Comet Knudsen Layers

This paper reviews some important results about Knudsen layers obtained in theoretical gas kinetics research in the last few decades, focusing on the weak and strong evaporation problems in two-surface, half-space, and spherical geometries. Furthermore, the application of such results in cometary science is reviewed. In order to illustrate some properties of the half-space evaporation problem for water ice surfaces at temperatures relevant for active comets, a number of numerical Direct Simulation Monte Carlo calculations are presented.     

Temperature comparison between CHAMP radio occultation and TIMED/SABER measurements in the lower stratosphere

Global Positioning System (GPS) receiver on the CHAllenging Mini-satellite Payload (CHAMP) and the Sounding of the Atmosphere using Broadband Emission Radiometry (SABER) instrument, one of four on board the TIMED satellite, provide middle atmosphere temperature profiles by Radio Occultation (RO) and limb viewing infrared emission measurements, respectively. These temperature profiles retrieved by two different techniques in the stratosphere are compared with each other using more than 1300 correlative profiles in March, September and December 2005. The over-all mean differences averaged over 15 and 35 km are approximately −2 K and standard deviation is less than 3 K. Below 20 km of altitude, relatively small mean temperature differences ∼1 K are observed in wide latitudinal range except for June (during the SABER nighttime observation). In the middle to low latitudes, between 30°S and 30°N, the temperature difference increases with height from ∼0–1 K at 15 km, to ∼−4 K at 35 km of altitude. Large temperature differences about −4 to −6 K are observed between 60°S and 30°N and 31–35 km of altitude for all months and between 0° and 30°N below 16 km during June (nighttime).     

Controlling factors of Region 2 field-aligned current and its relationship to the ring current: Model results

One essential component of magnetosphere and ionosphere coupling is the closure of the ring current through Region 2 field-aligned current (FAC). Using the Comprehensive Ring Current Model (CRCM), which includes magnetosphere and ionosphere coupling by solving the kinetic equation of ring current particles and the closure of the electric currents between the two regions, we have investigated the effects of high latitude potential, ionospheric conductivity, plasma sheet density and different magnetic field models on the development of Region 2 field-aligned currents, and the relationship between R2 FACs and the ring current. It is shown that an increase in high latitude potential, ionospheric conductivity or plasma sheet density generally results in an increase in Region 2 FACs’ intensity, but R2 FACs display different local time and latitudinal distributions for changes in each parameter due to the different mechanisms involved. Our simulation results show that the magnetic field configuration of the inner magnetosphere is also an important factor in the development of Region 2 field-aligned current. More numerical experiments and observational results are needed in further our understanding of the complex relationship of the two current systems.     

Self-similar stochastic processes in solar wind turbulence

Solar wind data is used to estimate the autocorrelation function for the stochastic process x(τ) = y(t + τ) − y(t), considered as a function of τ, where y(t) is any one of the quantities B²(t), n_p(t)V²(t), or n_p(t). This process has stationary increments and a variance that increases like a power law τ^2γ where γ is the scaling exponent. For the kinetic energy density and the proton density the scaling exponent is close to the Kolmogorov value γ = 1/3, for the magnetic energy density it is slightly larger. In all three cases, it is shown that the autocorrelation function estimated from the data agrees with the theoretical autocorrelation function for a self-similar stochastic process with stationary increments and finite variance. This is far from proof, but it suggests that these stochastic processes may be self-similar for time scales in the small scale inertial range of the turbulence, that is, from approximately 10 to 10³ s.     

New evidence for strong non-thermal effects in Tycho’s supernova remnant

For the case of Tycho’s supernova remnant (SNR), we present the relation between the blast wave and contact discontinuity radii calculated within the nonlinear kinetic theory of cosmic ray (CR) acceleration in SNRs. It is demonstrated that these radii are confirmed by recently published Chandra measurements which show that the observed contact discontinuity radius is very close to the shock radius. Therefore a consistent explanation of these observations can be given in terms of efficient CR acceleration which makes the medium more compressible.     

Optimal nodal flyby with near-Earth asteroids using electric sail

The aim of this paper is to quantify the performance of an Electric Solar Wind Sail for accomplishing flyby missions toward one of the two orbital nodes of a near-Earth asteroid. Assuming a simplified, two-dimensional mission scenario, a preliminary mission analysis has been conducted involving the whole known population of those asteroids at the beginning of the 2013 year. The analysis of each mission scenario has been performed within an optimal framework, by calculating the minimum-time trajectory required to reach each orbital node of the target asteroid. A considerable amount of simulation data have been collected, using the spacecraft characteristic acceleration as a parameter to quantify the Electric Solar Wind Sail propulsive performance. The minimum time trajectory exhibits a different structure, which may or may not include a solar wind assist maneuver, depending both on the Sun-node distance and the value of the spacecraft characteristic acceleration. Simulations show that over 60% of near-Earth asteroids can be reached with a total mission time less than 100 days, whereas the entire population can be reached in less than 10 months with a spacecraft characteristic acceleration of 1 mm/s².     

Balloon altitude studies of southern hemisphere hard X-ray sources by the Imperial College-University of Tasmania-INPE collaboration

Hard X-ray balloon altitude measurements with a 1600 cm² phoswich array are described. Data from observations on Sco X-1, GX1+4, GX5−1, Nova Oph. 1977, SMC X-1, SS433, IC 4329A and MR 2251-178 are presented. The role of Comptonisation in X-ray production for Sco X-1 and GX1+4 is discussed.     

An Analysis of the Low-Frequency Component in Measurements of Angular Velocity and Microacceleration onboard the Foton-12 Satellite

We compare the results of two methods used to determine the angular velocity of the Foton-12 satellite and the low-frequency component of microaccelerations onboard it. The first method is based on reconstruction of the satellite's rotational motion using the data of onboard measurements of the strength of the Earth's magnetic field. The motion (time dependence of the orientation parameters and angular velocity) was found from the condition of best approximation of the measurement data by the functions calculated along the solutions to equations of attitude motion of the satellite. The solutions found were used to calculate the quasistatic component of microaccelerations at certain points of the satellite, in particular, at the point of location of an accelerometer of the QSAM system. Filtration of the low-frequency component of the angular velocity and microacceleration from the data of measurements by a sensor of angular velocity and by the accelerometer of this system served as a second method. The filtration was made using the discrete Fourier series. A spectral analysis of the functions representing the results of determining the angular velocity and microacceleration by both methods is performed. Comparing the frequencies and amplitudes of the harmonic component of these functions allowed us to estimate the accuracy of measurements made by the QSAM system in the low-frequency range.     

Experimental studies of the impulsive ultrasonic machining by a tool with an intermediate striker

Some experimental data on the process of impulsive ultrasonic machining are presented. Also given are the data on variations in the impulsive vibration frequency of a workpiece and a tool.