海洋环境下服役飞机铝合金零件腐蚀失效分析

对出口旅游观光用飞机的铝合金零件在热带海洋气候环境服役条件下所发生的腐蚀问题进行了分析探讨.通过铝合金零件发生腐蚀的微观形貌和腐蚀产物成分等的分析,结合飞机所处环境条件,讨论了铝合金零件的腐蚀类型和发生剥蚀的过程及原因,并分析了其发生剥蚀的机理.认为海洋环境中的氯离子是造成沿海飞机铝合金零件腐蚀的外因,而内因是飞机零件的表面防腐蚀设计与防护不足,腐蚀的发展过程是铝合金零件表面点腐蚀、晶间腐蚀直至剥蚀,腐蚀产物造成的应力是促进分层剥离的原因.针对这种表面腐蚀防护问题,提出了相应的改进措施.      

积冰对飞机纵向操稳特性的量化影响

提出了一种根据气象条件、飞机特征、飞行条件预测积冰对飞机飞行动力学特性影响的估算方法.采用热力学平衡分析方法完成了积冰增长过程的数学描述,利用逐步线性回归方法建立了结冰飞机的气动模型,计算得到了结冰飞机的气动参数,计算结果与试验结果吻合较好,表明这种方法具有一定的工程实用性.并在此基础上研究了不同部位积冰对飞机纵向操稳特性的影响,通过数值仿真计算得出,结冰飞机气动特性的急剧恶化会导致其纵向操稳特性显著降低,严重时会危及其飞行安全.      

Effects on winter circulation of short and long term solar wind changes

Indices of the North Atlantic Oscillation and the Arctic Oscillation show correlations on the day-to-day timescale with the solar wind speed (SWS). Minima in the indices were found on days of SWS minima during years of high stratospheric aerosol loading. The spatial distribution of surface pressure changes during 1963–2011 with day-to-day changes in SWS shows a pattern resembling the NAO. Such a pattern was noted for year-to-year variations by Boberg and Lundstedt (2002), who compared NAO variations with the geo-effective solar wind electric field (the monthly average SWS multiplied by the average southward component, i.e., negative Bz component, of the interplanetary magnetic field). The spatial distribution of the correlations of geopotential height changes in the troposphere and stratosphere with the SWS; the geo-effective electric field (SWS∗Bz); and the solar 10.7 cm flux suggests that solar wind inputs connected to the troposphere via the global electric circuit, together with solar ultraviolet irradiance acting on the stratosphere, affect regional atmospheric dynamics.     

Dynamics and control of spacecraft hovering using the geomagnetic Lorentz force

To achieve hovering, a spacecraft thrusts continuously to induce an equilibrium state at a desired position. Due to the constraints on the quantity of propellant onboard, long-time hovering around low-Earth orbits (LEO) is hardly achievable using traditional chemical propulsion. The Lorentz force, acting on an electrostatically charged spacecraft as it moves through a planetary magnetic field, provides a new propellantless method for orbital maneuvers. This paper investigates the feasibility of using the induced Lorentz force as an auxiliary means of propulsion for spacecraft hovering. Assuming that the Earth’s magnetic field is a dipole that rotates with the Earth, a dynamical model that characterizes the relative motion of Lorentz spacecraft is derived to analyze the required open-loop control acceleration for hovering. Based on this dynamical model, we first present the hovering configurations that could achieve propellantless hovering and the corresponding required specific charge of a Lorentz spacecraft. For other configurations, optimal open-loop control laws that minimize the control energy consumption are designed. Likewise, the optimal trajectories of required specific charge and control acceleration are both presented. The effect of orbital inclination on the expenditure of control energy is also analyzed. Further, we also develop a closed-loop control approach for propellantless hovering. Numerical results prove the validity of proposed control methods for hovering and show that hovering around low-Earth orbits would be achievable if the required specific charge of a Lorentz spacecraft becomes feasible in the future. Typically, hovering radially several kilometers above a target in LEO requires specific charges on the order of 0.1 C/kg.     

