Scientific Planning and Commanding of the Rosetta Payload

ESA’s Rosetta mission was launched in March 2004 and is on its way to comet 67P/Churyumov-Gerasimenko, where it is scheduled to arrive in summer 2014. It comprises a payload of 12 scientific instruments and a Lander. All instruments are provided by Principal Investigators, which are responsible for their operations. As for most ESA science missions, the ground segment of the mission consists of a Mission Operations Centre (MOC) and a Science Operations Centre (SOC). While the MOC is responsible for all spacecraft-related aspects and the final uplink of all command timelines to the spacecraft, the scientific operations of the instruments and the collection of the data and ingestion into the Planetary Science Archive are coordinated by the SOC. This paper focuses on the tasks of the SOC and in particular on the methodology and constraints to convert the scientific goals of the Rosetta mission to operational timelines.     

MEMS Electronically Steerable Antennas for Fire Control Radars

Large apertures are of great benefit to applications that are prime powered limited as is found on aerostat and other airborne platforms. Electronically scanned array antennas are often proposed for these applications. However, increasing the aperture area with conventional array technology is met with prohibitive cost, weight, and prime power increases because of the dense spacing of phase shifters and/or active T/R modules. This discusses the recent development of RF MEMS (Microelectromechanical System) switch technology and the use of these switches in a Radanttrade lens configuration for arrays of approximately 10 m² at X-band. A proof-of-concept 0.4 m² MEMS Electronically Steerable Antenna (ESA) containing 25,000 MEMS switches has been successfully designed, fabricated, and tested. The 0.4 m² MEMS ESA was then integrated with an AN/APG-67 radar system to form the MEMS Demonstration Radar System. The MEMS Demonstration Radar System successfully detected both airborne and ground moving targets during a series of extensive radar demonstrations. This is believed to be the first large scale employment of MEMS switches in a scanning antenna and radar system. The low-cost, lightweight, and low power technology demonstrated can enable weight and power constrained platforms with electronic steering.     

Spectroscopic Measurement of Coronal Compositions

Although the elemental composition in all parts of the solar photosphere appears to be the same this is clearly not the case with the solar upper atmosphere (SUA). Spectroscopic studies show that in the corona elemental composition along solar equatorial regions is usually different from polar regions; composition in quiet Sun regions is often different from coronal hole and active region compositions and the transition region composition is frequently different from the coronal composition along the same line of sight. In the following two issues are discussed. The first involves abundance ratios between the high-FIP O and Ne and the low-FIP Mg and Fe that are important for meaningful comparisons between photospheric and SUA compositions and the second involves a review of composition and time variability of SUA plasmas at heights of 1.0≤h≤1.5R _⊙.     

Possibilities of parallel calculations in solving gas dynamics problems in the CFD environment of FLUENT software

The results of studying an incompressible gas flow field in a periodic element of the porous structure made up of the same radius spheres are presented; the studies were based on the solution of the Navier-Stokes equations using FLUENT software. The possibilities to accelerate the solution process with the use of parallel calculations are investigated and the calculation results under changes of pressure differential in the periodic element are given.     

Problems of application of face gasodynamic seals in aircraft engines

Problems arising in introduction of gasodynamic seals in aircraft engines are considered. The operation of a face gasodynamic seal as part of a natural gas pump is analyzed and its efficiency in the presence of oil is shown.     

Two years of INTEGRAL observation of the BHC IGR J17464-3213

On March 2003, IBIS, the γ-ray imager on board the INTEGRAL satellite, detected an outburst from a new source, IGR J17464-3213, that turned out to be an HEAO-1 transient, namely H1743-322. The spectral and temporal evolutions of the source were observed by INTEGRAL in different periods. Also RXTE observed the source for the first time on 2003 March 29 during a PCA Galactic bulge scan. The source flux decayed below the RXTE PCA sensitivity limit in November 2003, then in April 2004 it was again detected by INTEGRAL. On July 3, 2004 the source was again detected by RXTE/PCA at a 2–10 keV intensity of 16 mCrab and on July 7, reached 69 mCrab. Recently, a new outburst was observed on August 2005. We briefly summarise here the behaviour of the source observed by INTEGRAL from March 2003 to August 2005. The new outbursts of the source and the analysis of all the data collected (now public) give a global view of the spectral and time behaviour of this X-ray transient.     

Unmanned aircraft navigation for shipboard landing using infrared vision

This paper addresses the problem of determining the relative position and orientation of an unmanned air vehicle with respect to a ship using three visible points of known separation. The, images of the points are obtained from an onboard infrared camera. The paper develops a numerical solution to this problem. Both simulation and flight test results are presented.     

The J-MASS Marketplace: a new way for DoD to do business

It is current DoD policy to use commercial off-the-shelf software whenever it meets DoD requirements. The application of this policy to modeling and simulation has resulted in the concept of “The Joint Modeling and Simulation System (J-MASS) Marketplace.” J-MASS is designed as an Open Systems Architecture with the capability for the Simulation Support Environment (SSE) to be expanded by the addition of site specific software. In the “J-MASS Marketplace” industry will build commercial tools to work with J-MASS and individual organizations will license what they need for their particular site. The J-MASS SSE is a framework or backplane into which everything else plugs. A J-MASS product release would have the core capabilities, but the unique needs of various organizations would be satisfied by industry. This paper addresses how the J-MASS Marketplace could work and how compliance can be defined. It will outline opportunities for industry in both building software for the Marketplace and in defining the Marketplace concept     

Features of active sidestick controllers

This paper discusses the advantages of incorporating active sidesticks into a modern aircraft cockpit. Active sidestick controllers for manual pilot inputs in pitch and roll are examined for commercial transport aircraft. Options and requirements for sidesticks are reviewed. The recommendation of an active sidestick controller is developed providing both cross-cockpit coupling and autopilot backdrive capability. These characteristics provide pilot cues identical to traditional cable-linked column/yoke configurations     

Methodologies in user interface design

Software applications that require a high learning curve, a mountain of documentation, and weeks of training should be things of the past. Today's applications need to be simple to learn and to use. The human/computer interface should be intuitive and consistent. Context sensitive help should be available to keep the user on track. This paper provides some guidelines for taking commercial world concepts and applying them to the Automatic Test Equipment world. Examples included are from the Integrated Maintenance Information System (IMIS)