Features of whistling electromagnetic wave propagation descending from above upon the night ionosphere

The results of numerical solution of the wave equations for the oblique incidence of whistling electromagnetic waves upon the night ionosphere from above have been obtained and analyzed. In the studied region of altitudes, within the wavelength scale, charged particle concentration varies drastically, and damping caused by collisions between the charged and neutral particles decreases considerably. Below, the sharp lower boundary of the ionosphere, the refractive index of the whistler wave approaches unity, and plasma turbulence transform into atmospheric electromagnetic waves. The dependences of the whistler reflection factor are found in terms of energy and horizontal magnetic component of the electromagnetic wave near the Earth’s surface on the frequency and the wave vector transverse component for the plain-layered medium model at two values of latitude. Strong dependences have been found on the wave angle of incidence and frequency. At rather small angles of incidence, the wave disturbances reach the Earth’s surface, and the module of reflection coefficient logarithm is in the range of 0.4–1. At large angles of incidence, the reflection coefficient module varies over a wide range depending on specific conditions. The obtained results explain the absence of oscillation modes of plasma magnetosphere maser in the night magnetosphere.     

Thymine photoproduct formation and inactivation of intact spores of Bacillus subtilis irradiated with short wavelength UV (200-300nm) at atmospheric pressure and in vacuo.

Vacuum exposure renders the survival of spores of Bacillus subtilis approximately five times more sensitive to ultraviolet light irradiation than exposure under atmospheric conditions. The photoproduct formation in spores irradiated under ultrahigh vacuum (UHV) conditions is compared to the photoproduct formation in spores irradiated at atmospheric pressure. Compared to irradiation at atmospheric pressure, where only the "spore photoproduct" 5-thyminyl-5,6-dihydrothymine (TDHT) can be detected, two additional photoproducts, known as the c,s and t,s isomers of thymine dimer (T<>T) are produced in vacuo. The spectral efficiencies for photoproduct formation in spores under atmospheric and vacuum conditions are compared. Since there is no increased formation of TDHT after irradiation in vacuum, TDHT cannot be made responsible for the observed vacuum effect. "Vacuum specific" photoproducts may cause a synergistic response of spores to the simultaneous action of ultraviolet light (UV) and UHV. Three different mechanisms are discussed for the enhanced sensitivity of B. subtilis spores to UV radiation in vacuum. The experiments described contribute valuable research information on the chance for survival of microorganisms in outer space.     

Diurnal and seasonal variations of F2 layer characteristics over Irkutsk during the decrease in solar activity in 2003–2006: Observations and IRI-2001 model predictions

The diurnal and seasonal variations of F2 layer characteristics (critical frequency, peak height and bottomside thickness) over Irkutsk, Russia (52.3 N and 104.3 E) are studied by the method of running medians. The comparison with the IRI-2001 model during the decrease in solar activity in 2003–2006 revealed cases of both close agreement and systematic differences between predictions and observations. The systematic difference is not the only reason for disagreement between IRI and observations; there are also intrayear variations which are not associated with seasonal behavior. The period of observation was too short to make conclusions about solar activity dependence of the noon bottomside thickness and the modification of its diurnal behavior with decreasing solar activity.     

Discrete-time observability and estimability analysis for bearings-only target motion analysis

Observability in the context of bearings-only tracking (BOT) is still the subject of important literature. Different from previous approaches, where continuous-time analysis was considered, our approach relies on discrete-time analysis. It is then shown that this allows us to use directly and efficiently the simple formalisms of linear algebra. Using the direct approach, observability analysis is essentially reduced to basic considerations about subspace dimensions. Even if this approach is conceptually quite direct, it becomes more and more complex as the source-encounter scenario complexity increases. For complex scenarios, the dual approach may present some advantages essentially due to the direct use of multilinear algebra. New results about BOT observability for maneuvering sources are thus obtained. Observability analysis is then extended to unknown instants of source velocity changes. Even if observability analysis provides thorough insights about the algebraic structure of the BOT problem, the optimization of the observer maneuvers is essentially a control problem. Basic algebraic considerations prove that a relevant cost functional for this control problem is the determinant of the Fisher information matrix (FIM). So, a large part of this work is devoted to the analysis of this cost functional. Using multilinear algebra, general approximations of this functional are given. In order to involve only directly estimable parameters, the source bearing-rates are examined. Using these approximations, a general framework for optimizing the observer trajectory is derived which allow us to approximate the optimal sequence of controls. It is worth stressing that our approach does not require the knowledge of the source trajectory parameters and is still valid for a maneuvering source.     

