Interference Immunity Effects in CPSK Systems with Hard-Limiting Transponders

Transmission characteristics are described for M-ary coherent phase-shift keyed (CPSK) systems with N-stage hard-limiting transponders where noise and multiple continuous wave (CW) interference sources are additively combined in each link. A general expression for the probability density function of the composite phase at the final link is derived; the overall error probability is then obtained from this general expression. Comparisons with N-cascaded linear amplifier systems clearly show the noise and interference immunity that result from the use of bandpass hard limiters (BPHLs). The BPHL system's error probability improvement versus interference sources is shown to be much larger than the improvement versus noise.     

Microprocessor-Controlled Digital Shunt Regulator

A new approach to the design of power systems is presented in which a microprocessor is used as a controller for a digital shunt regulator (DSR). This approach meets the demands of future space and ground missions, i. e., high efficiency, high reliability, low weight, low volume, increased flexibility, and less development time. This approach responds to future demands by permitting realtime modification of system parameters for system optimization. This feature is especially important in the event of an anomaly. As the microprocessor need not be dedicated to the DSR, it can simultaneously be used for battery management and for charge regulator/discharge regulator control. This approach also reduces the component count, simplifies assembly and testing of the unit, results in significant time saving, and increases the reliability.     

Problems in the analysis of gamma-ray burst spectra

Spectral measurements by the Solar Maximum Mission have been used to confirm the cyclotron lines in gamma-ray bursts reported from the Konus experiment. We present ISEE-3 data for the same burst (GB800419) during the same period of time which show no line. We discuss various problems in the analysis of scintillator spectra and point out that unfolded spectra are not necessarily unique and that the position of a data point in a deconvolved spectrum may vary depending on the assumed overall shape of the spectrum. As a result, if the analysis assumes a soft spectrum (such as optically thin thermal bremsstrahlung) an absorption feature might appear, whereas a harder spectrum (such as a Comptonized blackbody) would not require the feature. Since the continuum shape probably changes during the duration of a typical burst, the nonuniqueness of the spectral unfolding, combined with the assumption that the continuum is optically thin thermal bremsstrahlung, could give rise to spurious “absorption” features which vary on a time scale of seconds. Despite these problems, there is still some evidence for $\text{narrow}$ spectral lines in the range 45 to 65 keV but not for the broad lines reported from the Konus experiment. Unfortunately, the range 45 to 65 keV is the most difficult spectral region to unfold.     

Ambiguity Functions for Quadratic Phase-Coded Pulse Trains

The matched filter ambiguity function is presented for a burst waveform composed of repeated subbursts, each one of which consists of N pulses in which the phase is varied quadratically from pulse to pulse. The resulting ambiguity function exhibits small residual ambiguities along the delay axis separated by the reciprocal of the pulse repetition frequency (PRF). A cross-ambiguity function is derived which reduces these ambiguities to zero amplitude. A third cross-ambiguity function is presented for a receiver matched to a generalized Hamming weighted repeated quadratic burst. The location in the delay/Doppler plane of the waveform ambiguities for these waveforms is compared with that of an uncoded pulse burst.     

Real-time stereoscopic applications using the goes operational satellites

We have investigated the use of real and synthetic stereo satellite images and stereo graphics in applications such as cloud-tracked winds, severe storm cloud analysis, and general meteorological interpretation. We have concluded that a stereo meteorological presentation is possible and desirable in an operational environment. Synthetic stereo could be used immediately in cloud-tracked wind operations. The presentation allows one to appreciate the interrelations between cloud motions and cloud structures, especially in multi-layered situations. Reprocessing of FGGE tropical wind sets with a synthetic stereo presentation showed some improved yields of low-level vectors, a significant increase in mid-level vectors, and very little change in the high-level vectors. Severe local storm real-stereo presentations are possible operationally because the 15 minute RISOP operations of GOES-East allow simultaneous scanning of both geosynchronous satellites twice per hour. The real-stereo height measurements of overshooting turrets are an improvement over infrared heights and can be used to monitor the strength of the thunderstorm updraft. Synthetic stereo presentations of thunderstorm tops can be presented in a non-linear fashion which stretches out the cloud top features. The synthetic stereo presentation is easier for most people to see. We recommend the use of a hybrid system where the viewing is done on the synthetic stereo image and the quantitative measurements are done on the real-stereo pairs.     

