Implications of an Engineering Manpower Shortage

Many competent sources have been predicting an increasing shortage of graduate engineers to perform needed research and development work in the United States. Consequently, many industrialists, educators, and government officials have been advocating an increased enrollment of students in the engineering curriculum in college in a greater effort to produce more engineers. This paper examines the assumptions behind the projected manpower shortage, and proposes some rather unique and occasionally radical alternatives to the solution of a manpower deficit. The paper, and the solutions, may produce violent controversy, but at least the material is not the usual dull rehash so often seen of late.     

Thrust modulation of solid propellant rockets by a fluidic vortex valve with secondary combustion

An analytical model for calculation of the thrust and pressure modulation of a solid propellant rocket by means of a fluidic vortex valve with secondary combustion has been developed. Thrust control by the vortex valve method was found superior to the axial injection of control flow. Addition of oxygen in the injected flow improves the energetic performance of the system as well as the thrust modulation capability. Experiments have been conducted using a mixture of nitrogen and oxygen as the injection gas. The two main parameters investigated in a series of experiments were the oxygen percentage in the injection gas and the ratio between the mass flow rates of the control gas and the solid propellant combustion products. The results show an increase of thrust by a factor of 2 for a 25% addition in mass flow rate by secondary injection at optimal conditions.     

PWM full-bridge converter with natural input power factor correction

A pulsewidth modulated (PWM) full-bridge converter that simultaneously performs input power factor correction (PFC) and DC-DC conversion is proposed. The converter is the same as the standard voltage-fed PWM full-bridge converter with a diode-bridge low-pass filter front end, but with a slight modification that results in an improvement in power factor that is sufficient to satisfy the EN61000-3-2 requirements for electrical equipment. The operation of the converter is explained and analyzed, and the results of the analysis are used to determine the converter's steady-state characteristics, which are discussed in detail. A design procedure for the selection of components is then derived and demonstrated with an example. The feasibility of the converter and its ability to satisfy EN61000-3-2 requirements on electrical equipment is shown with results obtained from an experimental prototype.     

Coronal Observations of CMEs

CMEs have been observed for over 30 years with a wide variety of instruments. It is now possible to derive detailed and quantitative information on CME morphology, velocity, acceleration and mass. Flares associated with CMEs are observed in X-rays, and several different radio signatures are also seen. Optical and UV spectra of CMEs both on the disk and at the limb provide velocities along the line of sight and diagnostics for temperature, density and composition. From the vast quantity of data we attempt to synthesize the current state of knowledge of the properties of CMEs, along with some specific observed characteristics that illuminate the physical processes occurring during CME eruption. These include the common three-part structures of CMEs, which is generally attributed to compressed material at the leading edge, a low-density magnetic bubble and dense prominence gas. Signatures of shock waves are seen, but the location of these shocks relative to the other structures and the occurrence rate at the heights where Solar Energetic Particles are produced remains controversial. The relationships among CMEs, Moreton waves, EIT waves, and EUV dimming are also cloudy. The close connection between CMEs and flares suggests that magnetic reconnection plays an important role in CME eruption and evolution. We discuss the evidence for reconnection in current sheets from white-light, X-ray, radio and UV observations. Finally, we summarize the requirements for future instrumentation that might answer the outstanding questions and the opportunities that new space-based and ground-based observatories will provide in the future.     

Formation of amino acid precursors in cometary ice environments by cosmic radiation.

Cometary ices are believed to contain water, carbon monoxide, methane and ammonia, and are possible sites for the formation and preservation of organic compounds relating to the origin of life. Cosmic rays, together with ultraviolet light, are among the most effective energy sources for the formation of organic compounds in space. In order to study the possibility of the formation of amino acids in comets or their precursory bodies (interstellar dust grains), several types of ice mixtures made in a cryostat at 10 K ("simulated cometary ices") were irradiated with high energy protons. After irradiation, the volatile products were analyzed with a quadrupole mass spectrometer, while temperature of the cryostat was raised to room temperature. The non-volatile products remaining in the cryostat at room temperature were collected with water. They were acid-hydrolyzed, and analyzed by ion-exchange chromatography. When an ice mixture of carbon monoxide (or methane), ammonia and water was irradiated, some hydrocarbons were formed, and amino acids such as glycine and alanine were detected in the hydrolyzate. These results suggest the possible formation of "amino acid precursors" (compounds yielding amino acids after hydrolysis) in interstellar dust grains by cosmic radiation. We previously reported that amino acid precursors were formed when simulated primitive planetary atmospheres were irradiated with cosmic ray particles. It will be of great interest to compare the amount of bioorganic compounds that were formed in the primitive earth and that brought by comets to the earth.     

