A novel framework for liquid propellant engine’s cooling system design by sensitivity analysis based on RSM and multi-objective optimization using PSO

One of the challenges of combustion chamber and nozzle design in a Liquid Propellant Engine (LPE) is to predict the behavior and performance of the cooling system. Therefore, while designing, the optimization of the cooling system is always of great importance. This paper presents the multi-objective optimization of the LPE’s cooling system. To this end, a novel framework has been developed, resulting from the application of the Response Surface Method (RSM) and the correlation coefficients matrix, sensitivity analysis and the The Particle Swarm Optimization (PSO). based on this method, the input variables, constraints, objective functions, and their surfaces were identified. In terms of multi-optimization algorithms, RSM and PSO are utilized to get global optimum. In conclusion, the methodology capability is to optimize the LPE’s cooling system, 6 percentage increase in total heat transfer and 7 bar decrease cooling system pressure loss, which resulted in a 1.2-seconds increase in the specific impulse of the engine.     

A comparative study of ionospheric IRIEup and ISP assimilative models during some intense and severe geomagnetic storms

Three-dimensional (3-D) electron density matrices, computed in the Mediterranean area by the IRI climatological model and IRIEup and ISP nowcasting models, during some intense and severe geomagnetic-ionospheric storms, were ingested by the ray tracing software tool IONORT, to synthesize quasi-vertical ionograms. IRIEup model was run in different operational modes: (1) assimilating validated autoscaled electron density profiles only from a limited area which, in our case, is the Mediterranean sector (IRIEup_re(V) mode); (2) assimilating electron density profiles from a larger region including several stations spread across Europe: (a) without taking care of validating the autoscaled data in the assimilation process (IRIEup(NV)); (b) validating carefully the autoscaled electron density profiles before their assimilation (IRIEup(V)).The comparative analysis was carried out comparing IRI, IRIEup_re(V), ISP, IRIEup(NV), and IRIEup(V) foF2 synthesized values, with corresponding foF2 measurements autoscaled by ARTIST, and then validated, at the truth sites of Roquetes (40.80°N, 0.50°E, Spain), San Vito (40.60°N, 17.80°E, Italy), Athens (38.00°N, 23.50°E, Greece), and Nicosia, (35.03°N, 33.16°E, Cyprus). The outcomes demonstrate that: (1) IRIEup_re(V), performs better than ISP in the western Mediterranean (around Roquetes); (2) ISP performs slightly better than IRIEup_re(V) in the central part of Mediterranean (around Athens and San Vito); (3) ISP performance is better than the IRIEup_re(V) one in the eastern Mediterranean (around Nicosia); (4) IRIEup(NV) performance is worse than the IRIEup(V) one; (5) in the central Mediterranean area, IRIEup(V) performance is better than the IRIEup_re(V) one, and it is practically the same for the western and eastern sectors.Concerning the overall performance, nowcasting models proved to be considerably more reliable than the climatological IRI model to represent the ionosphere behaviour during geomagnetic-ionospheric storm conditions; ISP and IRIEup(V) provided the best performance, but neither of them has clearly prevailed over the other one.     

Assessment study of ionosphere correction model using single- and multi-shell algorithms approach over sub-Saharan African region

It is a known fact that ionosphere is the largest and the least predictable among the sources of error limiting the reliability and accuracy of Global Navigation Satellite Systems (GNSS) and its regional augmentation systems like Satellite Based Augmentation System (SBAS) in a safety-of-life application. The situation becomes worse in the Equatorial Ionization Anomaly (EIA) region, where the daytime ionization distribution is modified by the fountain effect that develops a crest of electron density at around ±15° to ±20° of the magnetic equator and a trough at the magnetic equator during the local noon hours. Related to this phenomenon is the appearance of ionosphere irregularities and plasma bubbles after local sunset. These may degrade further the quality of service obtained from the GNSS/SBAS system of the said periods. Considering the present operational augmentation systems, the accuracy and integrity of the ionosphere corrections estimate decreases as the level of disturbances increases. In order to provide a correct ionosphere correction to the user of GNSS operating in African EIA region and meet the integrity requirements, a certified ionosphere correction model that accurately characterizes EIA gradient with the full capacity to over-bound the residual error will be needed. An irregularities detector and a decorrelation adaptor are essential in an algorithm usable for African sub-Saharan SBAS operation. The algorithm should be able to cater to the equatorial plasma vertical drifts, diurnal and seasonal variability of the ionosphere electron density and also should take into account the large spatial and temporal gradients in the region. This study presents the assessment of the ionosphere threat model with single and multi-layer algorithm, using modified planar fit and Kriging approaches.     

