Solar Irradiance Variability Since 1978

Since November 1978 a set of total solar irradiance (TSI) measurements from space is available, yielding a time series of more than 25 years. Presently, there are three TSI composites available, called PMOD, ACRIM and IRMB, which are all constructed from the same original data, but use different procedures to correct for sensitivity changes. The PMOD composite is the only one which also corrects the early HF data for degradation. The results from the detailed analysis of the VIRGO radiometry allow a good understanding of the effects influencing the long-term behaviour of classical radiometers in space. Thus, a re-analysis of the behaviour of HF/NIMBUS-7 and ACRIM-I/SMM was indicated. For the former the situation is complicated by the fact that there are no in-flight means to determine changes due to exposure to solar radiation by comparison with a less exposed radiometer on the same spacecraft. The geometry and optical property of the cavity of HF is, however, very similar to the PMO6-type radiometers, so the behaviour of the PMO6V radiometers on VIRGO can be used as a model. ACRIM-I had to be revised mainly due to a henceforth undetected early increase and a more detailed analysis of its degradation. The results are not only important for solar radiometry from space, but they also provide a more reliable TSI during cycle 21. The differences between the revised PMOD composite and the ACRIM and IRMB are discussed by comparison with a TSI reconstruction from Kitt-Peak magnetograms. As the PMOD composite is the only one which has reliable data for cycle 21, the behaviour of the three solar cycles can now be compared and the similarities and differences discussed.     

Coronal Observations of CMEs

CMEs have been observed for over 30 years with a wide variety of instruments. It is now possible to derive detailed and quantitative information on CME morphology, velocity, acceleration and mass. Flares associated with CMEs are observed in X-rays, and several different radio signatures are also seen. Optical and UV spectra of CMEs both on the disk and at the limb provide velocities along the line of sight and diagnostics for temperature, density and composition. From the vast quantity of data we attempt to synthesize the current state of knowledge of the properties of CMEs, along with some specific observed characteristics that illuminate the physical processes occurring during CME eruption. These include the common three-part structures of CMEs, which is generally attributed to compressed material at the leading edge, a low-density magnetic bubble and dense prominence gas. Signatures of shock waves are seen, but the location of these shocks relative to the other structures and the occurrence rate at the heights where Solar Energetic Particles are produced remains controversial. The relationships among CMEs, Moreton waves, EIT waves, and EUV dimming are also cloudy. The close connection between CMEs and flares suggests that magnetic reconnection plays an important role in CME eruption and evolution. We discuss the evidence for reconnection in current sheets from white-light, X-ray, radio and UV observations. Finally, we summarize the requirements for future instrumentation that might answer the outstanding questions and the opportunities that new space-based and ground-based observatories will provide in the future.     

Isotopic Signatures of Presolar Materials in Interplanetary Dust

Interplanetary dust particles collected in the stratosphere frequently exhibit enrichments in deuterium (D) and ¹⁵N relative to terrestrial materials. These effects are most likely due to the preservation of presolar interstellar materials. While the elevated D/H ratios probably resulted from mass fractionation during chemical reactions at very low < 100 K temperatures, the origin of the N isotopic anomalies remains unresolved. The bulk of the N-bearing material may have obtained its isotopic signatures from low temperature chemistry, but a nucleosynthetic origin is also possible. This revised version was published online in August 2006 with corrections to the Cover Date.     

Genesis on-board determination of the solar wind flow regime

Some of the objectives of the Genesis mission require the separate collection of solar wind originating in different types of solar sources. Measurements of the solar wind protons, alpha particles, and electrons are used on-board the spacecraft to determine whether the solar-wind source is most likely a coronal hole, interstream flow, or a coronal mass ejection. A simple fuzzy logic scheme operating on measurements of the proton temperature, the alpha-particle abundance, and the presence of bidirectional streaming of suprathermal electrons was developed for this purpose. Additional requirements on the algorithm include the ability to identify the passage of forward shocks, reasonable levels of hysteresis and persistence, and the ability to modify the algorithm by changes in stored constants rather than changes in the software. After a few minor adjustments, the algorithm performed well during the initial portion of the mission. This revised version was published online in August 2006 with corrections to the Cover Date.     

Far ultraviolet imaging from the IMAGE spacecraft. 3. Spectral imaging of Lyman-α and OI 135.6 nm

