Activation of the tail open part during the magnetospheric storm

In each polar cap (PC) we mark out “old PC” observed during quiet time before the event under consideration, and “new PC” that emerges during the substorm framing the old one and expanding the PC total area. Old and new PCs are the areas for the magnetosphere old and new tail lobes, respectively. The new lobe variable magnetic flux Ψ₁ is usually assumed to be active, i.e. it provides the electromagnetic energy flux (Poynting flux) ɛ′ transport from solar wind (SW) into the magnetosphere. The old lobe magnetic flux Ψ₂ is supposed to be passive, i.e. it remains constant during the disturbance and does not participate in the transporting process which would mean the old PC electric field absolute screening from the convection electric field created by the magnetopause reconnection. In fact, screening is observed, but far from absolute. We suggest a model of screening and determine its quantitative characteristics in the selected superstorm. The coefficient of a screening is the β = Ψ₂/Ψ₀₂, where Ψ₀₂ = const is open magnetic flux through the old PC measured prior to the substorm, and Ψ₂ is variable magnetic flux through the same area measured during the substorm. We consider three various regimes of disturbance. In each, the coefficient β decreased during the loading phase and increased at the unloading phase, but the rates and amplitudes of variations exhibited a strong dependence on the regime. We interpreted decrease in β as a result of involving the old PC magnetic flux Ψ₂, which was considered to be constant earlier, in the Poynting flux ɛ′ transport process from solar wind into the magnetosphere. Transport process weakening at the subsequent unloading phase creates increase in β. Estimates showed that coefficient β during each regime and the computed Poynting flux ɛ′ varied manifolds. In general, unlike the existing substorm conception, the new scenario describes an unknown earlier of tail lobe activation process during a substorm growth phase that effectively increases the accumulated tail energy for the expansion and recovery phases.     

Experimental drop tube of the metallurgy department of Grenoble

The drop tube which will be available in the “Centre d'Etudes Nucléaires de Grenoble” is described. Its main features are the following: - Dimensions : Drop height : 47.1 m Drop time : 3.1 s Tube inside diameter : 0.2 m - Experimental atmosphere : 1 Ultra-vacuum : 10⁻⁶ to 10⁻⁷ Pa - Residual gravity level : 10⁻⁸ to 10⁻⁹ g according to the vacuum level and drop diameter.

This facility is unique insofar as it enables experiments to be performed under ultra-vacuum conditions which, by delaying the formation of surface oxides, should contribute to improving maximum undercooling values.

The techniques used for obtaining small metallic drops (0.5 to 3 mm) are described. The availability of this instrument for the scientific community is also foreseen by the french sponsoring organizations (CEA, CNES, CNRS) ; some practicle informations will be given to potential experimenters.     

A Closely Regulated TWT Converter

The design concept for the traveling wave tube amplifier converter for possible use in the Thermoelectric Outer Planet Spacecraft (TOPS) is presented. An unusual combination of semiconductors and magnetics were utilized to achieve very stable voltage regulation on a number of separate outputs to satisfy the requirements of a high-power traveling wave tube (TWT), and at the same time operate at an efficiency of better than 90 percent from a 30-volt source. The circuitry consists of an output filter, an auxiliary Jensen oscillator driving a high-reactance transformer to provide current limiting to the heater, a variable time delay, a main Jensen oscillator driving the power transformer with a maximum step-up ratio of 120 to 1, and series transistorized post regulators to provide precise voltage adjustment and low output impedance. This paper discusses the design of the high-reactance transformer and the high step-up ratio transformer, as well as the high-voltage series regulators that are limited in range and operate at the top of the unregulated output voltage. Test data is presented, and details of current transients caused by charging the filter circuits, input current ripple, and output voltage ripples are considered. The circuit provides better than 0.5 percent regulation against load change, input voltage change, and over-operating temperature range of from -20 to + 80°C, with output ripple voltage of less than 2 volts peak-to-peak on top of the 3600-Vdc output. The measured efficiency was typically 87 percent. and recommendations are included to improve this to in excess of 90 percent.     

A Correlation Polarimeter for Noise-Like Signals

Optimum estimation (tracking) of the polarization plane of a linearly polarized electromagnetic wave is determined when the signal is a narrow-band Gaussian random process with a polarization plane angle which is also a Gaussian random process. This model is Compared to previous work and is applicable to space communication. The estimator performs a correlation operation similar to an amplitude -comparison monopulse angle tracker, giving the name correlation polarimeter. Under large signal-to-noise ratio (SNR), the estimator is causal. Performance of the causal correlation polarimeter is evaluated for arbitrary SNR. Optimum precorrelation filtering is determined. With low SNR, the performance of this system is far better than that of previously developed systems. Practical implementation is discussed. A scheme is given to reduce the effect of linearly polarized noise.     

