Augmenting the Linear Variance Equation

A technique is developed to convert the covariance analysis ofcertain time-varying linear systems into time-invariant form, thusallowing an arbitrary time step for the solution of the differentialequations. The result is accomplished by augmenting the linearvariance equation and augmenting the state vector if necessary. Themethod is illustrated with an example showing the covariancepropagation of ring laser gyro errors in a strapdown inertial systeminto navigation errors during turns.     

A Closely Regulated TWT Converter

The design concept for the traveling wave tube amplifier converter for possible use in the Thermoelectric Outer Planet Spacecraft (TOPS) is presented. An unusual combination of semiconductors and magnetics were utilized to achieve very stable voltage regulation on a number of separate outputs to satisfy the requirements of a high-power traveling wave tube (TWT), and at the same time operate at an efficiency of better than 90 percent from a 30-volt source. The circuitry consists of an output filter, an auxiliary Jensen oscillator driving a high-reactance transformer to provide current limiting to the heater, a variable time delay, a main Jensen oscillator driving the power transformer with a maximum step-up ratio of 120 to 1, and series transistorized post regulators to provide precise voltage adjustment and low output impedance. This paper discusses the design of the high-reactance transformer and the high step-up ratio transformer, as well as the high-voltage series regulators that are limited in range and operate at the top of the unregulated output voltage. Test data is presented, and details of current transients caused by charging the filter circuits, input current ripple, and output voltage ripples are considered. The circuit provides better than 0.5 percent regulation against load change, input voltage change, and over-operating temperature range of from -20 to + 80°C, with output ripple voltage of less than 2 volts peak-to-peak on top of the 3600-Vdc output. The measured efficiency was typically 87 percent. and recommendations are included to improve this to in excess of 90 percent.     

Ground Testing of Inertial Navigators to Improve Dynamic Performance

A ground testing method has been devised to evaluate the dynamic errors of an inertial navigation system. A trimmed stationary inertial system in the navigation mode can be subjected to programmed platform orm drift rates, and generate position outputs which are compared with those of a perfect navigator. The linearized error equations for this testing mode are derived and the resulting position error propagation is analyzed using Kalman filtering in order to identify the error sources. A simulated platform with a fixed set of error sources is analyzed to evaluate this testing concept. An example is presented to show that the gyro and accelerometer scale factor and misalignment error coefficients can be estimated.     

Pure proportional navigation against time-varying target manoeuvres

Capturability of the pure proportional navigation (PPN) guidance law against a target executing bounded piecewise continuous time-varying manoeuvres is investigated. A qualitative analysis is carried out to obtain a set of sufficient conditions for capture defined on the engagement parameters and initial conditions. These conditions are significantly less restrictive than the ones obtained previously by others using the Lyapunov method. It is shown that the actual capture region for time-varying target manoeuvres, obtained by using the conditions derived, is much larger than that obtained from the Lyapunov technique. We also show that though a bounded tine varying target manoeuvre does change the constant target manoeuvre capture region to some extent, it does not reduce it drastically. Further, we show that the worst case capture region is obtained when the target executes a constant manoeuvre equal to the bound on the manoeuvre level. Some bounds on the missile lateral acceleration are also obtained for certain regions in the engagement plane. These results are generalizations and extensions of existing results on the capturability of the PPN guidance law against targets executing constant or time-varying target manoeuvres     

An exact expression for resolution cell area in special case ofbistatic radar systems

An exact expression for the bistatic resolution-cell area (A _B) is developed for the special case in which either the transmit or receive antenna has a broad azimuth beamwidth or is omnidirectional. Quantitative examples are presented to illustrate the variation of A_B with location. A comparison is made with the performance of a commonly used approximation formula     

Improved Switching Converter Model Using Discrete and Averaging Techniques

The nonlinear modeling and analysis of dc-dc converters has been done by averaging and discrete-sampling techniques. The averaging technique is simple, but inaccurate, as the modulation frequencies approach the theoretical limit of one-half the switching frequency. The discrete technique is accurate even at high frequencies, but is very complex and cumbersome. An improved model is developed by combining the aforementioned techniques. This new model is easy to implement in circuit and state variable forms and is accurate to the theoretical limit.     

Nondestructive Characterization of RBSOA of High-Power Bipolar Transistors

Reverse-bias safe operating area (RBSOA) of high-power Darlington transistors is characterized using a 120 A/1000 V nondestructive reverse-bias second breakdown tester designed and fabricated at Virginia Polytechnic Institute and State University. Elaborate RBSOA characteristics are generated with different forward/reverse base drives and collector current levels. The effects of elevated case temperature and second-base drive on RBSOA of four-terminal Darlington devices are also discussed.