Spin-stabilized satellite magnetic attitude control scheme without initial detumbling

The angular motion of an axisymmetrical satellite equipped with an active magnetic attitude control system is considered. The dynamics of the satellite are analytically studied on the whole control loop. The control loop is as follows: preliminary reorientation along with nutation damping, spinning about the axis of symmetry, then precise reorientation of the axis of symmetry in inertial space. Reorientation starts right after separation from the launch vehicle. Active magnetic attitude control system time-response with respect to its parameters is analyzed. It is proven that low-inclined orbit forces low control system time-response. Comparison with the common control scheme shows the time-response gain. Numerical analysis of the disturbances effect is carried out and good pointing accuracy is proved.     

A search for narrow band signals with SERENDIP II: a progress report

Commensal programs for the Search for Extraterrestrial Intelligence (SETI), carried out concurrently with conventional radio astronomical observing programs, can be an attractive and cost-effective means of exploring the large multidimensional search space intrinsic to this effort. Our automated commensal system, SERENDIP II, is a high resolution 131,072 channel spectrometer. It searches for 0.49 Hz signals in sequential 64,700 Hz bands of the IF signal from a radio telescope being used for an astronomical observation. Upon detection of a narrow band signal with power above a preset threshold, the frequency, power, time, and telescope direction are recorded for later study. The system has been tested at the Hat Creek Radio Astronomy Observatory 85 ft telescope and the NASA-JPL Deep Space Station (DSS 14) 64 m telescope. It is currently collecting data at the National Radio Astronomy Observatory 300 ft telescope.     

Viability of barley seeds after long-term exposure to outer side of international space station

Barley seeds were exposed to outer space for 13 months in a vented metal container without a climate control system to assess the risk of physiological and genetic mutation during long-term storage in space. The space-stored seeds (S0 generation), with an 82% germination rate in 50 seeds, lost about 20% of their weight after the exposure. The germinated seeds showed normal growth, heading, and ripening. The harvested seeds (S1 generation) also germinated and reproduced (S2 generation) as did the ground-stored seeds. The culm length, ear length, number of seed, grain weight, and fertility of the plants from the space-stored seeds were not significantly different from those of the ground-stored seeds in each of the S0 and S1 generation. Furthermore, the S1 and S2 space-stored seeds respectively showed similar β-glucan content to those of the ground-stored seeds. Amplified fragment length polymorphism analysis with 16 primer combinations showed no specific fragment that appears or disappears significantly in the DNA isolated from the barley grown from the space-stored seeds. Though these data are derived from nine S0 space-stored seeds in a single exposure experiment, the results demonstrate the preservation of barley seeds in outer space for 13 months without phenotypic or genotypic changes and with healthy and vigorous growth in space.     

Debris swarms seen by SMEI

The large 3° × 60° fields-of-view of the Solar Mass Ejection Imager (SMEI) instruments are oriented on the stabilized Coriolis satellite to image most of the sky each Sun-synchronous orbit. Besides observing coronal mass ejections, the SMEI mission objective, SMEI also has detected a plethora of Earth-orbiting satellites (resident space objects or RSOs) brighter than ∼8th magnitude at a rate of about 1 per minute. Occasionally, SMEI sees an RSO swarm: a sudden onset of a large number of RSOs, many more than the nominal rate, upto dozens detected in a 4-s frame. These swarms usually last for a few minutes. A sample of six such RSO ensembles is analyzed in this paper in which the distance and the direction of the velocity vector for individual objects are estimated. We present the observational evidence indicating that the swarms must be near-field objects traveling in orbits near that of Coriolis, and that the relatively speeds between the objects and Coriolis are low. Further, analyses indicate that the RSOs are quite close (<20 m) and are generally moving radially away from the satellite. The predicted encounter geometries for Coriolis passing through or near a small debris cloud is, generally, quite inconsistent with the observations. The most likely explanation consistent with the observations is that SMEI is seeing debris being ejected from the Coriolis spacecraft itself. An analysis of distance and brightness for a subset of the RSOs indicates that the median diameter of the debris particles is ∼80 μm.     