Mechanism of error propagation from the subdaily Universal Time model into the celestial pole offsets estimated by VLBI

Within the analysis of space geodetic observations, errors of the applied subdaily Earth rotation model can induce systematic effects in different estimated parameters. In this paper, we focus on the impact of the subdaily Universal Time (UT1) model on the celestial pole offsets (CPO) estimated from very long baseline interferometry (VLBI) observations. We provide a mechanism that describes the error propagation from the subdaily UT1 into the daily CPO.In typical 24-h VLBI sessions the observed quasars are well distributed over the sky. But the observations, if looked at from the Earth-fixed frame, are not homogeneously distributed. The amount of observations performed in different terrestrial directions shows an irregularity which can be roughly compared to the case where the observations are collected in only one Earth-fixed direction. This peculiarity leads to artefacts in VLBI solutions, producing a correlation between the subdaily variations in UT1 and the position of the celestial pole. As a result errors in diurnal terms of the subdaily UT1 model are partly compensated by the estimated CPO. We compute for each 24-h VLBI session from 1990 until 2011 the theoretical response of the CPO to an error in the subdaily UT1 by setting up a least-squares adjustment model and using as input the coordinates of the observed quasars and observation epochs. Then real observed response of the estimated CPO derived from the VLBI session solutions is compared to the predicted one. A very good agreement between the CPO values estimated from VLBI and the predicted values was achieved. The presented model of error propagation from the subdaily UT1 into the daily CPO allows to predict and explain the behaviour of CPO estimates of VLBI solutions computed with different subdaily Earth rotation models, what can be helpful for testing the accuracy of different subdaily tidal models.     

Development of the Technique for Calculating the Ejectors with Low Entrainment Ratios

This paper presents the results of an investigation of ejectors with the low entrainment ratio. A technique for calculating the ejectors with a curvilinear axis has been developed. Comparative studies of the performance characteristics of ejectors with the rectilinear axis of the mixing chamber and the curvilinear initial section of the mixing chamber are carried out.     

Equalization of QPSK Data Transmission in Specular Multipath

This paper gives performance results for transversal-filter equalization of quadriphase phase-shift-keyed (QPSK) signals with two-component multipath and demodulator phase error. An analytical expression for optimum, minimum mean-square-error tap weights in terms of the multipath and signal parameters is given. Probability of error results for no equalization and equalization with adaptive decision-feedback tap-weight adjustment are compared. The results show that significant improvement can be obtained with relatively simple equalizer structures.     

Optimal Inputs for Nonlinear Process Parameter Estimation

The sensitivity of observed data to an unknown parameter is enhanced by utilizing optimal inputs. The derivation is given for the optimal input of an nth-order nonlinear differential equation. To obtain the optimal input, the solution of 4n two-point boundary value equations is required. Numerical resutis are given for a second order linear example. The optimal return is compared with the return obtained for a step input. The existence of a critical time length is demonstrated.     

Neural and fuzzy reconstructors for the virtual flight datarecorder

The results are presented of a comparative study evaluating the performance of neural network (NN) and fuzzy logic reconstructors (FLRs) for the development of a virtual flight data recorder (VFDK). Typical flight data recorders (FDRS) on commercial airliners do not record the aircraft control surface deflections. These dynamic parameters are critical in the investigation of an accident or an uncommanded maneuver. The results are shown relative to a VFDR based on a neural network simulator (NNS) along with a neural network reconstructor (NNR) or a FLR The NNS is trained off-line, using available flight data for the particular aircraft, for the purpose of simulating any desired dynamic output recorded in current FDRs. The NNS is then interfaced with the NNR or with the FLR. The output of the two reconstructors are the control surface deflections which minimize a performance index based on the differences between the available data from the FDR and the output from the NNS. The study tested with night data from a B737-300 shows that both schemes, the one with the NNR and the one with the FLR, provide accurate reconstructions of the control surface deflections time histories     

Fluctuations, Dissipation and Heating in the Corona

Mechanisms for the deposition of heat in the lower coronal plasma are discussed, emphasizing recent attempts to reconcile the fluid and kinetic perspectives. Structures at the MHD scales are believed to act as reservoirs for fluctuation energy, which in turn drive a nonlinear cascade process. Kinetic processes act at smaller spatial scales and more rapid time scales. Cascade-driven processes are contrasted with direct cyclotron absorption, and this distinction is echoed in the contrast between frequency and wavenumber spectra of the fluctuations. Observational constraints are also discussed, along with estimates of the relative efficiency of cascade and cyclotron processes. This revised version was published online in June 2006 with corrections to the Cover Date.     

Donald Hamilton,The Evolving Universe,Astrophysics and Space Science Library,volume 321

Space Science Reviews -