Transient fast reconnection in dynamic current sheets with anomalous resistivity

Two-dimensional compressible magnetohydrodynamic simulations of current sheet dynamics under the influence of multiple anomalous resistivity areas and slight asymmetries are presented. Following induced tearing and multiple coalescence, a plasmoid is formed and accelerated. Dominant X-points drive the dynamical evolution and lead to transient occurrence of a Petschek-like reconnection geometry. The dependence of current density extrema, plasmoid bulk velocity and maximum reconnection rate on the Lundquist number is examined.     

Missile Electronic System Hardness Assurance Program

A hardness assurance program suitable for a retaliatory or deterrent missile system is discussed. The program consists of three phases: the establishment of suitable controls and screens to ensure piece part hardness, a supplier data monitoring program to measure hardness related parameters in a timely fashion to obtain advanced warning of potential problems, and a hardness assurance verification testing (HAVT) program to periodically measure the radiation response of parts, circuits, subsystems, and systems on a sample basis to ensure proper functioning in simulated radiation environments. All of the data relevant to hardness assurance is stored in computer memory and routinely interrogated with programs which compare current results with the engineering baseline data and other data from preceding lots. Other computer programs enable statistical estimation of system response to the radiation environment with confidence based on the expanding data base provided by the HAVT program.     

LMC X-4, AO538-66 and surrounding X-ray sources observed with EXOSAT

Repeated observations of LMC X-4 with EXOSAT were carried out in 1983/84 in order to study its 30.5 day cycle and to cover the expected outbursts of the recurrent LMC transient A0538-66. The latter source was inactive during our campaign although a variable circumstellar envelope was still present around the optical counterpart.At least ten further X-ray sources are detected in the CMA field of view around LMC X-4 including the SNR N49 which is the possible site for the March 5, 1979 -ray burster and N63A which appears to be variable in X-ray luminosity. We furthermore discuss the strongest sources that were not present in a previous EINSTEIN survey of the LMC.     

Relationship between the fluxes of relativistic electrons at geosynchronous orbit and the level of ULF activity on the Earth’s surface and in the solar wind during the 23rd solar activity cycle

We present the results of a cross-correlation analysis made on the basis of Spearman’s rank correlation method. The quantities to correlate are daily values of the fluence of energetic electrons at a geosynchronous orbit, intensities of ground and interplanetary ultra-low-frequency (ULF) oscillations in the Pc5 range, and parameters of the solar wind. The period under analysis is the 23rd cycle of solar activity, 1996–2006. Daily (from 6 h to 18 h of LT) magnetic data at two diametrically opposite observatories of the Intermagnet network are taken as ground-based measurements. The fluxes of electrons with energies higher than 2 MeV were measured by the geosynchronous GOES satellites. The data of magnetometers and plasma instruments installed on ACE and WIND spacecraft were used for analysis of the solar wind parameters and of the oscillations of the interplanetary magnetic field (IMF). Some results elucidating the role played by interplanetary ULF waves in the processes of generation of magneospheric oscillations and acceleration of energetic electrons are obtained. Among them are (i) high and stable correlation of ground ULF oscillations with waves in the solar wind; (ii) closer link of mean daily amplitudes of both interplanetary and ground oscillations with ‘tomorrow’ values of the solar wind velocity than with current values; and (iii) correlation of the intensity of ULF waves in the solar wind, normalized to the IMF magnitude, with fluxes of relativistic electrons in the magnetosphere.     

Energetic Particles Investigation (EPI)

The Energetic Particles Investigation (EPI) instrument operates during the pre-entry phase of the Galileo Probe. The major science objective is to study the energetic particle population in the innermost regions of the Jovian magnetosphere — within 4 radii of the cloud tops — and into the upper atmosphere. To achieve these objectives the EPI instrument will make omnidirectional measurements of four different particle species — electrons, protons, alpha-particles, and heavy ions (Z > 2). Intensity profiles with a spatial resolution of about 0.02 Jupiter radii will be recorded. Three different energy range channels are allocated to both electrons and protons to provide a rough estimate of the spectral index of the energy spectra. In addition to the omnidirectional measurements, sectored data will be obtained for certain energy range electrons, protons, and alpha-particles to determine directional anisotropies and particle pitch angle distributions. The detector assembly is a two-element telescope using totally depleted, circular silicon surfacebarrier detectors surrounded by a cylindrical tungsten shielding with a wall thickness of 4.86 g cm^-2. The telescope axis is oriented normal to the spherical surface of the Probe's rear heat shield which is needed for heat protection of the scientific payload during the Probe's entry into the Jovian atmosphere. The material thickness of the heat shield determines the lower energy threshold of the particle species investigated during the Probe's pre-entry phase. The EPI instrument is combined with the Lightning and Radio Emission Detector (LRD) such that the EPI sensor is connected to the LRD/EPI electronic box. In this way, both instruments together only have one interface of the Probe's power, command, and data unit.