一种新颖的瞬时浮点放大器

介绍了瞬时浮点放大器的原理及构成，并给出一种结构新的具有２５６阶的瞬时浮点放大器，可有效地提高数据采集系统的测量范围。     

A three-dimensional plasma and energetic particle investigation for the wind spacecraft

This instrument is designed to make measurements of the full three-dimensional distribution of suprathermal electrons and ions from solar wind plasma to low energy cosmic rays, with high sensitivity, wide dynamic range, good energy and angular resolution, and high time resolution. The primary scientific goals are to explore the suprathermal particle population between the solar wind and low energy cosmic rays, to study particle accleration and transport and wave-particle interactions, and to monitor particle input to and output from the Earth's magnetosphere.Three arrays, each consisting of a pair of double-ended semi-conductor telescopes each with two or three closely sandwiched passivated ion implanted silicon detectors, measure electrons and ions above 20 keV. One side of each telescope is covered with a thin foil which absorbs ions below 400 keV, while on the other side the incoming <400 keV electrons are swept away by a magnet so electrons and ions are cleanly separated. Higher energy electrons (up to 1 MeV) and ions (up to 11 MeV) are identified by the two double-ended telescopes which have a third detector. The telescopes provide energy resolution of E/E0.3 and angular resolution of 22.5°×36°, and full 4 steradian coverage in one spin (3 s).Top-hat symmetrical spherical section electrostatic analyzers with microchannel plate detectors are used to measure ions and electrons from 3 eV to 30 keV. All these analyzers have either 180° or 360° fields of view in a plane, E/E0.2, and angular resolution varying from 5.6° (near the ecliptic) to 22.5°. Full 4 steradian coverage can be obtained in one-half or one spin. A large and a small geometric factor analyzer measure ions over the wide flux range from quiet-time suprathermal levels to intense solar wind fluxes. Similarly two analyzers are used to cover the wide range of electron fluxes. Moments of the electron and ion distributions are computed on board.In addition, a Fast Particle Correlator combines electron data from the high sensitivity electron analyzer with plasma wave data from the WAVE experiment (Bougeretet al., in this volume) to study wave-particle interactions on fast time scales. The large geometric factor electron analyzer has electrostatic deflectors to steer the field of view and follow the magnetic field to enhance the correlation measurements.     

铸造SiCp／ZL101复合材料的组织与性能

本文利用半固态搅拌铸造法制备了ＳｉＣｐ／ＺＬ１０１复合材料，对其组织和某些性能进行了研究，结果表明：ＳｉＣｐ在基体中分布均匀，无严重团聚现象，与基体结合良好，与基体合金相比，耐磨性，硬度有显著提高。     

空中受油管的绕流特性研究

空中加油是提高飞机航程、活动半径的重要方法。通过对四种固定受油管的数值模拟,从流动特性的改进方面说明了合适的截面及倾角会降低受油管绕流的压力脉动,进而使噪声降低。     

直升机滑油换热器的结构优化设计

在直升机肋管式滑油换热器的初步热力性能设计计算基础上,应用数值优化原理,对滑油换热器结构的优化设计进行了研究,建立了结构优化程序.该程序以滑油换热器的重量为目标函数,采用正弦法去约束并结合单纯形加速法寻优.实例计算表明,将滑油换热器的热力性能计算程序同结构优化程序结合起来,可以建立自动匹配的换热器设计及优化程序系统.应用该软件,输入设计要求,就可获得既满足性能要求,且重量最轻的肋管式滑油换热器.该软件可推广应用于各种类型肋管式换热器.     

对旋轴流风机非定常流场数值模拟

利用全隐格式的非稳态压力修正求解方法,分析和研究了对旋叶轮级间流场非定常流动情况,上游尾迹与下游叶片位势作用对流场的影响,并与动态实验结果进行了有益的对比.结果表明:非定常流场的计算更能反映叶轮机实际运行性能,如果能很好地组织对旋叶轮的非定常流动,还可以进一步提高其压比和效率.     

低温度系数标准电阻器的研制

主要介绍了低温度系数标准电阻器的研制,包括采用的电阻合金材料、电阻合金材料的筛选、匹配与加工制作,低温度系数标准电阻器的技术参数、温度系数测量方法,减小温度系数采用的补偿方法,测试结果分析。     

快速预热型铷原子振荡器的研制

介绍了一种快速预热型铷原子振荡器的设计方法和试验数据 ,3 5min的锁定时间、0 4 5L的小巧体积和良好的频率重现性能 ,非常适合于战术应用。     

双脉冲瞬态散斑全场测量方法研究CSCD

散斑测量技术在瞬态振动过程测量中具有不可或缺的重要地位。提出双脉冲瞬态散斑全场测量技术，解决了双脉冲激光器与双曝光相机的时序同步的关键技术，设计了基于双脉冲激光器的瞬态散斑光路系统，搭建了双脉冲瞬态散斑全场测量系统，从而实现了（2~800）μs 时间间隔内连续可调的瞬时振动形貌的测量。     

激光点火系统损耗检测温度误差补偿方法

点火通路损耗检测精度是激光点火系统的一个重要指标,其在很大程度上决定着点火系统状态判断的准确性.针对激光点火系统损耗检测精度随温度变化的问题,对不同温度条件下激光点火系统的点火通路损耗检测精度进行了分析.分析结果表明,探测器暗电流、运放输入偏置电流和输入失调电压等均会影响检测精度,且检测偏差随温度升高而增大.建立了点火通路损耗检测温度误差模型,在-40℃～75℃范围内,采用温度误差模型进行补偿后,火工品发火前的损耗检测偏差(峰峰值)从0.62dB减小为0.16dB,火工品发火后的损耗检测偏差(峰峰值)从1.45dB减小为0.30dB,提高了损耗检测的精度,为判断是否具备发火条件及发火状态提供了有效支撑.