全文获取类型
收费全文 | 110篇 |
免费 | 37篇 |
国内免费 | 11篇 |
专业分类
航空 | 89篇 |
航天技术 | 25篇 |
综合类 | 10篇 |
航天 | 34篇 |
出版年
2024年 | 2篇 |
2023年 | 4篇 |
2022年 | 7篇 |
2021年 | 7篇 |
2020年 | 9篇 |
2019年 | 4篇 |
2018年 | 11篇 |
2017年 | 4篇 |
2016年 | 9篇 |
2015年 | 7篇 |
2014年 | 7篇 |
2013年 | 9篇 |
2012年 | 11篇 |
2011年 | 6篇 |
2010年 | 11篇 |
2009年 | 5篇 |
2008年 | 4篇 |
2007年 | 8篇 |
2006年 | 8篇 |
2005年 | 4篇 |
2004年 | 5篇 |
2003年 | 3篇 |
2002年 | 1篇 |
2001年 | 7篇 |
2000年 | 1篇 |
1999年 | 1篇 |
1998年 | 1篇 |
1997年 | 1篇 |
1996年 | 1篇 |
排序方式: 共有158条查询结果,搜索用时 685 毫秒
51.
52.
53.
54.
55.
对铝合金平板上形成的超高速撞击(HVI)声发射(AE)信号S2模态的特征进行研究,分析其与损伤模式之间的关系。以3 mm厚5A06铝合金平板为研究对象,通过数值仿真获得不同撞击工况下的超高速撞击声发射信号,提取信号中的S2模态,并分析其幅值、能量、频谱等特征。结果表明,S2模态能量随传播距离呈指数衰减;分别随撞击弹丸直径和撞击速度的增加先下降后上升,且在弹丸直径与靶板厚度相近、临界撞击速度时最低。S2模态的中心频率随弹丸直径的增加而降低;随撞击速度的增加而增加;随传播距离的增加向1500 kHz移动。S2模态小波包系数呈凹性的频域范围分别随撞击速度和弹丸直径的增大变窄。在此基础上,当靶板形成穿孔损伤时,可根据S2模态的中心频率推测弹丸的直径;在传播距离和弹丸直径已知的前提下,可根据S2模态小波包系数呈凹性的频域范围推测撞击速度。 相似文献
56.
Analytic redundancy-based fault diagnosis technique (ARFDT) is applied to onboard maintenance system (OMS). The principle of the proposed ARFDT scheme is to design a redundancy configuration using ARFDT to enhance the functions of redundancy management and built in test equipment (BITE) monitor. Redundancy configuration for dual-redundancy and analytic redundancy is proposed, in which, the fault diagnosis includes detection and isolation. In order to keep the balance between rapid diagnosis and binary hypothesis, a filter together with an elapsed time limit is designed for sequential probability ratio test (SPRT) in the process of isolation. Diagnosis results would be submitted to central maintenance computer (CMC) together with BITE information. Moreover, by adopting reconstruction, the designed method not only provides analytic redundancy to help redundancy management, but also compensates the output when both of the sensors of the same type are faulty. Our scheme is applied to an aircraft’s sensors in a simulation experiment, and the results show that the proposed filter SPRT (FSPRT) saves at least 50% of isolation time than Wald SPRT (WSPRT). Also, effectiveness, practicability and rapidity of the proposed scheme can be successfully achieved in OMS. 相似文献
57.
利用最优控制方法研究变转速旋翼直升机在遭遇单发失效时,旋翼转速对自转着陆低速回避区的影响。首先,以UH-60A直升机为样机,建立三维刚体飞行动力学模型,并分析低速范围内旋翼转速对直升机需用功率的影响。然后,在模型中加入单发失效后自转着陆阶段发动机输出功率以及旋翼转速变化方程,并利用直接多重打靶法将直升机单发失效后的自转着陆过程转换为非线性最优控制问题进行数值求解。最后,基于最小化回避区面积的思想,得到并分析直升机在不同旋翼转速下单发失效后的自转着陆低速回避区,以及回避区高悬停点、拐点和低悬停点对应的最优着陆轨迹和操纵过程。结果表明:随着旋翼转速的降低,直升机单发失效后的低速回避区首先会逐渐缩小,然后迅速增大。最小回避区对应的旋翼转速略高于最小需用功率对应的旋翼转速。适当降低旋翼转速不仅能有效降低直升机的需用功率,还有利于提高直升机单发失效后的自转着陆性能。 相似文献
58.
59.
目前我国在用的电子秤存在严重的作弊现象,监管部门对电子秤的监管难度很大,虽有许多防作弊方法研究,但收效甚微。本文从电子秤防作弊的总体架构、监管流程设计等方面提出一个电子秤防作弊的整体解决方案,通过软硬件配合的方法,实现电子秤的全生命周期管理,提出需解决的几个关键问题,以期研究人员做进一步的研究。 相似文献
60.