PWM full-bridge converter with natural input power factor correction

A pulsewidth modulated (PWM) full-bridge converter that simultaneously performs input power factor correction (PFC) and DC-DC conversion is proposed. The converter is the same as the standard voltage-fed PWM full-bridge converter with a diode-bridge low-pass filter front end, but with a slight modification that results in an improvement in power factor that is sufficient to satisfy the EN61000-3-2 requirements for electrical equipment. The operation of the converter is explained and analyzed, and the results of the analysis are used to determine the converter's steady-state characteristics, which are discussed in detail. A design procedure for the selection of components is then derived and demonstrated with an example. The feasibility of the converter and its ability to satisfy EN61000-3-2 requirements on electrical equipment is shown with results obtained from an experimental prototype.     

Modeling of dynamic evolution of coronal loops

Parameters of expanding magnetic loops and arches and of mass flows generated by them in the corona have been computed in a 1D two-fluid approximation. Two possible trigger mechanisms of the coronal transients have been considered: (i) sudden increase of the background magnetic field strength, and (ii) heating and compression plasma inside these magnetic structures. We discuss the formation of shock waves and their dependence on dynamics and geometry of the magnetic structures.     

Stable mid-latitude red arcs: Observations and theory

Summary The observational features of the arc are fairly well established. At present, the thermal conduction model appears to explain the red arc features most consistently, but it must be noted that a soft electron flux would give very similar results. Ion temperature measurements in the vicinity of an arc, which should be forthcoming in the very near future, can establish conclusively whether transverse electric fields play any important role in the formation of the arcs. Accepting the assumption that the arcs are the result of energy flowing down from the plasmasphere, the major remaining question is: where does the energy come from and how does it get into the plasmasphere? The various proposed mechanisms discussed in the previous chapter appear feasible, but much work needs to be done before this problem is completely resolved.On leave from the Department of Electrical Engineering, The University of Michigan, Ann Arbor.The National Center for Atmospheric Research is sponsored by the National Science Foundation.     

Logistics Transportation for Space Station Support

Logistics support of a long duration space station will dictate a high degree of space flight activity to rotate personnel and transport supplies and equipment. Systems characteristics and mission requirements for space station logistics have been analyzed within the context of a broad spectrum of space missions. Preliminary concepts for a space shuttle system (space transportation) have been developed. This system can support not only a space station program, but a wide variety of space missions for both NASA and the DOD.     

Attitude Determination Via Nonlinear Filtering

The theory of nonlinear filtering has been applied to the problem of the attitude determination of a satellite. Two approximation methods have been studied with a view to practical implementation. Computer simulation results are included.     

Analysis of a Class of Nonlinear Sampled-Data Systems with a Gaussian Input Signal

The problem treated here is the analysis of a class of nonlinear sampled-data systems with a Gaussian input signal. The nonlinear element is a symmetrical limiter (memoryless device) that feeds the linear element. Preceding the limiter is a sampler and zero-order hold unit for data reconstruction. The analysis is predicated on finding an equivalent gain for the nonlinear element such that the mean-square error is a minimum. The nonlinearity is thus replaced by a linear component and the system is then analyzed by conventional techniques. It is also shown that for appropriate sampling rates the sampled-data system is equivalent to a continuous system due to the action of the sampler-hold combination. All calculations pertaining to the limiter input signal require the use of a transfer function that is interior to the feedback loop. However, in developing this transfer function, the overall system is considered so that the system output may be evaluated after the value of equivalent gain has been found.     

Monopulse Estimation of the Centroid of an Ensemble of Radar Scatterers

The use of data obtained by a monopulse radar to estimate the location of the radar cross-section centroid of an ensemble of scatterers is discussed. Both dish and phased-array antenna radars are treated. Expressions for the bias and variance of the centroid estimates are presented, including the effects of the radar receiver and beam pattern characteristics, receiver noise, and the video waveform sampling granularity, as well as the target properties. The monopulse tracking approach discussed here is contrasted with a raster scan approach presented previously.     

Missile Electronic System Hardness Assurance Program

A hardness assurance program suitable for a retaliatory or deterrent missile system is discussed. The program consists of three phases: the establishment of suitable controls and screens to ensure piece part hardness, a supplier data monitoring program to measure hardness related parameters in a timely fashion to obtain advanced warning of potential problems, and a hardness assurance verification testing (HAVT) program to periodically measure the radiation response of parts, circuits, subsystems, and systems on a sample basis to ensure proper functioning in simulated radiation environments. All of the data relevant to hardness assurance is stored in computer memory and routinely interrogated with programs which compare current results with the engineering baseline data and other data from preceding lots. Other computer programs enable statistical estimation of system response to the radiation environment with confidence based on the expanding data base provided by the HAVT program.     

False alarm control using Doppler estimation

A technique which uses maximum-likelihood estimates (MLEs) of target Doppler and target amplitude is developed for rejecting clutter residues. Multiple estimates are made and consistency checks are applied to the estimates. Simulation results indicate that for large clutter-to-noise ratios (C/N⩾55 dB) the probability of false alarm from clutter residues is reduced from 1.0 to below 0.01     

A new and robust CFAR detection algorithm

A constant false alarm rate (CFAR) detection method which is based on a combination of median and morphological filters (MEMO) is proposed. The MEMO algorithm has robust performance with small CFAR loss, very good behavior at clutter edges and high detection performance in the case of closely spaced narrowband signals (targets). The proposed MEMO method is favourably compared with cell averaging (CA) and ordered statistics (OS) CFAR detectors. The Monte Carlo method is employed to analyze the MEMO-CFAR detector