Anomalous enhancement of electric field derived from ionosonde data before the great Wenchuan earthquake

The seismo-ionospheric coupling is a hot topic of modern scientific research. One of the most reasonable mechanisms is the hypothesis of quasistatic electric field. With a preliminary analytical method, electric field in F2-region before Wenchuan earthquake was derived from the five lower latitude ground-based ionosondes: Lhasa (29.63°N, 91.17°E), Chongqing (29.50°N, 106.40°E), Kunming (25.00°N, 102.70°E), Guangzhou (23.15°N, 113.35°E) and Haikou (23.15°N, 110.35°E). The results show that there was an anomalous enhancement of electric field in F2-region close to the epicenter with maximal amplitude ∼2 mV/m (about 10 times of the background) at 15:00 LT on 9 May, which is in line with the amplitudes of anomalous electric field related to some previous earthquakes observed by satellites.     

圆形太阳翼模态仿真与试验研究

利用有限元软件SAMCEF实现了圆形太阳翼模态仿真分析，探究了翼面预紧力、约束方式和悬吊弹簧重力卸载系统对太阳翼模态的影响。结果显示，翼面预紧力对太阳翼模态影响较大；支撑车约束方式微小影响太阳翼第一阶模态；有支撑车相比无支撑车，太阳翼第一阶模态频率差值可达32.89%，因此地面试验不能使用支撑车；含悬吊弹簧重力卸载系统可有效减轻重力作用对模态的影响；此外，当弹簧刚度小于7 N/m时，其对太阳翼模态的影响小于0.59‰。随后，采用工作模态法和双点激振方式，经预试验优化地面试验方案；采用正弦扫频方法进行模态测试，获得了圆形太阳翼的前四阶模态振型和固有频率。最后，通过有限元模型修正，使模态仿真结果误差保持在4.16%以内，符合测试相关标准的要求。     

A novel environmental control system based on membrane dehumidification

This paper conducts a simulation study of a novel aircraft environmental control system based on membrane dehumidification(MD-ECS),and compares the system with the up-to-date four-wheel high pressure de-water system(4WHPDW-ECS).Mathematical models for the two systems are established,and a system simulation using a numerical technique is performed to analyze and compare the cooling performance of the two systems.Simulation results show that the cooling capacity of MD-ECS is much higher than that of 4WHPDW-ECS under the same working conditions,indicating that the novel system is theoretically feasible and promising.The effects of the sweep ratio of the membrane dehumidifier on the dehumidification and cooling performance of the system is also investigated.     

利用OpenGL显示叶轮造型及模拟加工

分析了OpenGL编程原理以及OpenGL与Windows图形设备接口GDI之间的关系,介绍了OpenGL进行叶轮造型显示及虚拟加工的应用方法.     

Experimental method for and theoretical research on defect tolerance of fixed plate based on damage mechanics

An experimental method and a theoretical analysis based on continuum damage mechan-ics are applied for the defects tolerance of fixed plate. The defects type studied in this article is scratch, which i...     

基于MiniGUI的嵌入式显控系统的设计与实现

MiniGUI是目前比较成熟图形用户接口,具有小巧、可配置和可移植等特点,本文结合触摸显控处理机实际项目开发和应用,重点研究了基于MiniGUI的嵌入式Linux图形系统的开发.     

低成本IMU／GPS组合导航系统研究

ＧＰＳ／ＩＮＳ组合导航系统已在一定领域得到应用，而ＩＮＳ昂贵的价格限制了它的广泛应用，本文采用低成本惯性测量组件（ＩＭＵ）设计了低成本ＩＭＵ／ＧＰＳ组合系统的硬件和相应的软件，进行了静态实验和数据处理，系统的俯仰角和横滚角误差均小于０．２°，实验结果表明，低成本组合系统的性能较好，而其性能价格比更高。     

飞控系统故障检测的参数模糊自适应调节

提出通过模型参数的模糊比例积分自适应调节，以校正基于模型的飞控系统故障检测中的系统数学模型偏差。针对模型中误差差较大的迎角导数值，将俯仰角加速度的测量值与教学模型估计值之差作为比例积分调节的反馈量，动态实时校正数学模型参数。     

Longitudinal behaviors of the IRI-B parameters of the equatorial electron density profiles retrieved from FORMOSAT-3/COSMIC radio occultation measurements

The electron density profiles in the bottomside F₂-layer ionosphere are described by the thickness parameter B0 and the shape parameter B1 in the International Reference Ionosphere (IRI) model. We collected the ionospheric electron density (N_e) profiles from the FORMOSAT-3/COSMIC (F3/C) radio occultation measurements from DoY (day number of year) 194, 2006 to DoY 293, 2008 to investigate the daytime behaviors of IRI-B parameters (B0 and B1) in the equatorial regions. Our fittings confirm that the IRI bottomside profile function can well describe the averaged profiles in the bottomside ionosphere. Analysis of the equatorial electron density profile datasets provides unprecedented detail of the behaviors of B0 and B1 parameters in equatorial regions at low solar activity. The longitudinal averaged B1 has values comparable with IRI-2007 while it shows little seasonal variation. In contrast, the observed B0 presents semiannual variation with maxima in solstice months and minima in equinox months, which is not reproduced by IRI-2007. Moreover, there are complicated longitudinal variations of B0 with patterns varying with seasons. Peaks are distinct in the wave-like longitudinal structure of B0 in equinox months. An outstanding feature is that a stable peak appears around 100°E in four seasons. The significant longitudinal variation of B0 provides challenges for further improving the presentations of the bottomside ionosphere in IRI.     

切削过程稳定性的研究现状

研究切削过程振动产生的原因和种类,并合理选择切削参数和加强刀具的切削性能来减轻刀具在金属切削过程中振动的具体措施是很有必要的,从而保证加工过程动态平稳性,实现高质量、高效率生产的要求。