基于小波变换的SAR相干斑抑制方法研究

SAR图像固有的相干斑噪声恶化了其成像质量,如何有效抑制相干斑噪声并保留SAR图像的细节信息是研究的一个热点问题。基于SAR相干斑乘性噪声模型,根据小波阈值处理的原理,分析小波滤波在SAR相干斑抑制中存在的关键问题和硬、软阈值处理中存在的不足,提出一种新的阈值函数,并利用均方误差和峰值信噪比指标对相干斑抑制效果进行评估。实验结果表明,新的阈值函数在有效抑制相干斑噪声的同时还保留大量SAR图像的细节信息,较硬、软阈值函数有更好的滤波效果。     

光纤陀螺用光收发组件的SLD准直系统设计

在光纤陀螺向高精度和小型化的方向发展的背景下,针对光纤陀螺用光收发组件对器件小型化、易集成的特殊要求和超辐射发光二极管SLD(Super-Luminescent Diode)出射光束的特点,提出利用双焦距双柱透镜准直整形系统对SLD光束进行准直、整形.根据椭圆高斯光束的特性,利用几何光学法和矩阵光学法,分别对该双柱透镜的重要结构参数(曲率、柱透镜厚度)进行了详细的计算及分析,并且利用矩阵光学法得出系统的光线传输矩阵,对该双柱透镜的结构参数进行优化设计.利用CODEⅤ光学仿真软件对优化后的系统进行仿真,得出准直整形后光束在xOz平面和yOz平面内的发散角仿真值均低于0.05 mrad,且光斑为圆形.     

天线罩干扰下的雷达/红外复合导引头数据融合

针对雷达/红外复合导引头中存在天线罩折射以及外部干扰问题,在三维模型下,提出一种基于扩展卡尔曼滤波(EKF,Extended Kalman Filter)的多模型算法,对天线罩斜率进行估计,并将估计结果代入EKF,降低观测视线角中的天线罩折射干扰,形成最优局部估计.采用基于环境信息的加权因子法对雷达/红外局部估计结果进行融合,通过环境信息度量传感器测量结果的可信度,忽略不可信的局部估计结果.设计4组算例检验融合算法性能,仿真结果表明:所提算法可以准确估计天线罩斜率,合理并有效使用雷达/红外传感器信息,提高系统估计精度.     

逆向涡流发生器减小涡轮叶尖泄漏流的数值研究

逆向涡流发生器可以有效减小涡轮叶尖泄漏流,提高叶片周向载荷.对影响逆向涡流器减小泄漏流的几个关键因素进行了数值研究,结果表明:入流和出流孔径比增大,涡流器流量增加,对叶尖泄漏流的减小效果越好,孔径比2∶1时比孔径比1∶1时涡流器流量增加了24%,叶尖泄漏流量降低了0.8%,叶片周向载荷提高了1%;与叶片前缘布置涡流器相比,在叶片中后部布置时涡流器流量增大,叶片周向载荷提高;涡流器布置越密,涡流器总流量增加,布置33个涡流器比布置9个涡流器叶尖泄漏流量降低了1.6%,叶片周向载荷提高了2.7%;出流角越小,叶尖泄漏流量越小,叶片周向载荷越大,出流角30°时泄漏流量比60°时降低了1.2%,叶片周向载荷提高了约2%.     

Monocular Vision-based Two-stage Iterative Algorithm for Relative Position and Attitude Estimation of Docking Spacecraft

Visual sensors are used to measure the relative state of the chaser spacecraft to the target spacecraft during close range rendezvous phases. This article proposes a two-stage iterative algorithm based on an inverse projection ray approach to address the relative position and attitude estimation by using feature points and monocular vision. It consists of two stages: absolute orientation and depth recovery. In the first stage, Umeyama's algorithm is used to fit the three-dimensional (3D) model set and estimate the 3D point set while in the second stage, the depths of the observed feature points are estimated. This procedure is repeated until the result converges. Moreover, the effectiveness and convergence of the proposed algorithm are verified through theoretical analysis and mathematical simulation.     

