航天测控系统自主运行的关键技术

航天事业发展趋势和未来需求指明,航天测控系统应该向以自主运行能力为代表特征的智能化方向发展。基于此,提出了标准化的支持与服务、映射现实的体系架构、实时响应的运行模式、服务化的基础平台等4项关键技术。通过将测控系统和卫星系统之间的接口、测控系统和用户系统之间的接口标准化,从而在此基础上建立最优化的操作逻辑。通过在计算机中映射现实系统的思想方法,从而产生稳定性和灵活性兼备的、支持自主运行的,并具有良好进化性能的系统架构。通过实时响应的运行模式可以很好满足全时段和突发性等具有挑战性的测控服务需求。通过大数据和云计算技术构建基础计算服务平台实现基础层与业务层分离,有利于整个系统的持续改进,提高服务质量改善的速度,建立竞争力优势。由此说明,在当前技术条件下实现自主运行的航天测控系统是可行的。     

无人机飞行控制系统先进设计技术评述

首先简要回顾了无人机飞行控制系统经典设计方法,然后着重论述了目前国外在无人机飞行控制系统设计领域的最新研究成果,包括动态逆技术、BACKSTEPPING自适应技术及综合制导与控制技术。     

激光光纤准直系统的试验研究

介绍一种新的激光准直系统,该系统通过单模光纤建立新的光发射基准,从而有效地抑制了由于激光腔热变形而产生的光束漂移。另外,该系统采用了标量卡尔曼数字滤波器耒降低大气扰动和其他环境因素对测量的影响,在2.5m的测量范围内,系统稳定性可以控制在±1.5μm以下。该系统适用于作为形状误差和运动误差测量时的直线基准。     

矩形截面弯管内气固两相流及对管壁磨损的数值分析

在便于描述矩形截面弯管流动的曲线坐标系中，计算了气固两相流，颗粒对管壁的磨损位置与磨损量。分析了弯管曲率、弯管安放方式、颗粒大小对磨损状况的影响。本文计算与实验数据比较，符合良好。     

小卫星非常规动力学分析与控制

针对小卫星研制中出现的一些非常规动力学问题进行研究,并提出解决办法。针对小卫星组件最大冲击谱量级超出常规冲击试验规范谱的分析与验证困难,通过研究提出了能够分析评估组件高量级冲击的方法。针对小卫星随机振动下强度设计方法还存在较大误差,分析了系统模态质量比与模态频率在一定频段的影响规律,认为忽略模态质量耦合会带来误差,提出了考虑模态质量耦合的准静态载荷计算方法。最后,针对小卫星整星开展了减振研究,分析了正弦和随机减振效果,对于对称安装减振系统,提出了减振系统的主频率计算公式。     

Measurement of mass diffusion coefficients of O_2 in aviation fuel through digital holographic interferometry

The experimental apparatus to measure the mass diffusion coefficients of O2 in aviation fuel was constructed based on the digital holographic interferometry method. The theory of mass diffusion coefficient and interference image processing were introduced in detail. The accuracy of the experiment was verified by measuring the mass diffusion coefficient of 0.33 mol/L KCl in aqueous solution at 298.15 K. The mass diffusion coefficients of O_2 in RP3 and RP5 aviation fuels were measured at temperature from 278.15 K to 333.15 K, and the Arrhenius equation was employed to fit the experimental data. In terms of the Stokes-Einstein equation, the viscosities of these two aviation fuels were tested to estimate the correlation among mass diffusion coefficient, viscosity and temperature. A uniform polynomial calculation correlation was proposed to predict the mass diffusion coefficients of O_2 in both RP3 and RP5 aviation fuels, and its accuracy is considerably higher than that of the Stokes-Einstein equation.     

Event-triggered attitude control of spacecraft

The problem of spacecraft attitude stabilization control system with limited communication and external disturbances is investigated based on an event-triggered control scheme. In the proposed scheme, information of attitude and control torque only need to be transmitted at some discrete triggered times when a defined measurement error exceeds a state-dependent threshold. The proposed control scheme not only guarantees that spacecraft attitude control errors converge toward a small invariant set containing the origin, but also ensures that there is no accumulation of triggering instants. The performance of the proposed control scheme is demonstrated through numerical simulation.     

Parametric Modeling of Circuit Model for AC Glow Discharge in Air

In the parametric modeling of the circuit model for glow discharge in air,a new method for the design of glow discharge circuit model is presented.The new circuit model is an important reference for the design of plasma power supply,the simulation of glow discharge plasma actuator and the simulation of glow discharge plasma anemometer.The modeling approach consists in developing an electrical model of the glow discharge in air based on circuit components.The structure of the circuit model is established according to the theoretical analysis and the experimental device.Then the parameters of the circuit model are obtained based on the circuit analysis.Finally,the circuit model is verified by comparing the simulation current with the experimental current.This model takes into account the whole framework of the air glow discharge including the sheath and the plasma area.The built circuit model is feasible and reliable,thus being instructive for the investigation of the glow discharge in air.     

三组元喷嘴雾化特性的试验研究

三组元喷嘴是气氢／液氧／煤油火箭发动机的重要部件,对４ 种类型的三组元喷嘴进行了雾化特性试验, 研究了喷嘴的雾化特性随各组元喷注压降的变化规律, 分析了喷嘴结构对雾化性能的影响, 比较了相同工况下单喷嘴和三喷嘴的雾化性能, 进行了三组元工况和双组元工况下的雾化特性试验, 试验结果表明同轴离心内混式喷嘴的雾化性能较好。所得结论对三组元喷嘴和气液同轴式喷嘴的优化设计有重要的参考价值     

某直升机齿轮传动系统的瞬态热分析

提出了传动系统瞬态温度场的分析方法,建立了失去润滑条件下传动系统功率损失及对流换热系数的计算模型,该模型考虑了失去润滑后传动系统热状态参数的时变特征。在稳态热分析的基础上,求解了某直升机齿轮传动系统的瞬态温度场,为该传动系统生存能力的预测提供了理论依据。