An evolutionary computational framework for capacity-safety trade-off in an air transportation network

Airspace safety and airport capacity are two key challenges to sustain the growth in Air Transportation. In this paper, we model the Air Transportation Network as two sub-networks of airspace and airports, such that the safety and capacity of the overall Air Transportation network emerge from the interaction between the two. We propose a safety-capacity trade-off approach,using a computational framework, where the two networks can inter-act and the trade-off between capacity and safety in an Air Transport Network can be established. The framework comprise of an evolutionary computation based air traffic scenario generation using a flow capacity estimation module(for capacity), Collision risk estimation module(for safety) and an air traffic simulation module(for evaluation). The proposed methodology to evolve air traffic scenarios such that it minimizes collision risk for given capacity estimation was tested on two different air transport network topologies(random and small-world) with the same number of airports. Experimental results indicate that though airspace collision risk increases almost linearly with the increasing flow(flow intensity) in the corresponding airport network, the critical flow depend on the underlying network configuration. It was also found that, in general, the capacity upper bound depends not only on the connectivity among airports and their individual performances but also the configuration of waypoints and mid-air interactions among conflicts. Results also show that airport network can accommodate more traffic in terms of capacity but the corresponding airspace network cannot accommodate the resulting traffic flow due to the bounds on collision risk.     

纳米复合镍粉雷达吸波涂层研究

采用机械化学法将纳米SiC包覆在镍粉表面制备复合吸波材料,将该材料喷涂在基体上制备吸波涂层,并研究了SiC在复合材料中的含量变化对涂层吸波性能的影响.研究表明,SiC含量为10%时,纳米复合涂层的吸波性能最佳.与镍粉吸波涂层相比,该纳米复合涂层中频段的吸波性能明显提高,发射率小于-5 dB的带宽由7 GHz增加到10.4 GHz,涂层最高吸收值达到-23.4 dB.     

TC11合金高温变形行为及其机理

采用Gleeble-1500热模拟机研究了TC11合金在800～1 050℃、应变速率0.005～5/s条件下的高温变形行为.根据动力学分析,确定了不同温度区间的热激活能和热变形方程.结合变形微观组织观察确定了TC11合金的高温变形机制.结果显示:TC11合金在(α β)两相区和β相区的热变形激活能分别为285.38和141.98 kJ/mol,表明不同温度区间的热变形机理不同;在两相区变形主要发生片状组织的球化,在β相区变形时低应变速率下(0.005～0.05/s)主要发生β相的动态再结晶,高应变速率下(0.05～5/s)主要发生动态回复.研究结果为确定该合金的最佳变形工艺参数提供了理论依据.     

AZ91镁合金搅拌摩擦加工后的组织与性能

采用400rpm-100mm/min,800rpm-100mm/min,800rpm-200mm/min三种工艺参数对铸态AZ91镁合金进行搅拌摩擦加工(FSP)处理,并对合金加工前后的显微组织和拉伸性能及微观断裂机制进行分析。结果表明,经800rpm-100mm/min工艺FSP处理后,合金的显微组织明显细化,延伸率和抗拉强度显著提高,综合拉伸性能最好,且拉伸断口主要表现为韧性断裂的特征。这主要是由于在FSP过程中合金发生动态再结晶,使合金晶粒显著细化及粗大β相的溶解和破碎所致。     

山特维克可乐满CoroPak08.2新品亮相CIMES 2008

山特维克可乐满是山特维克集团旗下最大的金属切削刀具公司,是全球金属切削行业的领导品牌。作为全球排名第一的金属切削业刀具制造和供应商,山特维克可乐满始终致力于提升制造业的综合实力,并为客户不断提供创新的高效率金属切削刀具和解决方案。金秋9月新鲜     

HBM测量系统在航空航天中的应用

RUAG公司用HBM测量系统进行飞机全尺寸疲劳试验瑞士RUAG公司的研究人员对瑞士版F/A-18战斗机的加强结构进行了大规模的综合试验研究,以验证飞机结构是否能满足较高的要求,达到所需的5000个飞行小时的工作寿命。     

