向喷流相互作用复杂干扰流场 ,得到了合理的涡系结构 ,计算波系结构及沿物面压力分布也与实验结果一致。计算还表明 ,TVD格式不但具有较强的捕捉激波的能力 ,而且用来模拟复杂涡系结构也是有效的