Overloading of Landing Based on the Deformation of the Lunar Lander

Along with the progress of sciences and technologies, a lot of explorations are taken in many countries or organizations in succession. Lunar, the natural satellite of the earth, become a focus of the space discovery again recently because of its abundant resource and high value in use. Lunar exploration is also one of the most important projects in China. A primary objective of the probe in lunar is to soft-land a manned spacecraft on the lunar surface. The soft-landing system is the key composition of the lunar lander. In the overall design of lunar lander, the analysis of touchdown dynamics during landing stage is an important work. The rigid-flexible coupling dynamics of a system with flexible cantilevers attached to the main lander is analyzed. The equations are derived from the subsystem method. Results show that the deformations of cantilevers have considerable effect on the overloading of the lunar lander system.     

金属橡胶减振器用于发动机安装减振的研究

 为减小发动机传递至飞机机身结构的振动,设计了金属橡胶减振器用于航空发动机安装。对该金属橡胶减振器进行了动力学建模研究,采用有限元技术对安装减振器前后的飞机全机结构进行了仿真分析,初步表明了该设计对结构频率影响较小,但能引入较大阻尼,降低响应水平。在理论分析基础上,进一步将设计制造的金属橡胶减振器安装于某型飞机,进行地面开车,实测了应用减振安装前后飞机的动力学响应。结果证明了发动机减振安装的可行性与有效性。     

基于预测脱靶量的远程拦截速度增益导引

 针对拦截器使用耗尽关机固体燃料发动机的情况,设计了大气层外目标拦截的速度增益导引方法。导引律中根据Lambert导引确定指令推力方向初值,利用剩余速度增量信息,计算惯性速度增益下的预测脱靶量,使用Kepler轨道摄动方程计算消除脱靶量所需的速度增益修正,根据惯性速度增益和速度增益修正之和确定指令推力方向。给出了一种计及J2项引力摄动影响的滑行段弹道预测半解析方法,减少导引律运算量,降低导引方法误差;导引律中引入了剩余速度增量测量环节,增强了导引精度对推进系统参数的鲁棒性。与传统的通用能量管理（GEM）导引相比,采用该导引律拦截远程目标时指令推力方向平稳、变化范围小,脱靶量降低了两个数量级。     

Comparative analysis of four different single-frequency PPP models on positioning performance and atmosphere delay retrieval

Single-frequency precise point positioning (SF-PPP) has attracted increasing attention due to its high precision and cost effectiveness. With various strategies to handle the dominant error, i.e., ionosphere delay, the ionosphere-float (IF), ionosphere-free-half (IFH), ionosphere-corrected (IC), and ionosphere-weighted (IW) SF-PPP models are certain to possess different characteristics and performance levels. This study is dedicated to assessing and comparing the four models from model characteristics, positioning performance, and atmosphere delay retrieval. The model comparison shows that IC and IW models are full-rank while IF and IFH models have a rank deficiency of size one that will result in biased estimations, which means the better solvability of IC and IW models. The experiments are carried out based on the 7-day Global Positioning System (GPS) observations collected at 57 global Multi-GNSS Experiment (MGEX) stations and Global Ionosphere Map (GIM) products. The results indicate that the IW model can accelerate SF-PPP convergence and achieve higher positioning accuracy compared to the other three SF-PPP models, especially in kinematic mode. With convergence criteria of 0.25 m in horizontal and 0.5 m in vertical, the east/north/up convergence times of IW model are 0.5/15.0/25.0 min and 0.5/16.0/36.5 min for static and kinematic modes, respectively. The IW model is able to achieve an instantaneous positioning accuracy of 0.28/0.35/0.75 m. In addition, a real kinematic test also demonstrates the best positioning solutions of IW model. Regarding troposphere delay retrieval, the IF, IFH, and IW models obtain a comparable daily accuracy of 3.0 cm on average, while the IC model achieves the worst accuracy of 8.0 cm. For precise ionosphere delay estimation, IW model only needs an average initialization time of 34.3 min, but a longer initialization time of 51.6 min is required for IF model. The daily precision of ionosphere delay estimation for IW model can reach up to 10.8 cm. At the present accuracy of GIM products, it is suggested that the IW model should be adopted for SF-PPP first due to its superior performance in positioning and atmosphere delay retrieval.     

硅橡胶基防热涂层动态烧蚀行为及机理研究

针对两种典型硅橡胶基防热涂层开展高温燃气流烧蚀实验，通过对烧蚀后涂层的宏观及微观形貌分析，探讨了其防隔热机理及烧蚀模型。研究结果表明：烧蚀后两种涂层均存在液态层、陶瓷层、热解层以及原始层；烧蚀过程中甲基苯基硅橡胶涂层主要发生主链“回咬”成环反应，导致树脂基体交联密度降低，力学性能下降，涂层外表面发生开裂，甲基乙烯基硅橡胶涂层则主要发生侧基交联反应，使树脂基体交联密度上升，促进涂层发生陶瓷化转变；热辐射、热容吸热、热解反应吸热以及热阻塞效应为四种主要的热耗散机制，质量损失产生的原因主要包括反应气体释放以及气动剪切力导致的机械剥蚀。     

Comparison of convergence time and positioning accuracy among BDS,GPS and BDS/GPS precise point positioning with ambiguity resolution

Precise point positioning (PPP) usually takes about 30?min to obtain centimetre-level accuracy, which greatly limits its application. To address the drawbacks of convergence speed and positioning accuracy, we develop a PPP model with integrated GPS and BDS observations. Based on the method, stations with global coverage are selected to estimate the fractional cycle bias (FCB) of GPS and BDS. The short-term and long-term time series of wide-lane (WL) FCB, and the single day change of narrow-lane (NL) FCB are analysed. It is found that the range of GPS and BDS non-GEO (IGSO and MEO) WL FCB is stable at up to a 30-day-time frame. At times frame of up to 60?days, the stability is reduced a lot. Whether for short-term or long-term, the changes in the BDS GEO WL FCB are large. Moreover, BDS FCB sometimes undergoes a sudden jump. Besides, 17 and 10 stations were used respectively to investigate the convergence speed and positioning errors with six strategies: BDS ambiguity-float PPP (Bfloat), GPS ambiguity-float PPP (Gfloat), BDS/GPS ambiguity-float PPP (BGfloat), BDS ambiguity-fixed PPP (Bfix), GPS ambiguity-fixed (Gfix), and BDS/GPS ambiguity-fixed (BGfix). The average convergence speed of the ambiguity-fixed solution is greatly improved compared with the ambiguity-float solution. In terms of the average convergence time, the Bfloat is the longest and the BGfix is the shortest among these six strategies. Whether for ambiguity-float PPP or ambiguity-fixed PPP, the convergence reduction time in three directions for the combined system is the largest compared with the single BDS. The average RMS value of the Bfix in three directions (easting (E), northing (N), and up (U)) are 2.0?cm, 1.5?cm, and 5.9?cm respectively, while those of the Gfix are 0.8?cm, 0.5?cm, and 1.7?cm. Compared with single system, the BDS/GPS combined ambiguity-fixed system (BGfix) has the fastest convergence speed and the highest accuracy, with average RMS as 0.7?cm, 0.5?cm, and 1.9?cm for the E, N, U components, respectively.     

基于微课的材料成型及控制工程专业英语翻转课堂教学实践与探索

微课不是指用于微学习的微内容,而是指使用专业软件构建便于在线和移动学习的实际教学内容。笔者结合教学实践,利用iSpring Suite软件制作微课,开展对材料成型专业英语的教学研究,并进一步探索基于微课的翻转课堂教学模式。