A design procedure for the phase-controlled parallel-loadedresonant inverter

High-frequency-link power conversion and distribution based on a resonant inverter has been recently proposed. The design of several topologies is reviewed and a simple approximate design procedure is developed for the phase-controlled parallel-loaded resonant inverter. This design procedure seeks to ensure the expected benefits of resonant conversion and is verified by data from a laboratory 2.5 kVA, 20-kHz converter. A simple phasor analysis is introduced as a useful approximation for design purposes. Experimental results show that under transient conditions such as load short-circuit, a reversal of the expected commutation sequence is possible. This should be accounted for in the design of the power circuit, or prevented by the design of the controller     

Frequency estimation techniques for high dynamic trajectories

A comparison is presented of four different estimation techniques applied to the problem of continuously estimating the rapidly varying parameters of a sinusoidal signal, observed in the presence of additive noise. Frequency estimates are emphasized, although phase and/or frequency rate are also estimated by some of the algorithms. These parameters are related to the velocity, position, and acceleration of the maneuvering receiver or transmitter. Estimated performance at low carrier-to-noise ratios and high dynamics is investigated for the purpose of determining the useful operating range of an approximate maximum likelihood estimator, an extended Kalman filter, a cross-product automatic frequency loop and a phase-locked loop. Numerical simulations are used to evaluate performance while tracking a common trajectory exhibiting high dynamics     

An exact expression for resolution cell area in special case ofbistatic radar systems

An exact expression for the bistatic resolution-cell area (A _B) is developed for the special case in which either the transmit or receive antenna has a broad azimuth beamwidth or is omnidirectional. Quantitative examples are presented to illustrate the variation of A_B with location. A comparison is made with the performance of a commonly used approximation formula     

Parallel resonant converter with LLC-type commutation

It is shown that by using a proper transformation of state variables, the third-order system of the parallel resonant converter (PRC) with LLC-type commutation can be analyzed by means of a two-dimensional state-plane diagram. A set of characteristic curves which can be used for the converter design is derived from the analysis. It is shown from these curves that the converter possesses more desirable features than the conventional PRC     

Lyapunov stability designs for switching regulator/low-pass filtersystem

The second method of Lyapunov is employed to determine quantitatively accurate criteria for asymptotic stability of the fourth-order switching-regulator/low-pass filter system. Modeling the regulator as a linearized negative resistance, this analysis provides alternative stability relationships to those found in the literature and also reveals the limitations of the Routh stability criterion. Design examples are included which ensure system stability and reduce the amplitude of the filter resonant peak (audio-susceptibility constraint)     

Detection performance in K-distributed and correlatedRayleigh clutters

Performance prediction for a detection system employing noncoherent integration is carried out for a chi-square family of fluctuating targets in K-distributed clutter plus noise. The detection performance for Swerling 11 targets in the K-distributed clutter plus noise is compared with that in exponentially correlated Rayleigh clutter. The results show that the performance prediction based on N pulses integrated in clutter plus noise using the K-distributed clutter model may be approximately equivalent to that using the exponentially correlated Rayleigh-distributed clutter model     

Geometric aspects of long-term noncoherent integration

Long-term integration is defined as integration, perhaps interrupted, over time periods long enough for targets to move through volumes in space resolvable by the radar. Because the motion of the target is unknown prior to detection, long-term integration must be performed along multiple paths representing plausible target paths. The geometry of such a set of integration paths affects detection performance in several ways. The simplest implementation of long-term integration, using constant radial velocity paths, is investigated. The effects of path geometry on detection is quantified and optimized for a target whose motion is nearly radial but otherwise unknown     

Decoding techniques in state estimation for dynamic systems withpast histories

States of dynamic models with a higher order memory are estimated using both a stack sequential decoding algorithm and the Viterbi decoding algorithm (VDA), without higher dimensional dynamic system representation. This results in memory reduction for state estimate implementation. It is found that state estimation with a stack sequential decoding algorithm is faster and more practical than the state estimation with the Viterbi decoding algorithm, even though the estimates obtained by the Viterbi decoding algorithm are superior     

A noise insensitive solution to an ambiguity problem in spectralestimation

The instantaneous frequency measurement (IFM) receiver is capable of measuring the center frequency of single frequency pulses over a wide range (bandwidth) of center frequencies. Because of various constraints, the frequency resolution requirement results in long correlator delay times that reduce the single correlator bandwidth. A large bandwidth can be achieved only if two or more correlators are used. The problem of estimating frequency is then reduced to the simultaneous congruence problem of number theory. A design procedure is presented for solving the congruence problem for a given amount of noise protection, a stated frequency resolution, a minimum bandwidth, and a fixed level of precision (bits) in the IFM receiver