微叠层材料及其制备工艺研究进展

着重论述了各种微叠层材料及其制备方法，认为电子束物理气相沉积是制备微叠层材料的有效方法：同时对微叠层材料性能方面的研究也作了相应的论述，并展望了我国今后在这方面的研究方向。     

FL—23风洞洞壁对跨声速颤振的干扰影响

本文提供了在FL-23风洞中进行的试验研究结果。试验采用动力相似的四种不同尺寸的60°三角机翼平板半模型。结果表明:洞壁干扰提高了跨声速颤振临界速压,当模型展长对试验段宽度的比值Lm/B为0.687、0.600和0.512时,使颤振临界速度的压缩性修正系数分别减小3.8％、2.5％和1.4％。改变开孔率的试验定性验证了上述结果的合理性。     

Improving ESPRIT via beamforming

Beamforming techniques are presented that improve the performance of the ESPRIT (estimation of signal parameters via rotational invariance techniques) algorithm for solving the narrowband multiple source location problem with uniform linear arrays. Using ESPRIT with these beamforming approaches maintains the computational advantage of the original ESPRIT while further exploiting the special structure of uniform linear arrays. Simulation results show that the use of ESPRIT with beamforming yields significantly improved performance compared with the original ESPRIT     

复合材料动模量振动测定方法的研究

 本文采用Timoshenko梁理论,首次导出了悬臂梁和自由-自由梁自由端具有附加质量的特征方程,并进而讨论了多种因素对动模量计算值的影响。此外还提出了用弯曲振动确定剪切动模量G_(12)的一般方法。最后进行了实例分析和讨论。     

空-空导弹全向攻击最优制导规律研究

 将发射瞬时所确定的平行接近弹道作为基准弹道,由于各种干拢所引起的相对于基准弹道的偏离作为偏差来处理;用最优控制理论导出空-空导弹进行全向攻击的最优制导律,此制导律包含目标加速度反馈。当目标作非机动飞行时,最优制导律是一种变比例系数的比例制导。数字仿真结果表明:在相同条件下,最优制导弹道需用过载、终端脱靶量均小于比例制导,特别是从目标前方攻击时,其制导精度大大优于比例制导。     

金属图象分割的研究

结合金属图象的特点,利用传统阚值分割技术和基于最大熵原则的图象分割技术对金属图象分割进行了分析;并根据金属图象分析要求,提出了先二值化金属图象再进行边缘提取的方法.对比实验结果表明,基于最大熵原则的图象分割技术可以获得较好的分割效果,所提出的方法能够获得连续闭合的晶粒边缘,为下一步的金属图象分析提供了可靠的依据.     

多径衰落条件下两种常规测向方法的误差问题

讨论了莱斯多径衰落信道模型在两类常规测向技术中的应用。利用常规测向技术对信噪比的特定要求,分析了具有莱斯分布特性衰落信道对比相、比幅测向误差抖动的影响,给出了其分布函数,并通过仿真指出其应用限制。最后就工程应用中所关心的模型参数获取和采样点数确定等问题作一论述。     

Investigation of corona initiation voltage at reduced pressures

The results of an experimental study of the 60 Hz ac corona inception voltage at reduced pressures for a cylindrical conductor and a parallel ground plane are presented. Several spacings and bare and insulated conductors of several diameters are considered. Empirical expressions from which a reasonably accurate prediction of the corona inception voltage (CIV) may be made have been inferred from experimental data     

A recursive multiple model approach to noise identification

Correct knowledge of noise statistics is essential for an estimator or controller to have reliable performance. In practice, however, the noise statistics are unknown or not known perfectly and thus need to be identified. Previous work on noise identification is limited to stationary noise and noise with slowly varying statistics only. An approach is presented here that is valid for nonstationary noise with rapidly or slowly varying statistics as well as stationary noise. This approach is based on the estimation with multiple hybrid system models. As one of the most cost-effective estimation schemes for hybrid system, the interacting multiple model (IMM) algorithm is used in this approach. The IMM algorithm has two desirable properties: it is recursive and has fixed computational requirements per cycle. The proposed approach is evaluated via a number of representative examples by both Monte Carlo simulations and a nonsimulation technique of performance prediction developed by the authors recently. The application of the proposed approach to failure detection is also illustrated     

一种新颖的瞬时浮点放大器

介绍了瞬时浮点放大器的原理及构成，并给出一种结构新的具有２５６阶的瞬时浮点放大器，可有效地提高数据采集系统的测量范围。