Thin-film Li-LiMn2O4 batteries

Thin-film rechargeable Li-LiMn₂O₄ batteries have been fabricated and characterized. Following deposition by electron beam evaporation of LiMn₂O₄, the amorphous as-deposited cathode films 1 cm² in area by 0.3to 4-μm thick were annealed at 700°C to 800°C in oxygen in order to form the crystalline spinet phase. The specific capacity of the cells between 4.5 V to 3.8 V ranged from 50 μAh/mg to 120 μAh/mg. When cycled over this range, the batteries exhibited excellent secondary performance with capacity losses as low as 0.001% per cycle. On charging to 5.3 V, a plateau with a median voltage of 5.1 V was observed. The total charge extracted between 3.8 V to 5.3 V corresponded to about 1 Li/Mn₂ O₄     

Leading Edge Estimation Errors

The leading edge estimator (LEE) of a pulse signal is defined as the instant at which a filtered version of the received noisy signal passes a preset threshold. A rigorous analysis for a rectangular pulse model of the signal results in an exact probability density function for the LEE, valid within the time interval of the leading edge of the filtered pulse. Possible occurrence of the threshold crossing outside of this interval is considered to be an anomalous estimate, since it leads to a gross error in comparison with the regular cases. It is found that the density function of the LEE error is asymmetrical and therefore biased, that the probability PA of anomalous estimation increases with the filter bandwidth, thus setting a well definable limit to the latter and that, for prespecified PA, the minimum bias and variance are proportional, respectively, to R-1 and R-2, minima being obtained by allowing for the largest bandwidth compatible with PA. On the other hand, for given bandwidth the variance decreases only as R-1. Here R is the signal-to-noise energy ratio. Results are presented in form of parameterized graphs.     

WAMDII — A wide angle Michelson Doppler imaging interferometer for spacelab

A CCD imaging device has been designed which combines a spatial resolution of 0.1° with a spectral resolving power of 10⁵, sufficient to measure Doppler shifts and line widths of individual atmospheric emission lines. It will be flown aboard Spacelab and will be used to study neutral winds and temperatures as functions of height, latitude and time of day.     

Comparison of resonant topologies in high-voltage DC applications

Because of their tolerance of transformer nonidealities, resonant converters are considered to be well-suited to high-voltage applications. The series and parallel resonant topologies, as well as a newly discovered hybrid resonant topology are compared for high-voltage applications. Design criteria which incorporate transformer nonidealities are developed and used in the construction of high voltage prototypes for each topology. It is found that the parallel topology leads to the lowest peak switch current and the most ideal behavior     

The Magellan project

Magellan is one of the future space projects being studied by the European Space Agency. The aim is to provide high resolution (λ/Δλ ≥ 2.5 × 10⁴) spectra in the far and extreme UV (between 500 and 1550 Å) of faint galactic and extragalactic objects (V ≤ 16^m). The instrument consists of a mechanical collimator, a concave holographic grating and a bidimensional photon-counting detector. A low resolution mode (λ/Δλ ≥ 10³) will provide spectra of objects as faint as 18^m.5. Magellan is planned as an observatory, operated in real time, and allowing interaction with the observer.     

Structure of the Martian atmosphere from ε-Gem occultation observations

We have collected information about Martian atmospheric scale heights derived from observations of the occultation of ? Gem by Mars on April 8, 1976. The observations give data in the altitude range ～50 to 80 km. A rough, unweighted average of results so far available yields a temperature of ～165°K. Excursions of ～±40°K about this mean may be present as a function of both altitude and areographic coordinates.     

Comments on "Optimum Bandwidth of a Low-Pass Filter for Detection of a Pulse in Nonstationary Noise"

In a recent correspondence1 a calculation of the optimum bandwidth of a low-pass RC filter for the detection of a pulse signal in nonstationary noise was presented. The purpose of this correspondence is: 1) to point out additional references to the work which has been conducted in the stationary noise case, and 2) to present an interesting alternate derivation of the expected output noise power for the nonstationary noise case.     

Causes of aircraft electrical failures

The results of a survey of data on failures of aircraft electronic and electrical components that was conducted to identify problematic components are reported. The motivation for the work was to determine priorities for future work on the development of accident investigation techniques for aircraft electrical components. The primary source of data was the Airforce Mishap Database, which is maintained by the Directorate of Aerospace Safety at Norton Air Force Base. Published data from the Air Force Avionics Integrity Program (AVIP) and Hughes Aircraft were also reviewed. Statistical data from these three sources are presented. Two major conclusions are that problems with interconnections are major contributors to aircraft electrical equipment failures, and that environmental factors, especially corrosion, are significant contributors to connector problems     

Radiation transmission in adverse weather

A simplified practical approach to determining the effects of weather on the transmission of radiation at visible, infrared (IR), and millimetre (mm) wavelengths, with particular reference to the aircraft landing problem, is outlined. Passive landing systems are studied. Landing categories related to visibility are defined. An extinction coefficient used to relate the effect of the atmosphere on the radiation detected by the human eye (or an imaging sensor onboard the aircraft) to the landing category and the calculation of this coefficient are discussed. The approach makes use of data from openly available literature. Results have been found useful in indicating the effects of adverse weather on imaging sensor performance for an enhanced vision aircraft-mounted landing system. As an example of the technique, the method of determining the extinction coefficients in fog for infrared radiation is outlined     

V-22 mechanical diagnostic design approach

The requirements and diagnostic applications for the V-22 tiltrotor aircraft are used to demonstrate the unique requirements of mechanical system diagnostic design. The rationale for the approach selected is explored, and it is shown how the mechanical system diagnostic requirements affect the avionics architecture and performance requirements. It is concluded that, in light of the underdeveloped nature of mechanical diagnostics technology and the extended time required for a given mechanical diagnostic design to mature, future avionics system designs need architecture that is adaptable enough to accommodate the evolving mechanical diagnostics