Pitch angle diffusion as seen by CRRES

Lifetimes and pitch angle distributions of radiation belt electrons injected into the slot region are determined from CRRES/MEA particle flux measurements. The dominant loss mechanism is presumed to be pitch angle scattering due to whistler waves, for which a theoretical formulation is available. The empirical lifetimes are compared to those from recent calculations, which rely on model whistler wave parameters. CRRES measurements of cyclotron-frequency electric fields are also presented and compared to the wave model.     

The INFRARED SPACE OBSERVATORY (ISO)

The INFRARED SPACE OBSERVATORY (ISO), a project of the European Space Agency (ESA), will make various astronomical observations in the wavelength range of 2 to 200 μm. Two-thirds of its observing time will be available to guest observers via the traditional route of proposal submission. ISO will be launched in 1995 by an Ariane 4 from Kourou (Guyana) and be brought into a very elongated orbit with a 24hr period of which 16 hr can be used for astronomical observations. The payload module is essentially a large cryostat with a tank that will be filled with over 2000 litres of superfluid helium to keep the instruments cold (2 to 4 K) during an expected lifetime of 18 months. Inside the dewar, there is a Ritchey-Chretien telescope with a primary mirror of diameter 60cm. Four instruments, each provided by a different PI consortium, share the ISO focal plane. These instruments are : a photometer, a camera and two spectrometers — one for the wavelength range 2–45 μm and the other for 45–180 μm.     

Engineering concepts for inflatable Mars surface greenhouses.

A major challenge of designing a bioregenerative life support system for Mars is the reduction of the mass, volume, power, thermal and crew-time requirements. Structural mass of the greenhouse could be saved by operating the greenhouse at low atmospheric pressure. This paper investigates the feasibility of this concept. The method of equivalent system mass is used to compare greenhouses operated at high atmospheric pressure to greenhouses operated at low pressure for three different lighting methods: natural, artificial and hybrid lighting.     

Surface tension-driven flows in horizontal liquid metal layers

The problem of surface tension-driven flows in horizontal liquid layers has been studied experimentally, and theoretically by direct numerical simulation and small perturbation analysis. We focus our attention on situations in which the depth of the fluid (liquid tin; small Prandtl number, Pr=0.015) is small enough to ensure the predominance of the surface tension forces over those due to the buoyancy. The surface velocity has been experimentally obtained for liquid tin layer with various aspect ratio (length to height) in the range 5<A<83. The thermal gradients are ranged from 5 to 40°K/cm. In the numerical study, the Navier-Stokes and energy equations are solved by an efficient finite difference technique. The parameters governing the flow behaviour in the liquid are varied to determine their effects on thermocapillary convection: the Reynolds number 10<Re<210⁴ and the aspect ratio 2<A<25; with Pr kept constant at Pr=0.015. The linear eigenequation resulting from small spatial disturbances of the Couette flow solution is solved using an Tau-Chebyshev approximation. A notable feature of the theoretical study is the totally different end circulations. In the region near the cold wall a multicell structure is evident. This agrees with the eigensolution which is of complex type, indicating spatial periodicity. In the hot wall region the flow is accelerated to reach the velocity value for the fully-developed Couette flow which is reached under conditions such as Re/A<20. The transition from viscous to boundary layer regime occurs for a critical value (Re/A)_c of nearly about 200, as deduced from the numerical and experimental results.     

Indicators of black-hole mass and Eddington accretion ratio from QSO X-ray and UV spectra

The evolution of luminous QSOs is linked to the evolution of massive galaxies. We know this because the relic black-holes found locally have masses dependent on the properties of the host galaxy’s bulge. An important way to explore this evolution would be to measure dependences of black-hole masses and Eddington accretion ratios over a range of redshifts, i.e., with cosmological age. For low redshift QSOs (and their lower luminosity Seyfert galaxy counterparts) it has been possible to infer black-hole masses from the luminosities and velocity dispersions of their host-galaxy bulges. These masses agree with those virial black-hole masses calculated from the Doppler widths of the broad Hβ emission lines. The latter method can then be extended to more distant and luminous QSOs, up to redshifts of 0.6 with ground-based optical observations. We discuss ways to extend these explorations to higher redshifts – up to 3 using the widths of QSOs’ broad UV emission lines, and in principle, and to redshifts near 4 from ground-based infrared observations of rest-frame Hβ at 2.5 μm. We discuss the possibility of investigating the accretion history of the higher redshift QSOs using measures of Eddington accretion ratio – the soft X-ray spectral index and the eigenvectors of Principal Components Analyses of QSOs’ UV emission-line spectra.