Environment and Radar Operation Simulator

The environment and radar operation simulator (EROS) is a hardware system whose function is to produce realistic synthetic radar backscatter, incorporating both target and clutter. The simulator is electrically connected to a subject radar and responds in real time to the radar's antenna scan angle by producing the correct composite video signal.     

Charge exchange lifetimes for ring current ions

In applying the charge exchange mechanism to ion phenomena within the Earth's magnetosphere it is critical to the proper interpretation of observations that the charge exchange lifetimes for the ions be known as accurately as possible. Various new results have been published which significantly modify the charge exchange lifetimes which have been used in space physics research during the past decade and a half. Some of the newer results have been used in the application of the charge exchange decay mechanism but the use has been limited and for the most part incomplete. The neutral hydrogen density distribution now yields lifetimes which are shorter than previously calculated, while the functional dependence of the lifetimes on pitch angle provides for slower decay for ions mirroring off the geomagnetic equator. This review coalesces and summarizes the latest and best measurements of the physical quantities involved in the complete calculation of the charge exchange lifetime of the mirroring magnetospheric ions.     

Thin-film Li-LiMn2O4 batteries

Thin-film rechargeable Li-LiMn₂O₄ batteries have been fabricated and characterized. Following deposition by electron beam evaporation of LiMn₂O₄, the amorphous as-deposited cathode films 1 cm² in area by 0.3to 4-μm thick were annealed at 700°C to 800°C in oxygen in order to form the crystalline spinet phase. The specific capacity of the cells between 4.5 V to 3.8 V ranged from 50 μAh/mg to 120 μAh/mg. When cycled over this range, the batteries exhibited excellent secondary performance with capacity losses as low as 0.001% per cycle. On charging to 5.3 V, a plateau with a median voltage of 5.1 V was observed. The total charge extracted between 3.8 V to 5.3 V corresponded to about 1 Li/Mn₂ O₄     

Preflare heating of filaments

Disappearances of preflare filaments have been observed on June 22, 1980 (S07,W13) (flare at 13.04 U.T.) and September 3, 1980 (flare at 7.52 U.T.). The analysis of MSDP data (MEUDON) leads to the followings conclusions : - Disappearances begin a few minutes before the Hα impulsive phase. - The filaments can be seen again after the flares. - Upwards motions occur in several points, without disturbing significantly preëxisting downflows.Velocity maps suggest shears or velocity loops.The filament disappearance seems to be due to a heating mechanism beginning before the flare maximum.     

The Resolution Performance of Range Estimators

The theoretical basis and methods of implementation of a moment algorithm for the range separation estimation of two closely spaced point targets are presented. Moment estimation and noise filtering techniques introduced here result in a considerable improvement over Baum's algorithm. The error bounds are established and it is shown that the spectral moment estimator exhibits optimum (zero bias, minimum variance) performance when the target separation normalized to the standard deviation of the Gaussian pulse is 2?1.5. Monte Carlo simulation is performed to verify the approximations made and to demonstrate the feasibility of the working models.     

Sequential Piecewise Recursive Filter for GPS Low-Dynamics Navigation

The design, implementation, and performance of a real-time estimation algorithm, referred to in this paper as the sequential piecewise recursive (SPWR) algorithm, for the global-positioning system (GPS) low-dynamics navigation system is described. The SPWR algorithm for this application was implemented in single precision arithmetic (32 bit, floating point). Numerical results are presented covariance and filter gains at a slower rate than the state measurement update, and it uses U-D factor formulation to perform covariance computations. The SPWR algorithm saves real-time processing requirements without appreciable degradation of filter performance. Another important feature of the SPWR algorithm is that it incorporates pseudorange and delta-range data from each GPS satellite sequentially for navigation solution. The SPWR algorithm, for this application, was implemented in single precision arithmetic (32 bit, floating point). Numerical results are presented.     

Global communication using a constellation of low Earth meridianorbits

The concept of meridian orbits is briefly reviewed. It is shown that, if a satellite in the meridian orbit makes an odd number (>1) of revolutions per day, then the satellite passes over the same set of meridians twice a day. Satellites in such orbits pass over the same portion of the sky twice a day and every day. This enables a user to adopt a programmed mode of tracking, thereby avoiding a computational facility for orbit prediction, look angle generation, and auto tracking. A constellation of 38 or more satellites placed in a 1200-km altitude circular orbit is favorable for global communications due to various factors. It is shown that appropriate phasing in right ascension of the ascending node and mean anomaly results in a constellation wherein each satellite appears over the user's horizon one satellite after another. Visibility and coverage plots are provided to verify the continuous coverage     

Residual stresses and endurance strength under tension-compression in the conditions of stress concentration

Residual stresses and endurance strength of specimens with stress concentrators are considered. The results obtained make it possible to predict the fatigue limit of strengthened parts with concentrators in the case of tension-compression.     

Statistical analysis of experimental study results on low-cycle fatigue resistance for the EI698-VD high-temperature alloy

The results of low-cycle fatigue tests of smooth cylindrical specimens made of the EI698-VD nickel-base high-temperature alloy widely used in aircraft engine industry are considered statistically. The influence of such factors as an initial level of mechanical properties, operating time and temperature of tests is evaluated. The experimental data on low-cycle fatigue (LCF) are used when determining the cyclic life for disks.