Transformer Induced Instability of the Series Resonant Converter

It is shown that the common series resonant power converter is subject to a low frequency oscillation that can lead to the loss of cyclic stability. This oscillation is caused by a low frequency resonant circuit formed by the normal L and C components in series with the magnetizing inductance of the output transformer. Three methods for eliminating this oscillation are presented and analyzed. One of these methods requires a change in the circuit topology during the resonance cycle. This requires a new set of steady state equations which are derived and presented in a normalized form. Experimental results are included which demonstrate the nature of the low frequency oscillation before cyclic stability is lost.     

Frame Synchronization in the Presence of Errors and Erasures

An approach to the problem of achieving frame synchronization in the presence of jamming or other large disturbances is presented. It is assumed that the disturbance can be detected at the receiver, which then erases the corresponding bits and passes this information to the synchronizer. A synchronization algorithm designed to operate in the presence of both erasures and background errors is described and evaluated for a representative set of system parameters. This algorithm is shown to have a significant advantage over an algorithm which does not use the location information inherent in the erasure model.     

A Fast Beamforming Algorithm for Large Arrays

This beamforming algorithm is written specifically for array radars in which the number of array elements K is very large compared with the number of jammers L the radar is designed to suppress. It uses a set of M noise vectors to construct a basis for the jammer component of the antenna output vectors. The component of the quiescent weight vector orthogonal to each basis vector is calculated, renormalized to unit length, and identified as the adapted weight vector. This algorithm is effective in the suppression of many types of jammers. The number of noise samples M required in the construction of the adapted weight vector is approximately equal to L. In the special case of L narrowband noise jammers, for example, a choice of M = L usually reduces the receiver output jammer power to a few dBs above the white noise background. It is permissible to have M相似文献   

Plasma transport across the heliopause

Existing heliopause models are critically rediscussed under the new aspect of possible plasma mixing between the solar wind and the ambient ionized component of the local interstellar medium (LISM). Based on current kinetic plasma theories, effective diffusion rates across the heliopause are evaluated for several models with turbulence caused by electrostatic or electromagnetic interactions that could be envisaged in this context. Some specific cases that may lead to high diffusion rates are investigated, especially in regard to their LISM magnetic field dependence.For weak fields (less than 10^–7 G), macroscopic hydrodynamic instabilities, such as of Rayleigh-Taylor or Kelvin-Helmholtz-types, can be excited. The resulting plasma mixing rates at the heliopause may amount to 20–30% of the impinging mass flow.Recently, an unconventional new approach to the problem for the case of tangential magnetic fields at the heliopause was published in which a continuous change of the plasma properties within an extended boundary layer is described by a complete set of two-fluid plasma equations including a hybrid MHD-formulation of wave-particle interaction effects. If a neutral sheet is assumed to exist within the boundary layer, the magnetic field direction is proven to be constant for a plane-parallel geometry. Considering the electric fields and currents in the layer, an interesting relationship between the field-reconnection probability and the electric conductivity can be derived, permitting a quantitative determination of either of these quantities.An actual value for the electrical conductivity is derived here on the basis of electron distribution functions given by a superposition of Maxwellians with different temperatures. Using two-stream instability theory and retaining only the most unstable modes, an exact solution for the density, velocity, and magnetic and electric fields can be obtained. The electrical conductivity is then shown to be six orders of magnitude lower than calculated by conventional formulas. Interestingly, this leads to an acceptable value of 0.1 for the reconnection coefficient.By analogy with the case of planetary magnetopauses, it is shown here for LISM magnetic fields of the order of 10^–6 G or larger that field reconnection processes may also play an important role for the plasma mixing at the heliopause. The resulting plasma mixing rate is estimated to amount to an average value of 10% of the incident mass flow. It is suggested here that the dependence of the cosmic-ray penetration into the heliosphere on the distribution of reconnecting areas at the heliopause may provide a means of deriving the strength and orientation of the LISM field.A series of observational implications for the expected plasma mixing at the heliopause is discussed in the last part of the paper. In particular, consequences are discussed for the generation of radio noise at the heliopause, for the penetration of LISM neutrals into the heliosphere, for the propagation of cosmic rays towards the inner part of the solar system and for convective electric field mergings into the heliosphere during the course of the solar cycle, depending on the solar cycle variations. With concern to a recent detection of electrostatic plasma waves by plasma receivers on Voyagers 1 and 2, we come to an interesting alternate explanation: the heliopause, rather than the heliospheric shock front, could be responsible for the generation of these waves.     

Simulation of Permanent Magnet Generator/Rectifier Combination

Permanent magnet generators are often used as the pilot exciters of three-stage generating units to provide an efficient and reliable source of electrical power. No external power supply is then necessary, and the problems associated with brushwear and with arcing at the rubbing contacts are eliminated. A technique is presented here by which the performance of a permanent magnet generator, when combined with a rectifier-fed d.c. load at its output terminals, may be accurately and efficiently computed. The machine model takes into account the magnetization characteristic of the permanent magnet rotor and involves only parameters which can be determined from terminal measurements on the machine at standstill. Both computed and measured characteristics for an experimental machine are presented, and a comparison of these characteristics shows that the model can predict accurately all the major characteristics of the machine, as well as its detailed internal performance, when supplying a typical resistiveinductive load.     

Analysis of Detection Probability for the Acoustooptic Receiver

A numerical method is described for analyzing the performance of an acoustooptic receiver. The method provides output waveforms, probability density functions for samples of the output, and detection probabilities for output samples. The approach is general in that input pulse envelope shapes, pulse offset frequencies, and output rilter magnitude responses are arbitrary. The basic analysis is also independent of the shape of the optical beam and of the photodiode windows.     

Clutter Map CFAR Analysis

An analysis of the probability of target detection for a clutter map CFAR using digital exponential filtering has been performed. General performance equations are derived. The probability of detection versus signal-to-noise ratio is plotted for a false alarm probability of 1.E-06 for several weight values. The CFAR loss is plotted for a detection probability of 0.9 and false alarm probabilities of 1.E-06 and 1.E-08.     

Instantaneous Frequency Estimation Using Adaptive Linear Predictor Weights

A computationally efficient scheme for estimating the digital instantaneous frequencies of narrowband inputs is introduced. The frequency estimates are obtained by searching for minima of the inverse input power spectrum. This spectrum is estimated at each input sample from the weights of an adaptive linear predictor which uses the LMS (least mean square) algorithm to update its weights. The related minima are sought via an iterative search algorithm, referred to as the iterative frequency estimator. This algorithm is computationally more efficient than available methods, and also provides a higher resolution. Simulation results are included; these include tracking of random message sequences in FM signals, and the formant frequency estimation of speech.     

Normalized LMS Algorithm Degradation Due to Estimation Noise

The steady-state weight vector derived by either the least mean square (LMS) or normalized least mean square (NLMS) algorithms has random deviations from the optimum values. These deviations increase the steady-state residue power. A previous paper derived the LMS weight noise effects for a multiple sidelobe canceller (MSLC) application. This paper describes the NLMS weight noise effects. It is shown that for a thermal noise environment, the weight noise effect for the LMS algorithm is insignificant but is quite significant for the NLMS algorithm. Calculations for example noise plus interference environments imply that the NLMS weight noise effects are always larger than that for LMS.