Epilogue: Cosmic Rays in the Active Heliosphere

Space Science Reviews -     

Aircraft Stores Interface Manual (ASIM) adopts paperlessinformation technology

During recent years, defense budgets have been cut across all services while the cost of maintaining current standards has risen. The Aircraft Stores Interface Manual (ASIM) Program Office found that maintaining a staff for paper updates was no longer feasible and was tasked by the North Atlantic Treaty Organization (NATO) Air Armament Working Party (AAWP) to digitize the ASIM manuals. Converting this information from paper to electronic media presented several challenges which are discussed. Adopting Paperless Information Technology and replacing “Snail Mail” with the World Wide Web is presented     

Coastal salinity measurement using a Doppler Radiometer

Coastal salinity is characterised by large and variable salinity contrasts on relatively small scales. Measurements of salinity at a resolution compatible with these coastal regions on a regular basis would provide a rich source of information that could be used for a number of applications that have a fundamental bearing on the world’s lifestyle. Doppler radiometry offers an approach to capture such measurements, as it reduces the number of required antennas needed to form an image, compared with an Interferometer type instrument.     

An overview of RADOM results for earth and moon radiation environment on Chandrayaan-1 satellite

The RADiatiOn Monitor (RADOM) is a miniature dosimeter-spectrometer that flew onboard the Chandrayaan-1 lunar mission in order to monitor the local radiation environment. Primary objective of the RADOM experiment was to measure the total absorbed dose, flux of surrounding energetic particles and spectrum of the deposited energy from high energy particles both en-route and in lunar orbit. RADOM was the first experiment to be switched on after the launch of Chandrayaan-1 and was operational until the end of the mission. This paper summarizes the observations carried out by RADOM during the entire life time (22 October 2008–31 August 2009) of the Chandrayaan-1 mission and compares the measurement by RADOM with the radiation belt models such as AP-8, AE-8 and CRRESS.     

The Magnetospheric Multiscale Magnetometers

The success of the Magnetospheric Multiscale mission depends on the accurate measurement of the magnetic field on all four spacecraft. To ensure this success, two independently designed and built fluxgate magnetometers were developed, avoiding single-point failures. The magnetometers were dubbed the digital fluxgate (DFG), which uses an ASIC implementation and was supplied by the Space Research Institute of the Austrian Academy of Sciences and the analogue magnetometer (AFG) with a more traditional circuit board design supplied by the University of California, Los Angeles. A stringent magnetic cleanliness program was executed under the supervision of the Johns Hopkins University’s Applied Physics Laboratory. To achieve mission objectives, the calibration determined on the ground will be refined in space to ensure all eight magnetometers are precisely inter-calibrated. Near real-time data plays a key role in the transmission of high-resolution observations stored on board so rapid processing of the low-resolution data is required. This article describes these instruments, the magnetic cleanliness program, and the instrument pre-launch calibrations, the planned in-flight calibration program, and the information flow that provides the data on the rapid time scale needed for mission success.     

Effects of space flight on surface marker expression.

Space flight has been shown to affect expression of several cell surface markers. These markers play important roles in regulation of immune responses, including CD4 and CD8. The studies have involved flight of experimental animals and humans followed by analysis of tissue samples (blood in humans, rats and monkeys, spleen, thymus, lymph nodes and bone marrow in rodents). The degree and direction of the changes induced by space flight have been determined by the conditions of the flight. Also, there may be compartmentalization of the response of surface markers to space flight, with differences in the response of cells isolated from blood and local immune tissue. The same type of compartmentalization was also observed with cell adhesion molecules (integrins). In this case, the expression of integrins from lymph node cells differed from that of splenocytes isolated from rats immediately after space flight. Cell culture studies have indicated that there may be an inhibition in conversion of a precursor cell line to cells exhibiting mature macrophage characteristics after space flight, however, these experiments were limited as a result of technical difficulties. In general, it is clear that space flight results in alterations of cell surface markers. The biological significance of these changes remains to be established.     

Some Electrical/Electronic Areas Requiring Emphasis in Preparation for Future Space Programs

A panel session held at the 1965 Aerospace Conference, Houston,Tex., June 23, 1965. Panelists discussed Life-Suppport interfaces with Electric Power; Communications; Navigation; System Integration for Future Space Programs; and Reliability.     

Design and Application of an Adaptive Tracking Filter Control System

The design of an adaptive tracking filter control system and its application to large flexible booster vehicles is described. The problem of elastic vehicle stability is considered along with its solution by conventional and adaptive techniques. The improvement in vehicle stability, which may be achieved with the adaptive tracking filter technique as compared to conventional techniques, is shown. The control system evolved uses two adaptive tracking filters to phase stabilize the first and second bending modes, in addition to conventional compensation techniques. The application of this adaptive technique to a vehicle in which the modal frequencies are in close proximity (<2.5 percent separation) is discussed. The mechanization of the adaptive control system involves the selection of design techniques and components that are electrically and physically compatible with the intended airborne application. The development of a suitable frequency tracking technique and tracking filter is described, in addition to the electronic and mechanical design of the adaptive control system prototype.