昆虫翅悬停飞行中的三维空间旋涡结构

昆虫(果蝇)悬停飞行中,翅膀按照特定的拍动方式往复运动,产生非定常高升力维持身体的平衡.研究昆虫高升力机理,需要探索拍动翼运动引发的三维空间非定常流场的特性,尤其是三维空间非定常涡的发展变化过程.本文将氢气泡流动显示技术应用于动态模型实验,定性的观察拍动翼前缘涡(LEV)的发展破裂过程.并利用数字体视粒子图像测速,DSPIV(Digital Steroscopic Particle Image Velocimetry)技术,测得了拍动翼运动瞬时相位和相位平均的三维空间流场信息(速度向量场、截面涡量场、空间涡量场,以及三维空间流线),揭示了拍动翼展向流动的存在,并结合定性和定量方法多角度说明了前缘涡沿展向发展到破裂的流动结构,并说明了侧缘涡与前缘涡的相互影响.测量结果表明:在雷诺数960的情况下,拍动翼运动至相位时,翼面上前缘涡在距翼根约60%展长的位置发生破裂;翼根至破裂点之间,展向流动稳定,指向翼梢;破裂点以后,展向流改变方向,指向翼根.     

The Electric Antennas for the STEREO/WAVES Experiment

The STEREO/WAVES experiment is designed to measure the electric component of radio emission from interplanetary radio bursts and in situ plasma waves and fluctuations in the solar wind. Interplanetary radio bursts are generated from electron beams at interplanetary shocks and solar flares and are observed from near the Sun to 1 AU, corresponding to frequencies of approximately 16 MHz to 10 kHz. In situ plasma waves occur in a range of wavelengths larger than the Debye length in the solar wind plasma λ _D ≈10 m and appear Doppler-shifted into the frequency regime down to a fraction of a Hertz. These phenomena are measured by STEREO/WAVES with a set of three orthogonal electric monopole antennas. This paper describes the electrical and mechanical design of the antenna system and discusses efforts to model the antenna pattern and response and methods for in-flight calibration.     

The Plasma and Suprathermal Ion Composition (PLASTIC) Investigation on the STEREO Observatories

The Plasma and Suprathermal Ion Composition (PLASTIC) investigation provides the in situ solar wind and low energy heliospheric ion measurements for the NASA Solar Terrestrial Relations Observatory Mission, which consists of two spacecraft (STEREO-A, STEREO-B). PLASTIC-A and PLASTIC-B are identical. Each PLASTIC is a time-of-flight/energy mass spectrometer designed to determine the elemental composition, ionic charge states, and bulk flow parameters of major solar wind ions in the mass range from hydrogen to iron. PLASTIC has nearly complete angular coverage in the ecliptic plane and an energy range from ～0.3 to 80 keV/e, from which the distribution functions of suprathermal ions, including those ions created in pick-up and local shock acceleration processes, are also provided.     

The THEMIS Array of Ground-based Observatories for the Study of Auroral Substorms

The NASA Time History of Events and Macroscale Interactions during Substorms (THEMIS) project is intended to investigate magnetospheric substorm phenomena, which are the manifestations of a basic instability of the magnetosphere and a dominant mechanism of plasma transport and explosive energy release. The major controversy in substorm science is the uncertainty as to whether the instability is initiated near the Earth, or in the more distant >20 Re magnetic tail. THEMIS will discriminate between the two possibilities by using five in-situ satellites and ground-based all-sky imagers and magnetometers, and inferring the propagation direction by timing the observation of the substorm initiation at multiple locations in the magnetosphere. An array of stations, consisting of 20 all-sky imagers (ASIs) and 30-plus magnetometers, has been developed and deployed in the North American continent, from Alaska to Labrador, for the broad coverage of the nightside magnetosphere. Each ground-based observatory (GBO) contains a white light imager that takes auroral images at a 3-second repetition rate (“cadence”) and a magnetometer that records the 3 axis variation of the magnetic field at 2 Hz frequency. The stations return compressed images, “thumbnails,” to two central databases: one located at UC Berkeley and the other at the University of Calgary, Canada. The full images are recorded at each station on hard drives, and these devices are physically returned to the two data centers for data copying. All data are made available for public use by scientists in “browse products,” accessible by using internet browsers or in the form of downloadable CDF data files (the “browse products” are described in detail in a later section). Twenty all-sky imager stations are installed and running at the time of this publication. An example of a substorm was observed on the 23rd of December 2006, and from the THEMIS GBO data, we found that the substorm onset brightening of the equatorward arc was a gradual process (>27 seconds), with minimal morphology changes until the arc breaks up. The breakup was timed to the nearest frame (<3 s) and located to the nearest latitude degree at about ±3^oE in longitude. The data also showed that a similar breakup occurred in Alaska ～10 minutes later, highlighting the need for an array to distinguish prime onset.