The Magnetospheric Multiscale Magnetometers

The success of the Magnetospheric Multiscale mission depends on the accurate measurement of the magnetic field on all four spacecraft. To ensure this success, two independently designed and built fluxgate magnetometers were developed, avoiding single-point failures. The magnetometers were dubbed the digital fluxgate (DFG), which uses an ASIC implementation and was supplied by the Space Research Institute of the Austrian Academy of Sciences and the analogue magnetometer (AFG) with a more traditional circuit board design supplied by the University of California, Los Angeles. A stringent magnetic cleanliness program was executed under the supervision of the Johns Hopkins University’s Applied Physics Laboratory. To achieve mission objectives, the calibration determined on the ground will be refined in space to ensure all eight magnetometers are precisely inter-calibrated. Near real-time data plays a key role in the transmission of high-resolution observations stored on board so rapid processing of the low-resolution data is required. This article describes these instruments, the magnetic cleanliness program, and the instrument pre-launch calibrations, the planned in-flight calibration program, and the information flow that provides the data on the rapid time scale needed for mission success.     

IMF Direction Derived from Cycloid-Like Ion Distributions Observed by Mars Express

Although the Mars Express (MEX) does not carry a magnetometer, it is in principle possible to derive the interplanetary magnetic field (IMF) orientation from the three dimensional velocity distribution of pick-up ions measured by the Ion Mass Analyser (IMA) on board MEX because pick-up ions' orbits, in velocity phase space, are expected to gyrate around the IMF when the IMF is relatively uniform on a scale larger than the proton gyroradius. During bow shock outbound crossings, MEX often observed cycloid distributions (two dimensional partial ring distributions in velocity phase space) of protons in a narrow channel of the IMA detector (only one azimuth for many polar angles). We show two such examples. Three different methods are used to derive the IMF orientation from the observed cycloid distributions. One method is intuitive (intuitive method), while the others derive the minimum variance direction of the velocity vectors for the observed ring ions. These velocity vectors are selected either manually (manual method) or automatically using simple filters (automatic method). While the intuitive method and the manual method provide similar IMF orientations by which the observed cycloid distribution is well arranged into a partial circle (representing gyration) and constant parallel velocity, the automatic method failed to arrange the data to the degree of the manual method, yielding about a 30° offset in the estimated IMF direction. The uncertainty of the derived IMF orientation is strongly affected by the instrument resolution. The source population for these ring distributions is most likely newly ionized hydrogen atoms, which are picked up by the solar wind.     

Some technical aspects of gaseous detonation

This paper briefly describes two attempts to utilize detonative combustion processes to MHD conversion of thermal energy of fuel to electrical energy and bonding of atmospheric nitrogen. For this purpose a continuous impulse detonation chamber with a frequency up to 200 cps was constructed. Using methane-oxygen-nitrogen mixtures the chamber was maintained in stable operation for several hundred hours. Oil was also employed as fuel.Estimates based on experimental data showed that up to 2% of chemical energy of the fuel may be converted into electrical energy. The use of an accelerating nozzle may improve this result.The concentration of nitrogen oxide in combustion products of the detonation wave was higher by 14% than that expected under usual combustion conditions.The advantages of this type of apparatus are: absence of compressors for fuel and oxidant, impulse current generation, low temperatures of chamber walls, and operation over a large range of operating conditions.Problems associated with the effect of the magnetic field on the propagation of the detonation wave are discussed and the possibility of applying the Zeldovich theory to the case of MHD interaction is described. It is shown that the detonation velocity may either increase or decrease depending on the relative orientation of the direction of magnetic field with respect to the detonation wave.     

Unsteady laminar separation over impulsively moved cylinders

A numerical method is employed to integrate the unsteady laminar boundary layers about circular and elliptic cylinders started impulsively from rest. An upwind differencing scheme permits the integration through thin layers of reversed flow that are embedded in the boundary layer. The results are in agreement with numerical solutions of the full Navier-Stokes equations and with small time inner-outer expansion solutions. At later times, a singularity of the Goldstein type appears; Sears and Telionis defined this singularity as unsteady boundary-layer separation. For the circular cylinder, this singularity travels upstream and for large times, arrives asymptotically at the point of steady-state separation.     

Novel quaternion Kalman filter

This paper presents a novel Kalman filter (KF) for estimating the attitude-quaternion as well as gyro random drifts from vector measurements. Employing a special manipulation on the measurement equation results in a linear pseudo-measurement equation whose error is state-dependent. Because the quaternion kinematics equation is linear, the combination of the two yields a linear KF that eliminates the usual linearization procedure and is less sensitive to initial estimation errors. General accurate expressions for the covariance matrices of the system state-dependent noises are developed. In addition, an analysis shows how to compute these covariance matrices efficiently. An adaptive version of the filter is also developed to handle modeling errors of the dynamic system noise statistics. Monte-Carlo simulations are carried out that demonstrate the efficiency of both versions of the filter. In the particular case of high initial estimation errors, a typical extended Kalman filter (EKF) fails to converge whereas the proposed filter succeeds.