The sensitivity of the earth's radiation budget to changes in cloudiness

Cloudiness modulates the radiation budget at the top of the Earth-atmosphere system. For radiation balance studies, for climate diagnostic studies, and for climate modeling studies, it is important to know the sensitivity of both the outgoing longwave radiation and the net (absorbed solar minus outgoing longwave) radiation of the system to changes in cloudiness on a global basis. Based on a 45 month series of NOAA satellite scanning radiometer observations, estimates of the global distribution of these sensitivity parameters are obtained.     

Multiple Beam Satellite System Optimization

An analytical method is developed for determining the basic RF link parameters that are required in a satellite system design. Certain simplifying assumptions are required and specific system elements are selected. Two different design criteria are considered; optimizing the per-beam signal energy to noise spectral density ratio (Eb/N0), and minimizing the per-user costs. These two criteria are complements of each other subject to coverage and performance constraints. The model can be used to rapidly assess tradeoffs in various system elements. A specific example of a domestic satellite system is considered. The economic analyses are also considered and the economy of scale effect is demonstrated for the design example and considered.     

On the generation of satellite position (and velocity) by a mixed analytical-numerical procedure

The generation of accurate Earth-satellite ephemerides by numerical integration, over a period of perhaps weeks, can consume an inordinate amount of computer time. No satisfactory purely analytical procedure exists, but if short-period components of the standard elliptic elements are removed analytically, the resulting mean elements can be integrated with a step time that is longer than the satellite's orbital period.The definition of the mean elements depends on the particular perturbations included in the orbit generator and regarded as non-resonant. It is best if short-period perturbations are not applied to the orbital elements themselves but to the satellite's position (and velocity if required), expressed in a system of cylindrical polar coordinates, and the paper shows how mean elements can be recovered from position and velocity.A computer program has been written to test the proposed procedure for generating ephemerides, using a truncated potential field. Some results from this program are presented.     

Lightweight (AlGaAs)GaAs/CuInSe2 tandem junction solarcells for space applications

Mechanically stacked tandem cells consisting of GaAs thin-film upper cells and CuInSe₂ thin-film lower cells have been developed to meet the increasing power needs projected for future spacecraft. The authors report the fabrication of the first highly efficient lightweight GaAs/CuInSe₂ tandem cell on a 2-mil thick substrate, update recent performance improvements in thin-film GaAs/CuInSe₂ tandem cells, and discuss their application to space power systems. The efficiency of 4-cm² cells has improved to 21.6% AM0, the highest ever reported for a thin-film photovoltaic cell. Lightweight 4-cm² tandem cells have been successfully fabricated with efficiencies as high as 20.8%. These cells weighed about 180 mg without optimized substrate trimming. Radiation and operating temperature effects on GaAs/CuInSe₂ tandem cells are also discussed, and an interconnect scheme to form a voltage-matched string is described     

MARC-a system for simulation and visualization of space missionscenarios

MARC (modeling, animation, rendering, and compositing), a system using advanced computer graphics and animation techniques for spacecraft mission simulation, is described. The MARC system provides capabilities for generating complex models of both man-made and natural phenomena. The system models orbital dynamics of terrestrial satellites, supports solid models for the Earth, Sun, and Moon, and simulates the dynamics of terrestrial satellites for arbitrary elliptical orbits. A stellar background including magnitudes and spectral types is generated. The elements of the MARC system, including object modeling tools, orbital animation techniques, the rendering system used to compute individual frames, and the compositing techniques used, are discussed. The software architecture of the MARC system and the hardware used to support the system are described