Low C/N_0 Carrier Tracking Loop Based on Optimal Estimation Algorithm in GPS Software Receivers

Suppressing jitter noises in a phase locked loop(PLL) is of great importance in order to keep precise and continuous track of global positioning system(GPS) signals characterized by low carrier-to-noise ratio(C/N0).This article proposes and analyzes an improved Kalman-filter-based PLL to process weak carrier signals in GPS software receivers.After reviewing the optimal-bandwidth-based traditional second-order PLL,a Kalman-filter-based estimation algorithm is implemented for the new PLL by decorrelating the model error noises and the measurement noises.Finally,the efficiency of this new Kalman-filter-based PLL is verified by experimental data.Compared to the traditional second-order PLL,this new PLL is in position to make correct estimation of the carrier phase differences and Doppler shifts with less overshoots and noise disturbances and keeps an effective check on the disturbances out of jitter noises in PLL.The results show that during processing normal signals,this improved PLL reduces the standard deviation from 0.010 69 cycle to 0.007 63 cycle,and for weak signal processing,the phase jitter range and the Doppler shifts can be controlled within ±17° and ±5Hz as against ±25° and ±15 Hz by the traditional PLL.     

Auroral Electrojet Event Associated With Magnetospheric Substorms

The auroral electrojet index is an important index in monitoring and predicting substorms. A substorms usually includes auroral breakup, auroral electrojet event marked by AE increase, energetic particle injection at geosynchronous orbit, mid-low latitude Pi2, etc. However the question whether an auroral electrojet event corresponds to a substorm remains unanswered. Using the auroral electrojet index in 2004, we analyzed five auroral electrojet events and studied their relation with substorms. The results show that there are three kinds of auroral electrojet events: (1) simultaneous rapid increase of westward auroral electrojet and eastward auroral electrojet; (2) rapid increase of westward auroral electrojet and almost unchangeable eastward auroral electrojet; (3) rapid increase of eastward auroral electrojet and almost unchangeable westward auroral electrojet. Most of auroral electrojet events correspond to substorms. However a few auroral electrojet events are not accompanied by substorms. This situation most often occurs for the auroral electrojet event in which eastward auroral electrojet dominates.      

国外空间对抗装备技术的发展途径与趋势

空间已成为事关国家安全和利益的战略“制高点”。主要航天国家围绕控制“制高点”,采取不同策略发展空间对抗能力。国外已具备有限的空间对抗实战能力,但是空间对抗装备在世界范围内总体上仍处于技术发展阶段。空间对抗装备技术将在与导弹攻防对抗、网络攻防对抗技术的交叉与叠加中演进升级。预计2030年前后,国外将形成一个比较全面、完整和成熟的空间对抗装备体系。     

月球着陆器着陆缓冲性能研究

首先基于MSC.Nastran/MSC.Adams软件建立了模拟月球着陆器的动力学模型,并利用模拟月球着陆器在地面冲击试验来验证仿真模型的正确性,重点关注缓冲机构与结构连接处的载荷,结构特征点的加速度响应,以及缓冲器的工作行程。然后利用模拟着陆器地面试验结果修正动力学分析模型,研究表明：着陆器结构和缓冲机构的柔性对缓冲性能具有较大的影响。最后,把动力学分析模型中的模拟结构更换成真实结构,进行着陆器在月球表面的着陆冲击仿真分析,从而获得模拟着陆器地面试验与着陆器在月面着陆的冲击缓冲性能差异。     

金属增材制造技术应用于军用飞机维修保障浅析

金属增材制造技术的发展为军用飞机维修保障提供了一条数字化、定制化、高性能、短周期的技术新途径,可提升军用飞机维修保障的技术水平和能力。本文综述了军用飞机维修保障的国内外现状,指出了金属增材制造技术的应用优势,介绍了军用飞机零件的典型损伤形式、不同增材制造工艺的适用性及修复工艺选取方案,分析了所涉及的逆向建模、结构优化、智能机器人等关键技术,详述了目前存在的技术成熟度与可靠性不高、修复原则不明确、标准规范不统一等主要问题及解决措施,指出了增材制造技术在军用飞机维修保障领域未来的发展方向和趋势,并给出了具体的应用建议。