Adaptive control for a sensorless permanent-magnet synchronousmotor drive

An adaptive velocity controller for a permanent-magnet synchronous motor without using shaft sensor is presented. Two line-to-line voltages and two stator currents are sensed to produce the flux position. The design part is concerned with the formulation of control algorithm for current-regulated pulsewidth modulated inverter and vector control strategy for speed loop. Under the vector control framework, self-tuning, model following, and model referencing adaptive control are applied to design for the speed-loop controllers. The implementational part integrates the control of current and speed loop using microprocessor-based controllers. Experimental case studies that correlate simulation and measurement results are provided. The experimental results validate the theoretical development. A new approach for designing advanced adaptive controller for a sensorless ac drive is provided     

氦气驱动预压涡轮泵启动初期反流问题分析

用于某液体火箭发动启动动系统的气驱预压涡轮泵在起动初期出现了气体反流,导致预压泵呈夹气状态,对发动启动动过程控制不利。根据驱动试验系统原理,在MWorks平台中对驱动过程进行了仿真。对预压泵采用了Suter全特性表达式,对涡轮管路及排放路分别建立了描述排空与两相流动过程的简化数学模型。结果 表明,导致反流的原因为涡轮入...     

航天器弹性附件伸展动力学研究

利用动量矩定理推导出带伸展弹性板航天器的姿态动力学方程，在弹性板等速伸展的情况下，导出板的振动与伸展运动耦合微分方程，航天器姿态运动与板的伸展运动、振动耦合微分方程，通过龙格－库搭积分法得出了数值解，结果表明：弹性板等速伸展时，其振动的振幅随板长度的增长而增大，航天器姿态角速度随板长度的增长而减少。弹性板等速率越大，板振动的振幅越大。     

Distributed computation for a tree network with communicationdelays

Tree networks of communicating processors are examined with the objective of solving a computational problem in a minimal amount of time. The processors in the networks may be equipped either with or without front-end processors for communicating of loading. The determination of the optimal division of processing load is discussed for the network with and the network without front-end processors. The inclusion of solution time, the time taken for sensors to report the solution back to originator, is discussed     

细晶铸造对K418合金拉伸性能的影响

测试了不同温度下细晶铸造和普通铸造Ｋ４１８合金的拉伸性能。结果表明，细晶铸造明显改善了合金的极限位伸强度和屈服强度，室温和６００℃的合金拉伸强度和晶粒平均直径符合Ｈａｌｌ－Ｐｅｔｃｈ关系。     

ADμC824在温度测控方面的应用

介绍了ADμC824的部分特性及其在精确控温方面的软硬件设计思路。     

TEMPERATURE EFFECT ON OXIDATION PROTECTION LIFE OF MULTI-LAYER COATING FOR C/C COMPOSITES

Carbon-carboncomposites(C/C)exhibitexcellentstructuralpropertiesabove165OC,andareconsideredasthemostpromisingcandidatematerialsforthehighthrust-weightratioturbineengines.Asakeytechnologyforthehigh-temperaturestructuralapplicationsofC/C,oxidationprotectionispaidmoreandmoreattentionrecently.TheoxidationprotectionllfeofacoatedC/Cisdeterminedbyenvironmenta1temperature,becauseitnotonlydecidesthether-mochemicalconditionsofinterfacesinacoating,butalsocontrolsthedynamicprocessofoxy-gendiffusion.The…     

高精度稠粘流体压力传感器

一种高精度流体压力传感器,这种传感器除适用于测量普通气体、液体的压力外,特别适用于稠粘流体的压力测量。文中着重阐述了这种传感器的工作原理、结构特点及性能指标,并简要介绍了设计中的一些考虑,指出了这种传感器的发展潜力和应用前景。     

壁面摩擦对风洞侧壁干扰的影响

本文研究了摩擦对风洞侧壁干扰的影响。在以Barnwell为代表开展的一系列侧壁干扰研究中,所有工作都未计及摩擦的影响。我们认为,Barnwell等人的这一处理理论上有缺陷。对此,本文用Karman-Pohlhausen方法对侧壁边界层作了分析,指出摩擦对侧壁干扰有不同程度的影响,具体取决于Pohlhausen参数B的大小;B越小,影响越大。Barnwell略去摩擦项的结果只对应于分离边界层情况,而事实上Barnwell处理的是附着边界层。通过这一分析,本文建立了有摩擦影响的侧壁干扰修正的新形式;考虑到多种因素的影响,初步建议参数B按中间值取为B=3～4。最后,就修正参数δ~*的确定作了一定讨论。     

循环电载荷下大功率LED金引线疲劳断裂寿命预测

随着大功率发光二极管（LED）在照明领域的普及与广泛应用,可靠性逐渐成为研究的重点。大功率LED封装器件中金引线疲劳断裂失效一直是制约其可靠性的重要因素。通过针对大功率LED封装器件中的金引线力学仿真与功率循环试验相结合的方法,首先确定循环电载荷条件下该型LED的主要失效原因为金引线疲劳断裂,其次提出基于电流加速模型的加速因子提取方法和基于应变幅值的Coffin-Manson解析寿命预测方法,最终完成对LED金引线疲劳断裂寿命的预测和试验验证。研究结果表明:所提方法具有较高的寿命预测精度,可以满足大功率LED封装器件可靠性快速、准确评估的要求。