The Calculation of Frequency-Modulation Distortion in Linear Networks

A numerical method is developed for the calculation of steady-state FM distortion in a linear passive network from the character of the FM signal input and the steady-state transfer characteristics of the network. The method of calculating FM distortion requires the solution of a finite set of linear equations which is accomplished readily by a digital computer. To illustrate the use of the method, the FM distortion introduced by a Chebyshev-response bandpass filter is calculated for a range of network and input signal parameters.     

A Closely Regulated TWT Converter

The design concept for the traveling wave tube amplifier converter for possible use in the Thermoelectric Outer Planet Spacecraft (TOPS) is presented. An unusual combination of semiconductors and magnetics were utilized to achieve very stable voltage regulation on a number of separate outputs to satisfy the requirements of a high-power traveling wave tube (TWT), and at the same time operate at an efficiency of better than 90 percent from a 30-volt source. The circuitry consists of an output filter, an auxiliary Jensen oscillator driving a high-reactance transformer to provide current limiting to the heater, a variable time delay, a main Jensen oscillator driving the power transformer with a maximum step-up ratio of 120 to 1, and series transistorized post regulators to provide precise voltage adjustment and low output impedance. This paper discusses the design of the high-reactance transformer and the high step-up ratio transformer, as well as the high-voltage series regulators that are limited in range and operate at the top of the unregulated output voltage. Test data is presented, and details of current transients caused by charging the filter circuits, input current ripple, and output voltage ripples are considered. The circuit provides better than 0.5 percent regulation against load change, input voltage change, and over-operating temperature range of from -20 to + 80°C, with output ripple voltage of less than 2 volts peak-to-peak on top of the 3600-Vdc output. The measured efficiency was typically 87 percent. and recommendations are included to improve this to in excess of 90 percent.     

Radar Cross Section of Ships

A laboratory method to determine the magnitude and position of radar reflection sources on complex targets is described. In addition the method provides a way to measure the modification of the radar cross section (RCS) due to multipath. The method has application in modeling RCS for radar and electronic countermeasure (ECM) system performance analysis and in the study of the extent to which the signature of the target could be altered. The equipment described, termed MACROSCOPE, was developed for RCS studies by the U.S. Army and is described in limited distribution bution literature. The application to marine targets is new with this paper, as is the technique of measuring the RCS of parts of the target and analytically combining them to represent the whole. An illustration of the need for this type of laboratory equipment was illustrated by the extensive search for full scale data which could be compared to scale model data to validate the technique.     

Radar ECCM: A European Approach

The radar designer must optimize parameters for performance in electronic countermeasures (ECM) and avoid any constraints which could be exploited by ECM. ECM/electronic counter-counter measures (ECCM) strategy must take into account electromagnetic compatibility (EMC) including enemy EMC. Electronic scanning improves search performance, but also reduces ECCM performance in other ways. While electronic scanning avoids some constraints, it imposes others, particularly in the frequency domain. It is argued that simple radars of good performance may be as cost effective in ECM as more complex systems. Some examples of recent developments are given.     

Photoelectron Counting Statistics and Error Performance of m-Distributed Optical Signal

By the term "m-distributed optical signal" we mean a noise-like optical signal whose envelope (or intensity) fluctuation probability is modeled by Nakagami's "m-distribution." Using the m-distribution which has been widely used as an analytical model of the fading envelope in radio communications, it is shown that one can generally analyze the statistical properties such as the photoelectron count probabilities and error probabilities for the wider class of noise-like optical signals; some numerical results are also given.     

On-Line Computer for Transient Turbine Cascade Instrumentation

A 32-channel computer based data acquisition and processing system em has been developed for use with the new type of transient cascade facility at Oxford. This is used for testing turbine blades and nozzle guide vanes at full-scale engine Reynolds and Mach numbers ers with correct wallto-flow temperature ratios. A novel technique for processing transient heat transfer data from thin film surface resistance thermometers has been developed. Measurements of surface ace pressure around blades, and of the upstream turbulence level have been made. The cascade and instrumentation are shown to have advantages both in cost and effectiveness over continuous running cascades.     

An investigation into the nature of the 4.4 hr periodic source 4U1755-33

We present the results of a continuous 18 hour observation of 4U1755-33 made with the European Space Agency's EXOSAT Observatory. Four 50 min dips in X-ray intensity were observed equally spaced with a period of 4.4 hrs, confirming the periodicity first suggested in White et al. (1984). The dips are spectrally independent. We examine the properties of 4U1755-33 and conclude that the source is most probably point-like and that the metallicity of the absorbing material is at least 600 times less than cosmic values.     

Shock acceleration of energetic particles in the heliosphere

The theory of shock acceleration of energetic particles is briefly discussed and reviewed with an emphasis on clarifying the apparent distinction between the V × B and Fermi mechanisms. Attention is restricted to those situations in which the energetic particles do not themselves influence the given shock structure. In particular, application of the theory to the acceleration of energetic particles in corotating interaction regions (CIR) in the solar wind is presented. Here particles are accelerated at the forward and reverse shocks which bound the CIR by being compressed between the shock fronts and magnetic irregularities upstream from the shocks, or by being compressed between upstream irregularities and those downstream from the shocks. Particles also suffer adiabatic deceleration in the expanding solar wind, an effect not included in previous shock models for acceleration in CIRs. The model is able to account for the observed exponential spectra at Earth, the observed behavior of the spectra with radial distance, the observed radial gradients in the intensity, and the observed differences in the intensity and spectra at the forward and reverse shocks.Calculations and resulting energy spectra are also presented for shock acceleration of energetic particles in large solar flare events. Based on the simplifying assumption that the shock evolves as a spherically symmetric Sedov blast wave, the calculation yields the time-integrated spectrum of particles initially injected at the shock which eventually escape ahead of the shock into interplanetary space. The spectra are similar to those observed at Earth. Finally further applications are suggested.An invited paper presented at STIP Workshop on Shock Waves in the Solar Corona and Interplanetary Space, 15–19 June, 1980, Smolenice, Czechoslovakia.