Correction to: Determining the Relative Cratering Ages of Regions of Psyche’s Surface

Space Science Reviews - Analysis of Homestake, Gallex and GNO measurements reveals evidence of variability of presumed solar-neutrino-flux measurements. Analysis of Super-Kamiokande neutrino...     

SIGMA observations of hard X-ray and soft gamma-ray emission from X-ray binaries

After more than two years of operation, the imaging γ-ray SIGMA telescope has accumulated several days of observation toward well known X-ray binaries. Four bright sources falling in this category have been detected so far: The pulsar GX 1+4 near the center of our galaxy, the stellar wind accreting system 4U 1700-377, and the black hole candidates Cygnus X-1 and GX 339-4. Moreover, SIGMA have observed three transients sources, which turned out to be also hard X-ray sources : The burster KS 1731-260, Tra X-1, and the Musca Nova. The properties of these systems in the SIGMA domain will be reviewed and a spectral distinction between black holes and neutron stars will be sketched.     

1994年2月21日行星际激波引起的磁暴

利用Imp-8,Geotail和Goes-6等卫星资料,研究了1994年2月21日0900UT到达地球磁层的行星际激波引起的磁暴期间,从太阳风向磁层传输能量的有关问题.结果指出:（1）南向行星际磁场（IMF）的长持续时间不是太阳风向磁层输能的必要条件.南北振荡的,较强IMF也能产生显著的能量传输;（2）行星际扰动磁场通过弓激波和磁层顶后扰动磁能增加,增幅将近5倍;（3）在磁层内扰动磁场的Bz分量在1×10-4Hz附近显著被吸收.这一低频扰动磁场可能是磁暴期间导致氧离子和质子等环电流粒子向内扩散并被加速的原因之一.     

Orbital phase spectroscopy of four high mass X-ray binary pulsars to study the stellar wind of the companion

Our work focuses on a comprehensive orbital phase-dependent spectroscopy of the four High Mass X-ray Binary Pulsars (HMXBPs) 4U 1538-52, GX 301-2, OAO 1657-415 and Vela X-1. We hereby report the measurements of the variation of the absorption column density and iron-line flux along with other spectral parameters over the binary orbit for the above-mentioned HMXBPs in elliptical orbits, as observed with the Rossi X-ray Timing Explorer (RXTE) and the BeppoSAX satellites. A spherically symmetric wind profile was used as a model to compare the observed column density variations. Out of the four pulsars, only in 4U 1538-52, we find the model having a reasonable corroboration with the observations, whereas in the remaining three the stellar wind seems to be clumpy and a smooth symmetric stellar wind model appears to be quite inadequate in explaining the data. Moreover, in GX 301-2, neither the presence of a disk nor a gas stream from the companion was validated. Furthermore, the spectral results obtained in the case of OAO 1657-415 and Vela X-1 were more or less similar to that of GX 301-2.     

Relativistic electron fluxes and dose rate variations during April–May 2010 geomagnetic disturbances in the R3DR data on ISS

Space radiation has been monitored successfully using the Radiation Risks Radiometer-Dosimeter (R3D) installed at the ESA EXPOSE-R (R3DR) facility outside of the Russian Zvezda module of the International Space Station (ISS) between March 2009 and January 2011. R3DR is a Liulin type spectrometer–dosimeter with a single Si PIN detector 2 cm² of area and 0.3 mm thick. The R3DR instrument accumulated about 2 million measurements of the absorbed dose rate and flux of 10 s resolution. The total external and internal shielding before the detector of R3DR device is 0.41 g cm⁻². The calculated stopping energy of normally incident particles to the detector is 0.78 MeV for electrons and 15.8 MeV for protons. After the Coronal Mass Ejection (CME) at 09:54 UTC on 3 April 2010, a shock was observed at the ACE spacecraft at 0756 UTC on 5 April, which led to a sudden impulse on Earth at 08:26 UTC. Nevertheless, while the magnetic substorms on 5 and 6 of April were moderate; the second largest in history of GOES fluence of electrons with energy >2 MeV was measured. The R3DR data show a relatively small amount of relativistic electrons on 5 April. The maximum dose rate of 2323 μGy day⁻¹ was reached on 7 April; by 9 April, a dose of 6600 μGy was accumulated. By the end of the period on 7 May 2010 a total dose of 11,587 μGy was absorbed. Our data were compared with AE-8 MIN, CRESS and ESA-SEE1 models using SPENVIS and with similar observations on American, Japanese and Russian satellites.     

Testing the three-dimensional IRI-SIRMUP-P mapping of the ionosphere for disturbed periods

This paper describes the three-dimensional (3-D) electron density mapping of the ionosphere given as output by the assimilative IRI-SIRMUP-P (ISP) model for three different geomagnetic storms. Results of the 3-D model are shown by comparing the electron density profiles given by the model with the ones measured at two testing ionospheric stations: Roquetes (40.8°N, 0.5°E), Spain, and San Vito (40.6°N, 17.8°E), Italy. The reference ionospheric stations from which the autoscaled foF2 and M(3000)F2 data as well as the real-time vertical electron density profiles are assimilated by the ISP model are those of El Arenosillo (37.1°N, 353.3°E), Spain, Rome (41.8°N, 12.5°E), and Gibilmanna (37.9°N, 14.0°E), Italy. Overall, the representation of the ionosphere made by the ISP model is better than the climatological representation made by only the IRI-URSI and the IRI-CCIR models. However, there are few cases for which the assimilation of the autoscaled data from the reference stations causes either a strong underestimation or a strong overestimation of the real conditions of the ionosphere, which is in these cases better represented by only the IRI-URSI model. This ISP misrepresentation is mainly due to the fact that the reference ionospheric stations covering the region mapped by the model turn out to be few, especially for disturbed periods when the ionosphere is very variable both in time and in space and hence a larger number of stations would be required. The inclusion of new additional reference ionospheric stations could surely smooth out this concern.     

In situ analysis of Europa ices by short-range melting probes

A key aspect for understanding the astrobiological potential of planets and moons in the Solar system is the analysis of material embedded in or underneath icy layers on the surface. In particular in case of the icy crust of Jupiters moon Europa such investigation would be of greatest interest. For a Europa lander to be launched in the 2020–2030 timeframe, we propose to use a simplified instrumented melting probe which is able to access and sample depths of a few meters without the necessity of heavy and complicated drilling equipment.     

Development of thermal sensors and drilling systems for lunar and planetary regoliths

We consider some novel concepts for thermal properties experiments aboard lunar landers or rovers, that may lead to an improved understanding of both the structure of the lunar near surface layers and the lunar thermal history. The new instruments could be developed using the experience and heritage from recently developed systems, like the Rosetta Lander thermal conductivity experiment MUPUS and existing designs used for terrestrial measurements of thermal conductivity. We describe shortly the working principle of such sensors and the main challenges faced when using them in the airless regolith layers of the Moon or other airless bodies. In addition new concepts to create appropriate drill holes for thermal and other measurements in the lunar regolith are discussed.