An Adaptive Array Signal Processing Algorithm for Communications

An algorithm is described for initial synchronization in a communication system with a digital adaptive array. This algorithm can also be used for message extraction. A set of consecutive complex video samples of the array output is processed to obtain optimum adaptive array weights, based on a least mean square (LMS) error criterion. This computation is performed for each of the possible alternative signals which may be present during an observation interval. The correct synchronization time or message symbol is selected as the one which yields the minimum LMS error. Assuming orthogonality of the alternative codes, a probability distribution for the output of this processor has been derived.     

Radar Identification of Naval Vessels

A scheme is presented for the identification of naval vessels via active multiple-frequency radar interrogation. A major virtue of the described method is the use of a response waveform synthesized using amplitude data only. A prediction correlation using natural resonances associated with substructures on the vessels is applied to synthetically generated matched-filter response waveforms. The identification scheme is tested using measured model data for 8 vessels on a simulated sea surface. A correct identification probability of roughly 77 percent is obtained.     

Calculating Detection Probabilities for Systems Employing Noncoherent Integration

Cumulative probability distributions that occur in radar and sonar detection problems are calculated directly from the characteristic function by using a Fourier series. The error in the result is controlled by two parameters which can be adjusted to suit the application. The technique is applied to the problem of determining the detection performance of consecutive discrete Fourier transforms (DFTs) for a narrowband Gaussian signal with a rectangular spectrum. Since the characteristic function is used directly in its product form this technique does not suffer from the numerical problems associated with the partial fraction approach. The technique can handle many different problems in a single computational structure making it a valuable tool in system performance studies.     

Hard Limiter Performance as a Polarity Detector for Extremely Polluted Signals

A hard limiter is a simple, yet highly efficient, RF signal sensor for VLF and LF navigation receivers. The observation reliability is used as the single quality criterion for the hard limiter if applied as a singlebit analog-to-digital converter (ADC). The effects of noise (Gaussian and atmospheric), nonsynchronous and synchronous interference, and dc offset on the observation reliability are described extensively. The single parameter determination Pobs is adequate for characterizing the polarity detector. This facilitates rank ordering of influences disturbing the signal and is a useful tool in optimizing digital tracking loops. The ?built-in? noise-censoring properties of the hard limiter in the presence of atmospheric noise are excellent. Therefore, three different atmospheric noise models are used in the determination of the observation reliability Pobs. Some ways for coping with other disturbances that potentially threaten the good performance of the hard limiter are suggested.     

Large-Signal Transient Responses of a Switching Regulator

Analytical and experimental considerations of the large-signal transient responses of the buck-type switching regulator are described. The dynamic behavior under the large-signal condition is different from the small-signal operation because of the saturation characteristics of the pulsewidth modulator feedback controller. The effect of this nonlinearity is analyzed by dividing its operation into three modes. As a result the peak values of the inrush current and output voltage are obtained analytically both for the start-up and for the step change of the load condition.     

MTI Processing and Weibull-Distributed Ground Clutter

It is shown that the Weibull-distributed ground clutter obeys a Weibull distribution after processing by the double canceler moving target indicator (MTI).     

Leaky Coaxial Cable Resource Protection Sensor Performance Analysis

The performance of an RF intrusion detection system which uses a leaky coaxial cable sensor is analyzed. A simple cable sensor field model is assumed which gives good agreement between the computed response and observation. Expressions that describe the performance of several deployment configurations and receiver types are developed. The probability of detection and the zone of containment are computed and their uniformity is examined as a function of cable propagation constants.     

The Effect of a Pulsed Interference Signal on an Adaptive Array

The performance of a least mean square (LMS) adaptive array in the presence of a pulsed interference signal is examined. It is shown that a pulsed interference signal has two effects. First, it causes the array to modulate the desired signal envelope (but not its phase). Second, it causes the array output signal-to-interferenceplus-noise ratio (SINR) to vary with time. The desired signal modulation is evaluated as a function of signal arrival angles, powers and interference pulse-repetition frequency (PRF) and pulsewidth. It is shown that the signal modulation is small except when the interference arrives close to the desired signal. To evaluate the effect of the time-varying SINR, it is assumed that the array is used in a differential phase-shift keyed (DPSK) communication system. It is shown that the SINR variation causes a noticeable but not disastrous increase in the bit error probability.     

Instrument Failure Detection in Partially Observable Systems

Instrument failure detection using the dedicated observer scheme (DOS) depends on partial state observability through each instrument which is monitored. For instrument fault detection by the DOS technique, a quantitative measure of partial state observability is established for each instrument and used to determine a necessary condition on the output structure of the system. This measure, called the internal redundancy of the instrument, indicates the complexity of the logic required for failure detection, and it also indicates where some hardware redundancy can be introduced into the system to improve the fault detection capability of the DOS. The principles developed are applied to a simulation of the pitch axis autopilot of the A7 jet aircraft.     

Transient response investigation of gimballed tiltrotors during engage and disengage operations

Ｕｎｉｑｕｅａｎｄｏｆｔｅｎｈａｚａｒｄｏｕｓｃｏｎｄｉｔｉｏｎｓａｒｅｅｎｃｏｕｎｔｅｒｅｄｗｈｅｎｒｏｔｏｒｃｒａｆｔａｒｅｏｐｅｒａｔｅｄｆｒｏｍｓｈｉｐｂａｓｅｄｐｌａｔｆｏｒｍｓ．Ｏｎｅｏｆｔｈｅｍｏｒｅｔｒｏｕｂｌｅｓｏｍｅｒｏｔｏｒｃｒ...