少烟推进剂中新型复合多功能添加剂研究

利用多种实验手段，考察了四种新型复合多功能添加剂对ＡＰ／ＲＤＸ／ＡＬ／ＨＴＰＢ少烟复合推进剂力学性能，燃烧性能，热分解性能和工艺性能的影响。实验及分析证实，Ｃ－２和Ｃ－１两种复合多功能添加剂能显著改善少烟复合推进剂的力学性能，尤其是低温力学性能，同时还能提高推进剂燃速，是两种良好的多功能添加剂。     

钻孔法测量残余应力时释放系数的标定与计算

 <正> 用钻孔法测量残余应力时,使用的释放系数将对构件的残余应力测量精变产生影响。计算释放系数的理论方法有多种。其中普遍应用的公式,是由弹性力学通孔公式推导的应变片中心点处计算式。     

翼面结构雷达散射截面（RCS）的测量与分析

 影响飞机结构RCS值的因素很多。对于全金属结构的飞机,由于雷达波受到金属蒙皮的遮挡,其内部结构对飞机RCS的影响不大,几何外形及蒙皮材料的电磁特性是主要的影响因素,但对于在机体结构中采用了复合材料的情况就复杂多了。     

Augmenting the Linear Variance Equation

A technique is developed to convert the covariance analysis ofcertain time-varying linear systems into time-invariant form, thusallowing an arbitrary time step for the solution of the differentialequations. The result is accomplished by augmenting the linearvariance equation and augmenting the state vector if necessary. Themethod is illustrated with an example showing the covariancepropagation of ring laser gyro errors in a strapdown inertial systeminto navigation errors during turns.     

Carrier Tracking by Smoothing Filter Improves Symbol SNR

The potential benefit of using a smoothing filter to estimate a carrier phase over use of phase-locked loops (PLL) is determined. Numerical results are presented for the performance of three possible configurations of an all-digital coherent demodulation receiver. These are residual carrier PLL, sideband-aided residual carrier PLL, and finally sideband aided with Kalman smoother. The average symbol SNR after losses due to carrier phase estimation is computed for different total power SNRs, symbol rates, and symbol SNRs. It is found that smoothing is most beneficial for low symbol SNRs and low symbol rates. Smoothing gains up to 0.7 dB over sideband-aided residual carrier PLL, and the combined benefit of smoothing and sideband aiding relative to residual carrier loop is often in excess of 1 dB.     

A Closely Regulated TWT Converter

The design concept for the traveling wave tube amplifier converter for possible use in the Thermoelectric Outer Planet Spacecraft (TOPS) is presented. An unusual combination of semiconductors and magnetics were utilized to achieve very stable voltage regulation on a number of separate outputs to satisfy the requirements of a high-power traveling wave tube (TWT), and at the same time operate at an efficiency of better than 90 percent from a 30-volt source. The circuitry consists of an output filter, an auxiliary Jensen oscillator driving a high-reactance transformer to provide current limiting to the heater, a variable time delay, a main Jensen oscillator driving the power transformer with a maximum step-up ratio of 120 to 1, and series transistorized post regulators to provide precise voltage adjustment and low output impedance. This paper discusses the design of the high-reactance transformer and the high step-up ratio transformer, as well as the high-voltage series regulators that are limited in range and operate at the top of the unregulated output voltage. Test data is presented, and details of current transients caused by charging the filter circuits, input current ripple, and output voltage ripples are considered. The circuit provides better than 0.5 percent regulation against load change, input voltage change, and over-operating temperature range of from -20 to + 80°C, with output ripple voltage of less than 2 volts peak-to-peak on top of the 3600-Vdc output. The measured efficiency was typically 87 percent. and recommendations are included to improve this to in excess of 90 percent.     

Calibration of Precision Gimbaled Pointing Systems

Corrections of pointing data provided by gimbal readout transducers can be used to compensate for the errors that arise because of gimbal misalignments and inaccuracies in transducer readout. This paper reviews the sources of pointing error in precision gimbaled pointing systems and describes the techniques for determining them. In particular, a method of calibration that is suitable for systems in which constraints on gimbal travel preclude the use of conventional calibration procedures is presented, and the pointing readout accuracy that can be achieved by this method is evaluated.     

Angular Accuracy of a Scanning Radar Employing a Two-Pole Filter

A two-pole filter is proposed as a detector for a scanning radar. The optimum values of the filter coefficients are found and are approximated by a simple expression. The optimum two-pole filter requires a 0.15-dB increase in signal-to-noise ratio in order to provide the same detection capability as the optimum detector, and yields azimuth estimates whose standard deviation are within 15 percent of the Cramér-Rao lower bound. The estimator is simple to implement, avoiding the storage requirements of the moving window detector and the bias complications of the feedback integrator.     

Target Identification by Natural Resonance Estimation

This paper presents a target identification method based on an estimation of the natural frequencies of oscillation in transient radar signatures. The emphasis is placed upon signal modeling and estimation ation strategy rather than relating resonance locations to physical structures. Salient features of this identification method are: 1) target aspect angle is not needed, 2) multiple targets of the same type can be illuminated simultaneously, and 3) bandpass interrogation ion pulses can be used. The latter feature is compatible with existing radar facilities. The method is applied to some simulated transfer functions, and factors affecting estimate accuracy are discussed.     

Pure proportional navigation against time-varying target manoeuvres

Capturability of the pure proportional navigation (PPN) guidance law against a target executing bounded piecewise continuous time-varying manoeuvres is investigated. A qualitative analysis is carried out to obtain a set of sufficient conditions for capture defined on the engagement parameters and initial conditions. These conditions are significantly less restrictive than the ones obtained previously by others using the Lyapunov method. It is shown that the actual capture region for time-varying target manoeuvres, obtained by using the conditions derived, is much larger than that obtained from the Lyapunov technique. We also show that though a bounded tine varying target manoeuvre does change the constant target manoeuvre capture region to some extent, it does not reduce it drastically. Further, we show that the worst case capture region is obtained when the target executes a constant manoeuvre equal to the bound on the manoeuvre level. Some bounds on the missile lateral acceleration are also obtained for certain regions in the engagement plane. These results are generalizations and extensions of existing results on the capturability of the PPN guidance law against targets executing constant or time-varying target manoeuvres