Influence of lunar topography on simulated surface temperature

The surface temperature of the Moon is one of the essential parameters for the lunar exploration, especially to evaluate the Moon thermophysical features. The distribution of the temperature is heavily influenced by the Moon topography, which, however, is rarely studied in the state-of-art surface temperature models. Therefore, this paper takes the Moon topography into account to improve the surface temperature model, Racca model. The main parameters, such as slopes along the longitude and latitude directions, are estimated with the topography data from Chang’E-1 satellite and the Horn algorithm. Then the effective solar illumination model is then constructed with the slopes and the relative position to the subsolar point. Finally, the temperature distribution over the Moon surface is obtained with the effective illumination model and the improved Racca model. The results indicate that the distribution of the temperature is very sensitive to the fluctuation of the Moon surface. The change of the surface temperature is up to 150 K in some places compared to the result without considering the topography. In addition, the variation of the surface temperature increases with the distance from the subsolar point and the elevation, along both latitude and longitude directions. Furthermore, the simulated surface temperature coincides well with the brightness temperature in 37 GHz observed by the microwave sounder onboard Chang’E-2 satellite. The corresponded emissivity map not only eliminates the influence of the topography, but also hints the inherent properties of the lunar regolith just below the surface. Last but not the least, the distribution of the permanently shadowed regions (PSRs) in the lunar pole area is also evaluated with the simulated surface temperature result.     

The relation between the Black hole mass and the Bulge mass for low redshift AGNs. Part I: Ground-based observations

Using the bulge data from AGN image decomposition with ground-based observations, we calculate the ratios of the central supermassive black hole mass(SMBH) to the Bulge mass (_Mbh/_Mbulge$M_{\text{bh}}/M_{\text{bulge}}$) in a sample of X-ray selected AGNs, including 15 Narrow-line Seyfert 1 galaxies (NLS1s) and 18 broad-line Seyfert 1 galaxies (BLS1s). We found that the mean value of log(_Mbh/_Mbulge)$\log (M_{\text{bh}}/M_{\text{bulge}})$ is -3.81±0.11$-3.81\pm 0.11$ for 15 NLS1s, and -2.91±0.13$-2.91\pm 0.13$ for 18 BLS1s, showing the lower _Mbh/_Mbulge$M_{\text{bh}}/M_{\text{bulge}}$ in NLS1s relative to BLS1s. The calculation shows that the Bulge mass from the host image decomposition in NLS1s is statistically smaller than that from Hubble-type correction method, and a linear mass relation is suggested for NLS1s and a nonlinear mass relation for BLS1s. The studying of host galaxies with ground-based observations strongly limited by the atmospheric seeing. We need to do the decomposition of host images for NLS1s with Hubble Space Telescope observation in the future.     

Very low frequency interferometry for the Chang’E-2 project

Very low frequency interferometry among two astronomical experiments has been proposed and accepted for further study for the second phase of China’s lunar exploration programme (the Chang’E Programme), which is envisaged to operate a lander and a rover on the surface of the moon. This experiment is an interferometer experiment in the very low frequency (VLF, f < 15 MHz) regime of radio frequencies with at least degree-level angular resolution. The goals include observing solar storm activities, Coronal Mass Ejections, Auroral Kilometric Radiation, and planetary radiation in the solar system, studying the origin of Cosmic Rays, spectral properties of pulsars, surveying ionized hydrogen in the Galaxy, and exploring coherent radio emissions.     

基于离散事件方法的AFDX建模与仿真

采用了建模仿真的方法来分析航空电子全双工交换式以太网(AFDX,Avionics Full Duplex switched ethernet)协议.通过对AFDX协议的抽象,基于离散事件的建模方法,以基本的网络元素来抽象化网络中的端系统、交换机等设备,以离散事件来描述网络设备的行为,以此构建了AFDX网络模型,并依据模型实现了仿真.网络演算是一种理论计算AFDX最坏延迟界限的方法,将典型场景下仿真得到的结果与理论计算的结果进行比较,验证了模型.通过不同流量方案下仿真结果的对比,对AFDX进行了传输特性的分析.