On Increasing Usable MTI Filter Bandwidth by Removing Linear-Phase Constraint

It has been shown in the literature that the linear-phase constraint of finite-duration impulse-response (FIR) digital filters can, under certain circumstances, be effectively traded either for a better filter amplitude response or a reduction in the number of filter coeficients. It is shown that such a tradeoff can be exploited for moving target indicator (MTI) radar signal processors to increase the usable bandwidth for target detection. Although it is demonstrated that the increase is significant for narrowband (ground) clutter, it is negligible for wideband (weather) clutter.     

Huygens Probe Aerosol Collector Pyrolyser Experiment

ACP's main objective is the chemical analysis of the aerosols in Titan's atmosphere. For this purpose, it will sample the aerosols during descent and prepare the collected matter (by evaporation, pyrolysis and gas products transfer) for analysis by the Huygens Gas Chromatograph Mass Spectrometer (GCMS). A sampling system is required for sampling the aerosols in the 135'32 km and 22'17 km altitude regions of Titan's atmosphere. A pump unit is used to force the gas flow through a filter. In its sampling position, the filter front face extends a few mm beyond the inlet tube. The oven is a pyrolysis furnace where a heating element can heat the filter and hence the sampled aerosols to 250 °C or 600 °C. The oven contains the filter, which has a thimble-like shape (height 28 mm). For transferring effluent gas and pyrolysis products to GCMS, the carrier gas is a labeled nitrogen ¹⁵N₂, to avoid unwanted secondary reactions with Titan's atmospheric nitrogen. Aeraulic tests under cold temperature conditions were conducted by using a cold gas test system developed by ONERA. The objective of the test was to demonstrate the functional ability of the instrument during the descent of the probe and to understand its thermal behavior, that is to test the performance of all its components, pump unit and mechanisms. In order to validate ACP's scientific performance, pyrolysis tests were conducted at LISA on solid phase material synthesized from experimental simulation. The chromatogram obtained by GCMS analysis shows many organic compounds. Some GC peaks appear clearly from the total mass spectra, with specific ions well identified thanks to the very high sensitivity of the mass spectrometer. The program selected for calibrating the flight model is directly linked to the GCMS calibration plan. In order not to pollute the two flight models with products of solid samples such as tholins, we excluded any direct pyrolysis tests through the ACP oven during the first phase of the calibration. Post probe descent simulation of flight results are planned, using the much representative GCMS and ACP spare models. This revised version was published online in August 2006 with corrections to the Cover Date.     

A Hybrid Navigation Concept Using a Spinning Satellite?Borne Interferometer and Self?Contained Equipment

This paper analyzes a hybrid navigation concept that uses signals from a radio interferometer mounted on a spinning geostationary satellite, preliminary position estimates from self-contained equipment, and stored a priori information on the past performance of this equipment. The craft-borne processor, optimum in the maximum a posteriori (MAP) sense, is designed to estimate position coordinates using only the incoming radio signals, although improved estimates result if the other two items are available. An error analysis starts with the derivation of an estimation error covariance matrix, whose elements depend on additive receiver noise and the physical parameters of the system. A minimum 1? estimation error in position is obtained by trading off these parameters. The effects of other major error sources, such as tropospheric phase fluctuations, multipath, and craft altitude uncertainty, are added to the estimation error to give a total 1? position error on the order of 3.7 to 5.6 km.     

A SAR processor based on two-dimensional FFT codes

A synthetic aperture radar (SAR) processor approach based on two-dimensional fast Fourier transform (FFT) codes coupled with an asymptotic evaluation of the unit response function is presented. For the latter, no approximation is made to the distance function, so that the full range of geometric aberrations is analytically considered, enabling an effective reference filter to be designed. The two-dimensional FFTs were designed as to run on computers of very limited memory: the required FFT is computed by means of FFTs of lower order. Two FFT codes were considered: one is faster and allows full or reduced (quick look or multilook) resolution performance to be obtained easily; the second is slower but allows the use of a space-varying filter and/or investigations on limited portions (zoom) of the image. Both codes are suited to parallel processing, e.g. by a transputer net. A full discussion on computer memory and time requirements is presented as well as first examples of image processing results     

Approximate Evaluation of Detection Probabilities in Radar and Optical Communications

Cumulative probability distributions such as occur in radar detection problems are approximated by a new version of the saddlepoint method of evaluating the inverse Laplace transform of the moment-generating function. When the number of radar pulses integrated is large, the approximation of lowest order yields good accuracy in the tails of the distributions, yet requires much less computation than standard recursive methods. Greater accuracy can be achieved upon summing the residual series by converting it to a continued fraction. The method is applied to evaluating the error-function integral and the Mth-order Q function, and to approximating the inverse of the chi-squared distribution. Cumulative distributions of discrete random variables, needed for determining error probabilities in optical communication receivers that involve counting photoelectrons, can be approximated by a simple modification of the method, which is here applied to the Laguerre distribution.