The Cool Interstellar Medium

Infrared spectroscopy and photometry with ISO covering most of the emission range of the interstellar medium has led to important progress in the understanding of the physics and chemistry of the gas, the nature and evolution of the dust grains and also the coupling between the gas and the grains. We review here the ISO results on the cool and low-excitation regions of the interstellar medium, where T _gas≲ 500 K, n _H∼ 100–10⁵ cm⁻³ and the electron density is a few 10⁻⁴. JEL codes: D24, L60, 047 Based on observations with ISO, an ESA project with instruments funded by ESA Member States (especially the PI countries: France, Germany, The Netherlands, and the United Kingdom), and with the participation of ISAS and NASA.     

Trace constituents measurements deduced from spectrometric observations on-board spacelab

The observation of infrared absorption lines by means of a grille spectrometer on board Spacelab 1 allows the determination of Co₂ and CO in the low thermosphere and in the middle atmosphere. Equal abundances of CO and CO₂ are found at 115 ± 5 km altitude. CO₂ is observed to depart from its homospheric volume mixing ratio near 100 km, dropping by a factor of 10,15 km higher. The CO largest number density is observed near 70 km altitude, close to the H Lyman alpha photoproduction peak.The analysis of one run dedicated to the observation of water vapor shows a middle atmospheric mixing ratio of this species within the limits : 3 to 8 ppmv up to 70 km altitude, with the indication of an increase from 30 to 50 km altitude. The H₂O mixing ratio drops very rapidly above 70 km.The comparison of the results from strong and weak H₂O and CO₂ lines shows the need to refine the line profile model.     

Hard X-ray spectral properties and discovery of narrow annihilation line in the spectrum of Nova Muscae

The observations of X-ray Nova in Musca (GRS1124-684) by two coded mask telescopes on board GRANAT observatory provided spectral data in broad 3 – 1300 keV band. During these observations, spanned over a year, the Nova was detected in a three apparently different spectral states, corresponding to different epochs of the soft X-ray light curve: (1) A spectrum with two distinct components (soft, below 8 keV and hard power law tail with slope 2.5, detected up to 300 keV). The soft emission changed gradually with characteristic decay time around 30 days, while power law component exhibited strong variability on the time scales of several hours and decreased much more slowly. (2) A soft spectrum (without hard power law tail), observed during the “kick” of the soft X-ray light curve. (3) A hard power law spectrum with slope 2.2. Thus, while the 3 – 300 keV luminosity decreased by more than order of magnitude, the source passed through all spectral states known for galactic black hole candidates (Cyg X-1, GX339-4, 1E1740.7-2942, GRS1758-258 etc.).

On January 20–21 1991, the SIGMA telescope aboard GRANAT detected a relatively narrow variable emission line near 500 keV (Fig.1,2) with net flux ≈ 6 · 10⁻³ phot/s/cm², most probably related with electron-positron annihilation processes, occurring in the source /1–4/. Additional excess above power law continuum, centered around 200 keV, was found during this observation.     

SIGMA/GRANAT observations of hard X-ray emission from type I X-ray bursters

Unlike black hole candidate systems, accreting neutron stars seem to encounter appreciable difficulties in emitting strong hard X-ray fluxes. However, in the catalogue of the hard X-ray sources detected by SIGMA, three sources are associated with type I X-ray bursters. In this paper, we review the present status of the SIGMA observations of these three X-ray burst sources, namely X 1724-308 in the globular cluster Terzan II, KS 1731-260, and GX 354+0.     

The pharao project: Towards a space clock using cold cs atoms

For several years, the “BNM-Laboratoire Primaire du Temps et des Fréquences” has worked on a cold atom frequency standard. With a cesium atomic fountain a resonance line width of 700 mHz has been obtained leading to a short-term stability of 2 × 10⁻¹³ τ^−1/2 down to 2 × 10⁻¹⁵ at 10⁴ s. A first evaluation of the fountain accuracy has been performed resulting in an accuracy of 3 × 10⁻¹⁵, three times better than previously achieved with thermal beams frequency standards. In the atomic fountain, gravity limits the interaction time to ˜1 s, hence the resonance line width to ˜0.5 Hz. A factor of 10 reduction in the line width could be obtained in a micro-gravity environment. The “Centre National d'Etudes Spatiales” (the French space agency), the “BNM-Laboratoire Primaire du Temps et des Fréquences”, the “Laboratoire de l'Horloge Atomique” and the “Laboratoire Kastler Brossel” have set up a collaboration to investigate a space frequency standard using cold atoms: the PHARAO project. A microgravity prototype has been constructed and operated first in the reduced gravity of aircraft parabolic flights in May 1997. It is designed as a transportable frequency standard. The PHARAO frequency standard could be a key element in future space missions in fundamental physics such as SORT (solar orbit relativity test), detection of gravitational waves, or for the realization of a global time scale and a new generation of positioning system.     

The observations of AGNs in the 40–1300 keV energy range by the SIGMA telescope

The SIGMA telescope realizes images of the sky in the hard X-ray domain (40 keV–1.3 MeV) through a coded mask system. The extragalactic study was one of the main objectives and has brought new results in our knowledge of the Active Galactic Nuclei behavior at high energy.

In fact, the variability is the most important factor as all these objects have been showed to display strong evolution in intensity or/and spectral shape. Moreover, the discovery of a new hard X-ray source close to 3C273 and probably strongly absorbed below 40–50 keV could have many consequences in the extragalactic field.     

遥感图像的显著-概要特征提取与目标检测

针对巨幅遥感图像的目标检测问题,提出了一种基于显著-概要特征的遥感图像自动目标检测算法.采用滑动窗口将巨幅遥感图像划分为若干个小尺度的区域,针对各个小尺度分块图像,借鉴人类视觉生理功能特性之原理,提取其显著特征和概要特征,其中的显著特征代表了图像中的显著信息及显著区域空间分布和关联信息,概要特征可从整体上反映该区域的背景/目标关联信息.通过对分块区域图像的分类鉴别以实现目标检测.实验结果表明:此方法能以高可靠性和高精确度检测出巨幅遥感图像中的目标.     

Regolith-derived ferrosilicon as a potential feedstock material for wire-based additive manufacturing

Ferrosilicon is a primary metallic alloy produced during the reduction of metal oxides contained in lunar and Martian regolith by a variety of techniques. This study examines the usefulness of ferrosilicon as a candidate feedstock material for wire-based 3D printers designed for in-space manufacturing. Alloys of composition ranging from pure iron to 12?wt% Si were synthesized and their electrical and mechanical properties characterized. The melts were cast into rods for mechanical testing to determine ultimate strength and ductility. It was determined that the samples above 3?wt% Si were too brittle to be pulled into wire and ruptured at low strain values. The 3?wt% Si sample and iron had comparable mechanical properties relative to samples of higher silicon content but with differences in ductility and ultimate strength. Microstructure and compositional studies revealed the differences between the ductile and brittle samples as being the complete ferrite phase presence on the iron and low-Si content samples. This study establishes an upper limit on the Si content at 3?wt% in ferrosilicon materials to be used in wire feedstock in additive manufacturing for in-space applications.