Two FUV Spectral imaging instruments, the Spectrographic Imager (SI) and the Geocorona Photometer (GEO) provide IMAGE with simultaneous global maps of the hydrogen (121.8 nm) and oxygen 135.6 nm components of the terrestrial aurora and with observations of the three dimensional distribution of neutral hydrogen in the magnetosphere (121.6 nm). The SI is a novel instrument type, in which spectral separation and imaging functions are independent of each other. In this instrument, two-dimensional images are produced on two detectors, and the images are spectrally filtered by a spectrograph part of the instrument. One of the two detectors images the Doppler-shifted Lyman- while rejecting the geocoronal `cold Ly-, and another detector images the OI 135.6 nm emission. The spectrograph is an all-reflective Wadsworth configuration in which a grill arrangement is used to block most of the cold, un-Doppler-shifted geocoronal emission at 121.567 nm. The SI calibration established that the upper limit of transmission at cold geocoronal Ly- is less than 2%. The measured light collecting efficiency was 0.01 and 0.008 cm² at 121.8 and at 135.6 nm, respectively. This is consistent with the size of the input aperture, the optical transmission, and the photocathode efficiency. The expected sensitivity is 1.8×10^–2 and 1.3×10^–2 counts per Rayleigh per pixel for each 5 s viewing exposure per satellite revolution (120 s). The measured spatial resolution is better than the 128×128 pixel matrix over the 15°×15° field of view in both wavelength channels. The SI detectors are photon counting devices using the cross delay line principle. In each detector a triple stack microchannel plate (MCP) amplifies the photo-electronic charge which is then deposited on a specially configured anode array. The position of the photon event is measured by digitizing the time delay between the pulses detected at each end of the anode structures. This scheme is intrinsically faster than systems that use charge division and it has a further advantage that it saturates more gradually at high count rates. The geocoronal Ly- is measured by a three-channel photometer system (GEO) which is a separate instrument. Each photometer has a built in MgF₂ lens to restrict the field of view to one degree and a ceramic electron multiplier with a KBr photocathode. One of the tubes is pointing radially outward perpendicular to the axis of satellite rotation. The optic of the other two subtend 60° with the rotation axis. These instruments take data continuously at 3 samples per second and rely on the combination of satellite rotation and orbital motion to scan the hydrogen cloud surrounding the earth. The detective efficiencies (effective quantum efficiency including windows) of the three tubes at Ly- are between 6 and 10%.     

The Extreme Ultraviolet Imager Investigation for the IMAGE Mission

The Extreme Ultraviolet Imager (EUV) of the IMAGE Mission will study the distribution of He⁺ in Earth's plasmasphere by detecting its resonantly-scattered emission at 30.4 nm. It will record the structure and dynamics of the cold plasma in Earth's plasmasphere on a global scale. The 30.4-nm feature is relatively easy to measure because it is the brightest ion emission from the plasmasphere, it is spectrally isolated, and the background at that wavelength is negligible. Measurements are easy to interpret because the plasmaspheric He⁺ emission is optically thin, so its brightness is directly proportional to the He⁺ column abundance. Effective imaging of the plasmaspheric He⁺ requires global `snapshots in which the high apogee and the wide field of view of EUV provide in a single exposure a map of the entire plasmasphere. EUV consists of three identical sensor heads, each having a field of view 30° in diameter. These sensors are tilted relative to one another to cover a fan-shaped field of 84°×30°, which is swept across the plasmasphere by the spin of the satellite. EUVs spatial resolution is 0.6° or 0.1 R _E in the equatorial plane seen from apogee. The sensitivity is 1.9 count s^–1 Rayleigh^–1, sufficient to map the position of the plasmapause with a time resolution of 10 min.     

Extraction of ion distributions from magnetospheric ENA and EUV images

Energetic neutral atom (ENA) and extreme ultra-violet photon (EUV) imagers will soon be probing magnetospheric ion distributions from the NASA space missions IMAGE and TWINS. Although ENA and EUV images will differ greatly, the same basic mathematical approach can be applied to deducing the ion distributions: extracting the parameters of a model ion distribution in a model magnetic field (and, in the case of ENA, interacting with a model cold neutral population). The model ion distribution is highly non-linear in its many parameters (as many as 38 have been used) in order to describe the strong spatial gradients of ion intensities in the magnetosphere. We have developed several new computer algorithms to accomplish the extraction by minimizing the differences between a simulated (instrument-specific) image and an observed image (or set of images). Towards the goal of a truly automated `hands-off extraction algorithm, we have combined three algorithms into a Hierarchical Simplex Algorithm. At each step of the minimization, it first tries a sophisticated and efficient Adaptive Conjugate Gradient algorithm. Then, if the error function is not reduced, it defers to an intermediate Analytic Simplex algorithm, and (if this step also fails) it finally defaults to the robust but inefficient Downhill Simplex algorithm. Whenever a step is successful, the algorithm begins the next step at the top of the hierarchy. We also offer a completely different approach (without minimization) for the interpretation of sharp `edges in the images (e.g., the plasmapause in He ⁺ 30.4 nm EUV images of the plasmasphere). We demonstrate mathematically that the equatorial shape of the plasmapause can be constructed directly from the image using a simple graphical algorithm.     

C/SiC复合材料超声振动钻孔评估

在分析碳纤维增强碳化硅复合材料的力学性能、密度、孔隙率和弯曲强度的基础上 ,进行了超声钻孔工艺试验 ,检测并研究了材料去除率、孔径差、孔边质量和工具损耗情况 ,得出了超声钻孔是一种好的加工方法的结论。     

Tracking multiple objects with particle filtering

We address the problem of multitarget tracking (MTT) encountered in many situations in signal or image processing. We consider stochastic dynamic systems detected by observation processes. The difficulty lies in the fact that the estimation of the states requires the assignment of the observations to the multiple targets. We propose an extension of the classical particle filter where the stochastic vector of assignment is estimated by a Gibbs sampler. This algorithm is used to estimate the trajectories of multiple targets from their noisy bearings, thus showing its ability to solve the data association problem. Moreover this algorithm is easily extended to multireceiver observations where the receivers can produce measurements of various nature with different frequencies.